gure 1
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS
1. Do not leave appliance when plugged in. Unplug
from outlet when not in use and before servicing.
2. Do not use outdoors or on wet surfaces.
3. Do not allow to be used as a toy. Close attention
is necessary when used by or near children or
inrm persons. This appliance is not intended for
use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning the
use of the appliance by a person responsible for
their safety.
4. Use only as described in this manual. Use only
manufacturer’s recommended attachments.
5. Do not use with damaged cord or plug. If appliance
is not working as it should, has been dropped,
damaged, left outdoors, or dropped into water,
return it to a service center.
6.Do not pull or carry by cord, use cord as a handle,
close a door on cord, or pull cord around sharp
edges or corners. Keep cord away from heated
surfaces.
7. Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
8. Do not handle plug or appliance with wet hands.
9. Do not put any objects into openings. Do not use
with any opening blocked; keep free of dust, lint,
hair, and anything that may reduce air ow.
10.Keep hair, loose clothing, ngers, and all parts of
body away from openings and moving parts.
11.Do not pick up anything that is burning or
smoking, such as cigarettes, matches, or hot ashes.
12.Do not use without dust bag and/or lters in place.
13.Turn off all controls before unplugging.
14.Use extra care when cleaning on stairs.
15.Do not use to pick up ammable or combustible
liquids such as gasoline or use in areas where they
may be present.
16.Connect to a properly grounded outlet only. See
Grounding Instructions.
This appliance must be grounded. If it should malfunction
or break down, grounding provides a path of least resistance
for electric current to reduce the risk of electric shock. This
appliance is equipped with a cord having an equipment-
grounding conductor and grounding plug. The plug must be
inserted into an appropriate
outlet that is properly
installed and grounded in
accordance with all local
codes and ordinances. No
adaptor should be used with
this appliance.
WARNING
Improper connection of the equipment-grounding conductor
can result in a risk of electric shock. Check with a qualied
electrician or service person if you are in doubt as to
whether the outlet is properly grounded. Do not modify the
plug provided with the appliance – if it will not t the outlet
have a proper outlet installed by a qualied electrician.
This appliance is for use on a nominal 120 V circuit, and has
a grounded plug (gure 1). Make sure that the appliance is
connected to an outlet having the same conguration as the
plug. No adaptor should be used with this appliance.
GROUNDING INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the following.
Read all instructions before using this appliance.
WARNING - To reduce the risk of re, electric shock, or injury:
gure 4
retention
ring
A
B
tabs on bag
adaptator
gure 5
gure 3
A
B
gure 2
SCHEMATIC – HAIR JET
1. Circuit Breaker
2. Serial Number
3. Automatic Dustpan
4. Integrated Inlet
2
3
1
4
HOSE HOOK-UP & INLETS
If using an On-Off hose…
To start your Hair Jet, simply insert
the hose in the vacuum inlet of your
choice. Please ensure that the tab
on the hose end is properly lined
up with the slot in the inlet
opening (gure 3). If your
hose handle has an integrated
on-off switch, simply slide the
switch to the “on” position.
MAINTENANCE
Change the bag when the one in place is full. Frequency will
depend on the use of the unit.
1. To access the bag, lift and remove the unit’s top cover.
2. Remove the used bag and seal bag opening (adhesive seal
provided on each bag). Discard used bag.
3. Install the new bag, ensuring the tabs on the bag adaptor
are aligned with the slots in the bag collar (gure 4).
4. Ensure adequate sealing by inserting bag as far as the
retention ring (gure 4-A). Rotate bag 20° (gure 4-B)
to ensure tabs on bag adaptor are no longer aligned with
the slots in the bag collar.
5. Replace the unit’s top cover.
The disc-shaped lter
(gure 6), located between the
dust bag and the motor, should
be changed once for every three
bags, or more often as needed.
Part Number :
TDSAC43G
OPERATING INSTRUCTIONS
Place Hair Jet on a smooth, dry, level surface in close
proximity to a 120v electrical outlet.
Plug unit into outlet, and sweep debris to the front of the
automatic dustpan. To activate the dustpan, lift up on the
dustpan ange with your toe (gure 2-A). To shut unit off,
push down on the right side of the dustpan until it clicks in
place (gure 2-B).
To activate the system for use as a central vacuum system,
lift up on integrated inlet door and insert hose. Unit will
automatically turn on. To shut unit off, unplug the hose.
Note:
If you are unable to store the Hair Jet against a wall, you
may want to use the rubber pads for added stability. Place a
rubber pad on the bottom of each rear corner of the Hair Jet
base. Do not use the rubber pads at the front of the unit.
