Garden Treasures MD170 User manual

Item # 58695
Submersible Fountain Pump
(Model # MD170)
Questions, Problems, Missing Parts?
Before returning to your retailer, call our customer servicedepartment at
1-[phone], 8 a.m. – 6 p.m. EST, Monday – Friday ore-mail us at [e-mail]
Please have your model number available
Parts List No Tools Required for Assembly
Part # Description Quantity
1 Pump 1
Warnings
•Risk of electrical shock. This pump is supplied with a grounding conductor and grounding–type attachment plug. To
reduce the risk of electric shock, be certain that it is connected only to a properly grounded, grounding- type receptacle
(GFCI).
•Do not exceed the voltage shown on the pump.
•Always disconnect pump from the power source before beginning any maintenance or work on the pump.
•Inspect cord for damage before installation and/or maintenance. Replace the entire pump assembly if damage is found.
•Do not remove the grounding pin from the power cord plug.
•To reduce the risk of electricshock, use only on portable self-contained fountains no larger than 5ft. in any dimension.
Cautions
● Use a proper power source as indicated on the pump label.
● Keep the cord away from high temperatures orother heat sources.
● Avoid using the pump when water temperatures fall below 41° F.
● Do not use the pump in water exceeding 86° F .
● Do not pump heated liquids.
● Do not let the pump run dry. Pump must be completely submerged for proper operation and cooling.
● Operate in freshwater only.Avoid heavily chlorinated water & water with high PH levers.
● Do not lift the pump byits power cord.
Assembly Instructions
1. Remove the pump from the package and untiethe power cord.
2. If applicable, attach fountain head or tubing, etc.
3. Place your pump in the desired position in your pond, or fountain, ensuring that it is completely submerged in the water. If the
pump is to be used in a pond, raise the pump off the pond floor to ensure that it is above any dirt that will collect, as this will
adversely affect pump performance.
4. Plug the pump power cord into a properly grounded, grounding type receptacle (GFCI).
5. If necessary, adjust the flow rate by moving the flow control as shown.
Care and Maintenance
•Keep water clean to prolong the life of the pump. Use of distilled water will reduce mineral deposits.
•Regular cleaning of the pump may be necessary depending upon the environment in which it is operated. Clean the pump
when it is visibly soiled or when a drop in performance is detected.
●Before cleaning, always disconnect the pump from the power source.
●Remove all parts fromthe pump and clean in warm, soapy water.
●Disassemble the pump housing and remove the impeller housing to expose the impeller assembly. Remove the impeller

assembly by gently pulling on the impeller blades. Use a soft cloth or brush to clean the impeller assembly and the inside of the
impeller housing.
Troubleshooting
If the pump fails to operate;
● Check to make sure thepower cord is plugged in and the pump is getting power.
● Check the pump outlet and any tubing, fountains, spitters etc. for kinks or obstructions.
● Remove the inlet screen and/or pump cover, and impeller housing to expose the impeller. Turn the impeller to ensure that it is
not broken or jammed.
If the performance of the pump is not satisfactory or the pumpdoes not flow evenly:
● Check to make sure thepump is completely submerged inwater.
● Check to make sure theimpeller and the housing are clean.
● Adjustflowcontrol.