G-project G-BUZZ User manual

PORTABLE ALARM CLOCK
G-BUZZG-BUZZ
G-1CR
FM Radio
Wake-up Sounds
USB Phone Charger
Dual Alarm

PACKAGE CONTENTS:
• G-BUZZ Portable Alarm Clock
• AC Power Adapter
• User Guide
Welcome
Alarm clocks can be boring. Get ready to shake things up with your
new G-BUZZ. Slap the snooze for more ZZZ’s or shake to stop the
alarm. Try out the custom sounds we made to put you to sleep and
wake you up. Pick your favorite to start the day, because you can't
get out and play unless you get out of bed first.
If you need a hand using your new G-BUZZ, we’re here to help.
Email us at [e-mail] or give us a call at
1-855-896-1795 between 6AM - 6PM PST.

PORTABLE ALARM CLOCK
G-BUZZG-BUZZ
STOP BY AND SAY HELLO TO US:
A NEW SONG EVERYDAY:
facebook.com/gprojectgear
twitter.com/gprojectgear
instagram.com/gprojectgear
We’ve got a new song for you everyday and
a collection of playlists to get you going.
Have a listen at songs.gprojectgear.com

1. SNOOZE Indicator
2. ALARM 2 Indicator
3. ALARM 1 Indicator
4. ‘PM’ Indicator
5. LED Display
6. ‘FM’ Indicator
7. Low Battery Indicator
8. SOUND Indicator
9. Speaker
1 7 82 3 4 5 6
9

PORTABLE ALARM CLOCK
G-BUZZG-BUZZ
20
10. POWER Button
11. REVERSE Button
12. FORWARD Button
13. ALARM 1 Switch
14. TIME Button
15. SET Button
16. ALARM 2 Switch
17. VOLUME – Button
18. VOLUME + Button
19. Sleep Sounds Button
20. SNOOZE / SLEEP
1210 11 13 14 15 16 17 18 19

21 22
24 25
23
21. Line In Jack
22. USB Charging Port
23. DC In Jack
24. Battery Compartment
25. FM Antenna Wire

PORTABLE ALARM CLOCK
G-BUZZG-BUZZ
WAKE-UP SOUNDS
SLEEP SOUNDS
Choose from a set of four custom alarm sounds get you out of bed.
Relax to four different soothing sounds while you drift off to sleep.
Rooster Bells Foghorn Drum
Ocean
Waves
OwlWhite
Noise
Crickets

AC POWER SOURCE
Connect the supplied AC adaptor (DC 5V 1.8A)
to the DC In jack on the back of G-BUZZ and
plug the other end into a standard wall outlet
(100~240V 50-60Hz).
NOTES: Disconnect both ends of the power cord
when not in use. Use only the supplied AC adaptor
with the following specs: AC In - 100-240V AC, 50/
60Hz / DC Out - 5V 1.8A.
INSTALLING THE BATTERIES
G-BUZZ can also be powered by four “AAA” batteries.
• Open the battery door on the back of your G-BUZZ.
• Insert four “AAA” batteries into the battery compartment,
being careful to observe proper polarity.
• Replace the battery door and snap closed.
AC outlet
AC adapter’s plug

PORTABLE ALARM CLOCK
G-BUZZG-BUZZ
USB CHARGING PORT
G-BUZZ includes a USB port located on the back of the unit. This USB port
supports powering and supports charging mobile phones and other
compatible USB powered accessories when G-BUZZ is plugged with the
included AC adaptor. (USB cable sold separately).
POWER SAVE MODE
When in battery mode, G-BUZZ will automatically power down in 3 minutes
after pressing the POWER button. This is designed to extend the life of the
batteries while traveling or when an AC power source is not available.
• To exit Power Save Mode, press any button while the LED display is
illuminated and G-BUZZ will return to normal operation.
• With Power Save Mode On, the LED display only illuminates the current
time and will automatically power down after 3 minutes. Pressing the
POWER button once while in Power Save Mode will wake the G-BUZZ
and display the current time.
• With Power Save Mode Off, the LED display is illuminated at all times.

INITIAL CLOCK SETUP
1Using the supplied AC power adapter, plug G-BUZZ into an AC power source
or install four “AAA” batteries.
2With G-BUZZ in STANDBY mode, the LED display will begin flashing the default
time of “12:00”.
3Press the << button repeatedly to select the current hour and press the
>> button repeatedly to select the current minute.
4Press the TIME button to save the new clock setting.
RESETTING THE TIME
1Make sure G-BUZZ is powered off, in STANDBY mode.
2Press and hold the TIME button until the display begins to flash.
3Press the << button repeatedly to select the current hour, then press the
>> button repeatedly to select the current minute.
4Press the TIME button again to save the new clock setting.

PORTABLE ALARM CLOCK
G-BUZZG-BUZZ
AUX-IN CONNECTION
1Insert one end of a 3.5mm audio cable (not included) into the LINE OUT jack
on your external audio source (e.g. iPad, iPod, mobile phone, MP3 player,
digital media player, etc.), then insert the other end into the LINE IN jack on
rear of G-BUZZ.
2Power on G-BUZZ, then power on the external audio source. The display will
show “AUX” briefly then change to the current clock time.
3Select the music you want to listen to and press play on the external audio
source. Playback will begin and sound will be heard through G-BUZZ.
ADJUSTING THE BRIGHTNESS
There are three levels of display brightness available
(the default setting is High).
1To change the brightness setting, make sure G-BUZZ is powered off.
2Press the +or –button repeatedly to cycle though and select the
desired brightness level.

PLAYING THE RADIO
Pressing the POWER button will turn on G-BUZZ and enter RADIO mode.
Choose from the three tuning modes available for selecting radio stations.
1PRESET Mode – Press the SET button repeatedly to select the desired
preprogrammed station numbered P01 – P10 ( See “SETTING RADIO
PRESETS” to program your favorite stations).
2SCANNING Mode – Press and hold the << or >> button to scan through
the stations; scanning starts from the current station and stops at the next
strongest station received.
3MANUAL Mode – Repeatedly press the << or >> button to manually
tune into a specific station.
NOTE: Unravel and extend the FM wire antenna to receive the best FM reception.

PORTABLE ALARM CLOCK
G-BUZZG-BUZZ
SETTING RADIO PRESETS
1With G-BUZZ in RADIO mode, tune to a favorite station to save.
2Press and hold the SET button to create a preset for the current station.
“P” will appear and the preset number “##” will blink on the display
3Press the << or >> button to select a specific preset number (01-10).
Press the SET button again to confirm the setting and the station will be
saved into memory.
4Repeat these steps to program up to 10 different presets stations.
RECALLING RADIO PRESETS
With G-BUZZ in RADIO mode, repeatedly press the SET button until
the desired preset number appears in the display and G-BUZZ tunes
to the station.

SETTING THE ALARM
Alarms can be set with G-BUZZ is powered ON or in STANDBY mode.
1Slide the ALARM 1 or ALARM 2 switch to “SET”. The alarm time will begin to
blink on the display.
2Setting Alarm Time – Press the << button repeatedly to select the alarm
hour, then press the >> button repeatedly to select the alarm minute.
Press the “SET” button to confirm alarm time and enter alarm source mode.
3Setting Alarm Source – There are six options for each alarm (FM Radio,
buzzer and four unique sounds; Rooster, Bells, Foghorn or Drum).
The default alarm source is FM Radio and uses the current station G-BUZZ
is tuned to. Press the << or >> button repeatedly to select a different alarm
source. Press the “SET” button to confirm alarm source.
4Setting Alarm Volume – After confirming the alarm source, the display will
blink the default alarm volume level. Press +or –button repeatedly to
adjust and select the desired alarm volume.
5Saving Alarm Setting – Slide the ALARM 1 or ALARM 2 switch to “ON” to
save these alarm settings. The LED alarm indicator will appear on the display.
NOTE: The FM station can not be selected in alarm source mode and must be tuned
prior to setting an alarm.

PORTABLE ALARM CLOCK
G-BUZZG-BUZZ
TURNING OFF THE ALARM
When the alarm sounds there are two ways to turn off the alarm.
1Shake Mode – When the alarm sounds, shake G-BUZZ to turn off the
alarm. The alarm will automatically sound again the same time tomorrow.
2Manual Mode – When the alarm sounds, slide the alarm switch to “OFF”
to silence it. To reset the alarm to sound the next day, you must slide
the alarm switch to “ON” again.
NOTE: G-BUZZ will sound for a maximum of 60 minutes if not turned off. The alarm will
then stop and automatically sound again at the same time tomorrow.
SNOOZE
1When the alarm sounds, press the SNOOZE / SLEEP button to delay the
alarm from sounding again for 10 minutes.
2You can increase the delay by an additional 10 minutes each time you press
the SNOOZE / SLEEP button. The display will show the snooze duration for
about 3 seconds then return to display the current time.
3The maximum duration is 60 minutes and increases as follows:
10 > 20 > 30 > 40 > 50 > 60
NOTE: Press the SNOOZE / SLEEP button to display the remaining delay time.

SLEEP
Choose from four unique sounds; Ocean Waves, White Noise, Owl or Crickets
1With G-BUZZ powered on, press SLEEP SOUND button to select a sleep sound
for playback.
2Press the << or >> button repeatedly to cycle through and select a playback
sound.
3If you want to set the sleep timer duration, you can increase the duration each
time you press the SNOOZE / SLEEP button while sleep sound playback
4The maximum duration is 90 minutes and increases as follows:
15 > 30 > 60 > 90 > OFF
5If you do not set the sleep timer duration, G-BUZZ will continue to play the
sleep sound until you stop it.
6To stop playback, press the SLEEP SOUND button again or shack G-BUZZ to
turn off it.

PORTABLE ALARM CLOCK
G-BUZZG-BUZZ
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
NOTE: Any unapproved changes or modifications will void the warranty.
IMPORTANT SAFETY NOTIFICATIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol,
within an equilateral triangle is intended to alert the user to the presence
of uninsulated dangerous voltage within the product’s enclosure that may
be of sufficient magnitude to constitute a risk of electric shock to persons.
ATTENTION: The exclamation point within an equilateral triangle is intended
to alert the user to the presence of important operating and maintenance
(servicing) instructions in the literature accompanying the appliance.

FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to
this equipment may cause harmful interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this equipment if an unauthorized change
or modification is made.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Compliance information: This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
SURGE PROTECTORS: It is recommended to use a surge protector for AC connection. Lightning and power
surges ARE NOT covered under warranty for this product.
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.

a. Do not expose this unit or the AC/DC adaptor to dripping or splashing water.
Keep liquid-filled objects, such as vases, away from this unit and AC/DC adaptor.
b. Only use attachments / accessories specified by the manufacturer.
c. Ensure that the AC/DC adaptor is easily accessible.
d. Please note the information printed underneath the unit.
e. Do not impede the ventilation of this unit by covering the ventilation openings with
items such as newspapers, table-cloths, curtains, etc.
f. Keep open flames, such as lighted candles, away from this unit.
g. Do not place this unit in closed bookcases, racks, or other spaces without
proper ventilation.
h. Unplug this unit during lightning storms or when unused for long periods of time.
i. This unit contains a built-in rechargeable battery. Disposal of these materials may
be regulated due to environmental considerations. For disposal or recycling
information, please contact your local authorities.
j. Do not expose the battery to flames or dispose of it in a fire.
SAFETY PRECAUTIONS
PORTABLE ALARM CLOCK
G-BUZZG-BUZZ

G-Project is a registered trademark of Goodhatch, LLC
G-BUZZ is distributed by Life Lab International LTD.