Listed by
Underwriters
Laboratories
PEB9159SJSS
GE Profile™Series 1.5 Cu. Ft. Countertop Convection/Microwave Oven
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
For answers to your Monogram, GE Café™Series, GE Profile™Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center®Service, 800.626.2000. Specification Revised 3/16
OPTIONAL ACCESSORY TRIM KITS FOR GE MICROWAVE
OVENS (AVAILABLE AT ADDITIONAL COST)
For a custom built-in appearance, these kits allow built-in installation
of the countertop microwave oven into a wall or cabinet alone and are
U.L. approved for installation over a GE single electric wall oven.
These kits should not be installed over a gas wall oven.
NOTE: 120V, 60-cycle, grounded power receptacle location optional
on back within cabinet opening.
INSTALLATION INFORMATION: This information is not intended
to be used for installing unit described. Before installing, consult
installation instructions packed with product/kit for current
dimensional data.
ACCESSORY
TRIM KITS "Z"
MAX
HEIGHT
TRIM
KITS
30" Deluxe 29-3/4" 19-1/8" JX9153SJ
27" Deluxe 26-7/8" 19-1/8" JX9152SJ
EXTERIOR DIMENSIONS (IN INCHES)
Height 12-3/16"
Width 21-3/16"
Depth 16"
Depth including bumpout 20"
Depth from back of case to front legs 13"
CABINET OVERLAP REQUIREMENTS 30" 27"
A- Overlap of trim kit over top of cabinet 1" 1"
B- Overlap of trim kit over bottom of cabinet 1" 1"
C- Overlap of trim kit over sides of cabinet 3-5/16" 1-7/8"
NOTE:
Allow an additional inch
of clearance beyond trim
frame on all sides.
ACCESSORY TRIM KIT Z
JX9153 29-3/4"
JX9152 26-7/8"
19-1/8"
Allow 3"
clearance
*For ADA compliance, the microwave
must be installed no higher than 37".
A
C
23-1/8" ± 1/16"
Bracket
Trim
Kit
17-1/16" ± 1/16"
36" MIN.*
B
Z
18" MIN. receptacle
in cabinet 16" MIN.
receptacle outside
cabinet
16"
13"
20"
CABINET OVERLAP REQUIREMENTS 30"27"
A - Overlap of trim kit over top of cabinet 1" 1"
B - Overlap of trim kit over bottom of cabinet 1" 1"
C - Overlap of trim kit over sides of cabinet 3-5/16" 1-7/8"
NOTE: Allow an additional
inch of clearance beyond
trim frame on all sides.