Gainsborough Solar 3 Tier Bronze Water Feature User manual

Solar 3 Tier Bronze Water Feature
K202 v001: 13/08/21
Please read and retain these instructions for future reference
ALWAYS POSITION IN DIRECT SUNLIGHT
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
Parts
Dimensions
(H) 89 x (W) 51 x (D) 51cm
Length of lead: 3m
Size of solar panel: 20 x 17cm
•MONOCRYSTALLINE SILICON SOLAR PANEL 12V/4W
•WATERPUMP 9V –170MA
•Power: 120V a.c.
•Water capacity: 3.78L
Battery: 1 x 7.4V 600mAh (not replaceable)

Solar 3 Tier Bronze Water Feature K202 Instructions for Use
Please read and retain these instructions for future reference v001: 13/08/21
Before using first time
Allow panel to charge for at least 8 hours in full sunlight.
Find an ideal Place for the Solar Light.
Place the solar panel in an area where it will receive direct sunlight for at least 8 hours per day. The number
of hours the pump will work is directly proportional to the hours of sunlight it receives. If the panel is placed
in a shaded area, it will not be able to fully charge and its pumping time will be limited.
Assembly
1. Place the fountain
base on a smooth level
surface. Attach the post
connector to the
fountain base. Screw the
post into the post
connector by twisting it
clockwise with the
threads. Ensure that both
the post and the post
connector are snug.
2. Fit the pump (attached
to the fountain basin)
into the pump housing
on the side with the gap.
(Note: The pump cord
fits into the gap).
3. Insert the pump housing pipe into the hole on top of
the pump. Rotate the nut and washer on the pipe until
they are tight at the top of the pump housing. Ensure that
the rectangular guide is flush with the raised areas. The
bottom of the pump should be flat against the base of the
pump housing.

Solar 3 Tier Bronze Water Feature K202 Instructions for Use
Please read and retain these instructions for future reference v001: 13/08/21
7. Fill The fountain basin with 1 gallon of water, being careful not to overflow and cause splashing. Make
sure the water completely submerges the pump.
4. Locate the pump power cable and
feed it through the top of the post.
Pull the pump power cable out of the
hole under the fountain base then
connect the solar panel.
5. Attach the fountain basin by
twisting it onto the post. Ensure it is
level before proceeding. Place the
washers on the holes of the fountain
basin. Run the cord through the gap of
the pump housing. Align the holes of
the pump housing and the holes of the
fountain basin and washers and
tighten the screws.
6. Place the pump cover around the pump housing. Place the lower tier on
the pump housing pipe and press down until it fits into the top of the pump
cover hole. Place the dish cover on the pump housing pipe followed by the
upper tier followed by screwing on the top piece.

Solar 3 Tier Bronze Water Feature K202 Instructions for Use
Please read and retain these instructions for future reference v001: 13/08/21
It is recommended you use distilled water to prevent scale build-up. The first time you operate the pump
it can take up to 5 minutes for the air to be completely expelled and water begins to flow properly.
8. Plug the pump power cable into your power supply and water will start flowing.
Care and Maintenance Recommendations
1. Clean solar panel with a soft sponge every couple of weeks.
2. Make sure all connectors are still tight and no water getting in.
3. Keep the water clean during the summer keep topping up every 3 or 4 days with clean water.
4. Clean any pipes every month stop any build-up of algae which could put an extra pressure on your
pump.
5. Take out any foreign body around the pump and keep clean solar product.
6. Always make sure there is enough water for the pump to work otherwise you could damage the pump.
7. Make sure you clean the pump on a regularly bases when you are cleaning face the solar panel face
down on a towel this will stop the pump running or switch it off.
8. During the winter if you can bring it inside and give a good clean ready for next year.
BATTERIES
•Keep batteries away from children and pets.
•Never dispose of batteries in a fire.
•Battery disposal, spent or expired batteries must be properly disposed of and recycled in compliance
with local regulations. For detailed information, contact your local authority.
•Follow the battery manufacturer’s safety, usage, and disposal instructions.
DISPOSAL
•Coopers of Stortford use recyclable or recycled packaging where possible.
•Please dispose of all packaging, paper, cartons, packaging in accordance with your local
recycling regulations.
•Plastics, polybags –this is made from the following recyclable plastic.

Solar 3 Tier Bronze Water Feature K202 Instructions for Use
Please read and retain these instructions for future reference v001: 13/08/21
Code & Symbol
Type of Plastic
Polypropylene
Commonly used for
Microwaveable food containers, yoghurt pots, butter tubs, disposable plates and
cups
Notes
Commonly recycled and collected from household recycling bins (packaging tape
itself not recyclable but does not interfere with cardboard)
•At the end of the product’s lifespan please check with your local council authorised household waste
recycling centre for disposal.