Garage Tek GT1309E User manual

INSTALLATION INSTRUCTIONS
GT1309E DRAWER - BASKET
CARTON CONTENTS
QUANTITY DESCRIPTION
1 DRAWER –BASKET ASSEMBLY
4 MOUNTING SCREWS
TOOLS REQUIRED - ELECTRIC DRIVER / DRILL
PHILLIPS BIT
DRILL BIT, 1/8”
TAPE MEASURE
PG 1 QUESTIONS ???? CALL 1-866 664 2724 REV 1, 8/11

DRAWER - BASKET ASSEMBLY INSTRUCTIONS
STEP 1 STEP 2
STEP #1: CHECK PARTS RECEIVED.
STEP #2: TIP: IT IS MUCH EASIER TO MOUNT THE DRAWER TO THE TABLE TOP IF THE TOP IS LAYING
“UPSIDE”DOWN ON THE FLOOR AS SHOWN. HOWEVER, THE DRAWER CAN CERTAINLY BE INSTALLED
WITH THE TABLE TOP INSTALLED ALSO.
PLACE THE DRAWER NEAR THE FRONT EDGE OF THE TABLE TOP AND CENTERED LEFT / RIGHT AS YOU
DEISIRE.
STEP 3 STEP 4
STEP #3: MEASURE / POSITION THE SIDE PANELS 4”FROM THE TABLE TOP FRONT EDGE AS SHOWN.
STEP #4: MARK THRU THE FASTENER OPENINGS; MOVE THE DRAWER ASIDE AND PREDRILL HOLES FOR
THE SCREWS. BE CAREFUL NO TO DRILL THRU THE TABLE TOP.
REPOSITION THE DRAWER AND DRIVE THE SUPPLIED SCREWS IN PLACE. THE ASSEMBLY IS COMPLETE.
PG 2