
– 19 –
Installing the Filter Cartridge
1. Align top of filter with
cartridge holder and push until
cartridge is fully seated.
2. While continuing to ensure
cartridge is fully seated in the
holder, gently rotate the filter
(inward for BF models) until it
can no longer rotate. If rotation
is difficult, check to ensure filter
is properly aligned and fully
seated within the holder.
3. Run water from the dispenser
(approx. 2 gallons or about 5
minutes) to clear any particles
and remove air from the
system.
4. Reset Filter Status.
Touch Screen Models: Access RESET button thru the Water
Filter menu.
Non-touch Screen Models: Press and hold the Reset Filter
button for three seconds.
Note: A newly installed water filter cartridge may cause
water to spurt from the dispenser during the first 5 minutes
of operation. Use a large pitcher or sports bottle to catch the
water spray.
Note: It is normal for water to appear discolored during the
initial system flush. Water color will return to normal after
first few minutes of dispensing.
Filter Bypass Plug
To reduce the risk of property damage due to water leakage,
you MUST use the filter bypass plug when a replacement
filter cartridge is not available. The dispenser and icemaker
will not operate without either the filter or bypass plug
installed. The bypass plug is installed in the same way as a
filter cartridge.
(Continued next page)
Water Filter Cartridge
The water filter cartridge is located in one of the following
places:
- In the left-hand fresh food door (recessed in the door flange).
- In the fresh food interior on the left side wall, near the top.
When to replace the filter cartridge
The filter cartridge should be replaced every six months
or earlier if the flow of water to the dispenser or icemaker
decreases.
Touch Screen Models: A filter status message will appear on
the screen when the water filter needs to be replaced. The
filter status message must be reset manually.
The Water Filter: Replace status message can be reset by
entering the Settings menu from the home screen. Then,
select the Water Filter menu and press the RESET button.
This will reset the filter status.
Non-touch Screen Models: A filter indicator message will
illuminate in the screen when the water filter needs to be
replaced. This light must be reset by pressing and holding the
Reset Filter button for three seconds.
The filter cartridge has an expected life of six months and
should be replaced when indicated by the filter indicator on
the refrigerator, or sooner if a significant reduction in flow
occurs.
Removing the filter cartridge
To replace the filter, first remove the old cartridge by gently
lifting the filter away from housing until first release, then lift
again to remove. DO NOT TWIST. A small amount of water
may drip out.
'RQRWWZLVW
$ERXWWKH*(53:)ZDWHUILOWHUFDUWULGJH*($SSOLDQFHVFRP
WARNING: To reduce the risk associated with choking, do not allow children under 3 years of age to have access to
small parts during the installation of this product. The disposable filter cartridge should be replaced every 6 months at the
rated capacity, or sooner if a noticeable reduction in flow rate occurs.
For the maximum benefit of your filtration system, GE recommends the use of GE-branded filters only. Using GE-branded filters
in GE and Hotpoint® refrigerators provides optimal performance and reliability. GE filters meet rigorous industry NSF standards
for safety and quality that are important for products that are filtering your water. GE has not qualified non-GE-branded filters
for use in GE and Hotpoint refrigerators and there is no assurance that non-GE-branded filters meet GE's standards for quality,
performance and reliability.
If you have questions, or to order additional filter cartridges, visit our website at www.geapplianceparts.com or call GE
Parts and Accessories, 800.626.2002.
Customers in Canada should consult the yellow pages for the nearest Camco Service Center.