1. A9 solar camera can only be set up with 2.4g Wi-Fi network. (It's
ok to use Cell phone 4G data to live viewing it after the camera
was set up with 2.4g Wi-Fi network firstly.)
2. When the battery runs out, the camera can only turn on
automatically after the camera is charged more than 4 hours.
3. You may possibly need a Wi-Fi extender if your Wi-Fi signal is
weak around the yard where you want to install it.
4. At least 1-3 hours direct sunlight to the camera every day is
needed, the more sunshine the better to avoid manually charge
it frequently. (North side of the house is not a recommended
installation place)
5. Please format the micro SD card to FAT32 format and install the
card when camera powered off.(Micro SD card is not included
in the package)
6. Please charge your A9 camera before you set it up, it
usually takes up to 10-12 hours to fully charge it.Do not use any
power adaptor exceed 5V/2A,or it may damage the camera.
(There's no indicator to show charging status from the camera)
7. Make sure the distance between your phone,router and the
camera is no more than 1.5 feet when you're ready to pair the
camera. Ensure that the Wi-fi signal strength on your phone is
good.
8. The PIR range is 16 feet around,the recommend camera install
height is 8 feet around.To avoid too much false alarms, we
suggest you do not install the camera with nearby bushes,shrubs,
grasses and tree leaves coming into the PIR range.
9. To ensure an accurate motion detection function,it is suggested
to adjust the camera angle physically to focus the motion area
within the PIR suggested 16ft range.
10. If you install the camera on stucco,brick or concrete surface,
please mark 4 holes matching the bracket and then use a drill
driver to drill into the wall and insert the expansion screws to
hold the camera tightly
Warm tips before you go:
