Gardening Works Manger Beds User manual
Firstly, assemble the two sets of legs
by joining them using the pre-cut
joints.
Please note how one of the channels
is blocked at the centre of the X.
Select one of C T AWAY BOARDS and
slide this down the channel so that
the wide end comes to rest on to the
'stop' mentioned above.
Position the second set of legs, so
that the end of the first board can slot
into a channel that runs the whole
length of the inside of the leg.
Your Manger Bed, should now look
like this.
Manger Beds Assembly Instructions
Take the second Cut Away board and
slide it down the opposite site in the
reverse position to the first board.
The wide part of the second board
should come to rest on the stop, as
did the first.
You will probably have to move the
narrow end of the first board, so that
the second board can slot into
position.
The base of your Manger Bed, should
now look like this.
If your boards are insert correctly,
then if you roll the Manger Bed over,
the underside of the first two boards
should look like this.
The remaining boards can now be slid
on top, with the end pieces into the
centre of the X piece
Gardening Works
nit 1, Bee Mill, Ribchester, Preston. PR3 3XT
T: 01254 820088 Email: orders@recycelworks.co.uk
www.recycleworks.co.uk
Table of contents
