GBA ST1C-UL User manual

GBA ST1C-UL 110 VAC
12Vdc
Operation Manual
www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80433 / 303-670-1099

Page 2 of 25
CONTENTS
1 INTRODUCTION.......................................................................................... 3
1.1 Symbols ..................................................................................................................... 3
2 CARE AND TRANSPORT .............................................................................. 4
2.1 Transport................................................................................................................... 4
2.2 Storage ...................................................................................................................... 4
2.3 Cleaning and Drying................................................................................................... 4
2.4 Unpacking.................................................................................................................. 4
3 SAFETY DIRECTIONS & WARRANTY ............................................................ 5
3.1 General...................................................................................................................... 5
3.2 Intended Use ............................................................................................................. 5
3.3 Responsibilities.......................................................................................................... 5
3.4 Warranty ................................................................................................................... 6
4 PRODUCT INFORMATION........................................................................... 7
4.1 General Specifications ............................................................................................... 7
4.2 Product Architecture ................................................................................................. 8
4.3 Bill Cassette ............................................................................................................... 9
4.4 Opening the Bill Cassettes ....................................................................................... 10
4.5 Faceplate Options.................................................................................................... 11
4.6 Connections and User Controls................................................................................ 12
4.7 Wiring Looms........................................................................................................... 13
4.7.1 110VAC operation...................................................................................... 13
4.7.2 12Vdc operation ........................................................................................ 13
4.7.3 Programming Loom (optional) ................................................................... 13
5 ELECTRICAL INTERFACE SPECIFICATION.................................................... 14
5.1 Power Requirements ............................................................................................... 14
5.2 Safety Standards...................................................................................................... 14
5.3 110VAC Power Connector........................................................................................ 15
5.3.1 9-pin connector Details .............................................................................. 15
5.3.2 Output Relay Rating ................................................................................... 15
5.3.3 High Voltage Enable ................................................................................... 15
5.4 12Vdc Low Voltage Signal Port................................................................................. 16
5.4.1 18-pin Connector Details............................................................................ 16
5.4.2 Low Voltage Enable.................................................................................... 16
5.4.3 Signal Specifications................................................................................... 17
5.5 USB Port .................................................................................................................. 17
6 MAINTENANCE & OPERATION.................................................................. 18
6.1 Cleaning the Validator Bill Path................................................................................ 18
6.2 Lower Sensor Housing ............................................................................................. 19
6.3 Clearing a Bill Jam .................................................................................................... 20
7 DIAGNOSTICS & TROUBLESHOOTING ....................................................... 21
7.1 Diagnostics .............................................................................................................. 21
7.1.1 Diagnostic LED ........................................................................................... 21
7.1.2 Diagnostic LED –Bill Reject Codes .............................................................. 22
7.1.3 Illuminated Bill Guide Patterns................................................................... 22
7.2 Troubleshooting ...................................................................................................... 23
8 DIMENSIONAL DRAWINGS ....................................................................... 24
8.1 Upstacker / Downstacker......................................................................................... 24
9 About US.................................................................................................. 25
www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80433 / 303-670-1099

Page 3 of 25
Section
1
1 INTRODUCTION
This manual describes the operation and maintenance of the GBA ST1C-UL integrated
bill validator and stacker.
The GBA ST1C-UL bill acceptor has been specifically designed for use in UL
applications that require a 110VAC operation or 12Vdc and require to accept bill
widths up to 70mm.
The following features include:
Integral 100 - 120 Volt AC power regulator (for AC applications)
Up or Down entry stacking configuration
Fully illuminated Bill Entry Bezel
Easy access to bill path for cleaning and servicing
Cassette options for 100, 300, 600 or 1000 bills, with optional security locks
Two cassette styles offer front or rear note access
Multiple Interface Options
18 pin connector
Optional USB port for programming and connection to host controller
On board Individual bill enable / disable
UL and RoHS compliance
Please note that all references to “ST1C”in this document mean “ST1C-UL version
with integral 100 - 120 Volt AC power regulator”, where applicable.
If you have any questions about this or any other GBA and Microcoin products then
please visit our web sites at www.globalbillacceptors.com and www.microcoin.com,
or contact your regional sales office for assistance.
1.1 Symbols
The Symbols used in this manual have the following meanings:
Type Description
Danger Danger indicates an imminently hazardous situation which, if
not avoided, will result in death or serious injury.
Caution Caution indicates a potentially hazardous situation or an
unintended use which, if not avoided, could result in death or
serious injury.
Warning Warning indicates a potentially hazardous situation or an
unintended use which, if not avoided, may result in minor or
moderate injury and/or appreciable material, financial and
environmental damage.
Important paragraphs which must be adhered to in practice
as they enable the product to be used in a technically correct
and efficient manner.
www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80433 / 303-670-1099

Page 4 of 25
Section
2
2 CARE AND TRANSPORT
2.1 Transport
Shipping Whenever shipping the product, always use the original packaging,
shipping container and/or the appropriate packaging. The packaging
protects the product against potential shipping damage.
Inspection After transport inspect the product before use.
2.2 Storage
Product Respect the temperature limits when storing the equipment, particularly
in summer. Refer to section 4.1 General Specifications for information
about storage and operating temperature limits.
Inspection After long periods of storage inspect the product before use.
2.3 Cleaning and Drying
Product Use only a clean, soft, lint-free cloth for cleaning. If necessary, moisten
the cloth with water or a mix of water and up to 50% Iso-Propyl Alcohol
(IPA) . DO NOT use more than 50% IPA. Do not use other liquids; these
may attack surface coatings.
Please observe detailed instructions in section Error! Reference source
not found. Error! Reference source not found.
Damp products Dry the product and the accessories at a temperature not greater than
40°C (108°F) and clean them. Do not repack until everything is
completely dry.
Cables and plugs Keep plugs clean and dry. Blow away any dirt lodged in the plugs of the
connecting cables.
2.4 Unpacking
Inspect the Bill Acceptor for potential damage sustained in transit. If any damage is present,
return the ST1C-UL into the original packaging and notify the carrier immediately. Send a
written intent to file a claim to the delivering carrier within 72 hours from delivery. Send a
copy of that letter to the shipper. Note that only the consignee can file a claim against the
carrier for concealed damages.
If there was no damage sustained in transit, retain the original packaging for immediate
storage, future shipping or transporting.
www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80433 / 303-670-1099

Page 5 of 25
Section
3
3 SAFETY DIRECTIONS & WARRANTY
3.1 General
The following directions should enable the person responsible for the product, and
the person responsible for use of the equipment, to anticipate and avoid operational
hazards.
The person responsible for the product must ensure that all personnel who install
and maintain the product understand these directions and adhere to them.
3.2 Intended Use
Permitted Uses Bill Note Validation
Adverse Uses Adverse uses of the equipment include, but are not limited to:
Use of the product without instruction
Use outside of the intended limits
Removal of hazard notices
Opening the product while it is connected to mains power
Modification or conversion of the product
Use of products with obviously recognizable damages or defects
Warning Adverse use can lead to injury, malfunction and damage.
It is the task of the person responsible for the equipment to
inform the user about hazards and how to counteract them. The
product is not to be operated until the user has been instructed
on how to work with it.
3.3 Responsibilities
Person
installing or
maintaining
the product
The person installing or maintaining the product has the
following duties:
To understand the safety instructions on the product and the
instructions in the user manual
To be familiar with local regulations relating to safety and accident
prevention
To inform relevant person in charge immediately if the product and
the application becomes unsafe
To ensure that the national laws, regulations and conditions for the
operation are respected
Warning The person installing the product must ensure that the product
is used for its intended purpose and that it is operationally safe.
Warning This product may be installed only by an appropriately trained
and qualified technician as per any national regulation.
Warning Only Astrosys International authorized service workshops are
entitled to repair these products.
www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80433 / 303-670-1099

Page 6 of 25
3.4 Warranty
AstroSystems Inc warrants the GBA ST1C-UL Bill Acceptor for a period of one (1)
year from the date of purchase. This warranty extends to the original purchaser of
the warranted product, and to each transferee owner of the product, during the
term of the warranty.
During the warranty period, manufacturer will repair or replace (at manufacture’s
option); any parts (up to and including the complete unit) which fail to function
properly because of defects in material or workmanship.
This warranty covers the GBA ST1C-UL which has been designed to accept valid
currency. Manufacturer is not responsible for consequential damage or
performance degradation that results from counterfeit currency, foreign objects,
or other objects inserted into the Bill Acceptor.
The product to be repaired under warranty must be delivered to an Authorized
Service Centre, inbound freight prepaid. Upon request, owner must show proof of
purchase when submitting equipment for service during the warranty period.
Repair or installation at the owner’s location is NOT included in the warranty.
During the warranty period, manufacturer will pay all outbound ground freight
charges to the owner’s location. If special handling/shipping is desired, owner
must assume any shipping charges incurred.
Damage due to electrical overload, negligence, accidents, misuse, abuse,
vandalism, or act of God, is not covered by this warranty. Any alteration of the
product after manufacture voids the warranty in its entirety.
Manufacturer shall not be liable for any consequential damages as a result of
defects in material or workmanship. Any written or applied warranty of this product
is strictly limited to the refund of the cost of goods purchased.
www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80433 / 303-670-1099

Page 7 of 25
Section
4
4 PRODUCT INFORMATION
4.1 General Specifications
Bill Insertion: Up to 32 bill denominations with 4 way
insertion
Bill Dimensions: 62 to 70mm wide; 120 to 160 mm long
Bill Acceptance Rate: Greater than 95%
Cycle Time for Validation and
Stack:
Typically less than 3 seconds
Nominal Cassette Capacity: 300 bills, front or rear access
Interfaces Supported: Pulse
Parallel
NISR (Serial)
BSCP
ccTalk
ccNet
VCCS
Refer to separate manuals for more
details on each interface.
Power Supply: 110 Volt AC Nominally or 12Vdc
Environmental Range
(Operating Temperature): 0° to 55°C
(Operating Humidity): Up to 90% R.H., non-condensing
(Storage Temperature): -10° to 65°C
www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80433 / 303-670-1099

Page 8 of 25
4.2 Product Architecture
The GBA ST1C-UL bill acceptor is a modular assembly which can be easily accessed for
service and support. It consists of a Main Chassis, Faceplate and Bill Guide, Bottom
Sensor Housing and a Bill Cassette. There are interchangeable items depending upon
the specific application.
①Bill Cassette (100, 300, 600 or 1000 bill capacity)
②Faceplate & matching Bill Guides to suit 66 or 70mm bill widths.
Internal Bill Guides to suit 66mm or 70mm applications
②Faceplate
& Bill Guide
Main Chassis
①Bill Cassette
(Front or rear access)
Bottom Sensor
Housing (With
Internal Bill
Guides)
Optional Cassette Lock
(located at rear for rear access
cassette)
4.2 Main components of product assembly
www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80433 / 303-670-1099

Page 9 of 25
4.3 Bill Cassette
Bill cassettes can be provided with 100, 300, 600 or 1000 note capacity.
Each cassette may be supplied with tamper-evident security locks
The cassettes may be configured as front access or rear access styles for collecting
stored notes.
300 Bill Cassette shows a front access style
600 Bill Cassette shows a rear access style, with lock fitted
Remove the cassette by sliding
the cassette clip forwards and
lifting the cassette from the GBA
ST1C-UL unit.
Reverse this action to fit the
cassette back into place.
300 Bill Cassette
(showing front access) 600 Bill Cassette
(showing rear access)
style)
www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80433 / 303-670-1099

Page 10 of 25
4.4 Opening the Bill Cassettes
To access the bills from each cassette
Front Access Cassette
Rear Access Cassette
Squeeze two tabs
Press the release button
Pull back to open the cassette lid
Remove stacked bills
Front Access Cassette
Opening lid
Front Access Cassette
Remove stacked bills
Rear Access Cassette
Opening Lid
Rear access Cassette
Remove stacked bills
www.TURNSTILES.us / www.entrapass.com / 8641 S. Warhawk Road, Conifer, CO 80433 / 303-670-1099