GearBest FuriBee F90 User manual

FuriBee F90 Wasp Mini RC Racing Quadcopter
User Manual
V1.0
FuriBee F90 Wasp Mini RC Racing Quadcopter user manual

Warnings and Safety Notes
Thanks for purchasing F90 WasMiniquadcopter.Please regularly visit F90 web
page at www.gearbest.com which is updated regularly. product information,
technical updates and manual corrections will be available on this web page.
Due to unforeseen changes or product upgrades, the informationcontained
in the manual is subject to change without notice.
Read this disclaimer carefully before using this product. By using this
product ,you here by agree to this disclaimer and signify that you have ready
them fully. please strictly follow the manual to assemble and use the product.
The manufacturer and seller assume no liability for any resulting damage or
injury arising from the operation or use of this product.
This product is a multi-rotor aircraft which will provide a very good flight
experiencewith the good condition of the power system and all the parts in
good condition. Please contact customer service for the latest instructions
and warnings. Idea-Fly will reserve the rights to update this disclaimer.
General Safety
The quadcopter can be extremely dangerous and cause bodily injury.
Exercise the utmost caution when flying and operating it. It can be dangerous
if you do not fly it in a safe manner or do not pay close attention while flying it.
You alone are responsible for its actions during flight.
Before flight, always do a quick motor test to verify that all four
propellers are spinning the correct directions. If you’re not careful,
it’s possible to accidently install the outrigger arms and/or propellers
incorrectly, which can result in the quadcopter not flying correctly and
possibly crashing.
The propellers must be removed from the motors whenever you update the autopilot’s
firmware or whenever there’s any question about safely operating the quadcopter.
• Do not attempt to fly the quadcopter if one or more of the propellers are damaged. Flying with
damaged propellers is not safe and can make the quadcopter fly uncontrollably.
• Always make sure the propellers are installed correctly and that the propeller hub washers
and mounting screws are secured tightly. Never install the propellers without also installing
the propeller hub washers!
01
FuriBee F90 Wasp Mini RC Racing Quadcopter user manual

Tableof Contents
Get to know your aircraft
Get to know your remote controller
Attention before flight
Charging the battery
02
03
04
05
05
Prepare Your Quadcopter 06
Ready for flight
Motor Unlock/Lock
07
07
End of flight 07
Operation Instruction 08
Specifications 09
FuriBee F90 Wasp Mini RC Racing Quadcopter user manual

Get to know your aircraft
SP Racing F3 EVO Brushed Flight Controller:
- It can be powered by up to three LiPo cells
- Equipped with a buzzer and you can set the voltage of alarm
- Supports signal input of PPM, SBus, DSM receivers
A
B
CDE
F
G
J
K
03
Omnipotent 8CH DSM Receiver :
- Compatibility: DSM2/DSMx series protocol remote controller
- Distance: 1.5km ( outdoor ) / 300m ( indoor )
- Interface: PPM, SBus output
8520 Coreless Motor :
- Motor diameter: 8.5mm
- Motor length: 20mm
ABody Shell
BPower Connector
DPropeller(CCW)
EPaddle protection seat
FCoreless motor
GPropeller(CW)
Antanna
J
KFrame
CCamera & Transmiter
FuriBee F90 Wasp Mini RC Racing Quadcopter user manual

Blind to your remote controller
04
The FuriBee Mini quadcopter has a build-in receiver, which
can support DSM2/DSMx type remote controller. If you get
a version that without a remote controller, you need do a
blind process.
1). Power on the quadcopter and wait for about 3s,theLED
onthereceiverwillflashquickly,itmeansthatthereceiver
inblindingmode；
2). According to the user manual of the remote controller, do
the correct steps to blind to your receiver.
*For Mkron i6, you just push the blind switch before powering
on the remote controller.
3). After blind successful, the LED on the receiver will be
constant on.
4). Using a Micro USB cable connect the quadcopter to your
PC and run the Betaflight-Configuration, then change the table
to “Receiver”, moving the sticks to check the endpoint and the
Reverse of each channel.
5).After set the remote controller success, you need set the
flight Mode appropriatelyifnecessaryusingthe
Betaflight-Configurationtool.
Blinding Process
(Remote Controller setting) (Flight Mode setting)
FuriBee F90 Wasp Mini RC Racing Quadcopter user manual

Attention before flight
The F90 mini-quad is recommended for pilots,10 years or
older, with RC hobby experience.
Only fly the F90 in dry weather, with low wind, please do not
fly in rain or heavy foggy conditions.
Always choose large open fields for flying. Check local LAW
and ordinances for legal flying areas.
Always keep at least 10 feet distance to the aircraft when
armed ,to avoid injury from high-speed propellers on the
ground or while flying. Always disarm before handling the
aircraft.
Charge The Battery
1. Connect the charger to the USB adaptor;
2.Inserting the 2S LiPo balance port to
the charger;
3. When the battery is fully charged, the charge
status LED glows constant green.
05
Low Voltage Alarm
The flight controller has a build-in buzzer and you can set the
voltage of alarm, the default warning cell voltage is 3.3V and
the minimum voltage cell voltage is 3.0v, when the voltage is
reach this points, the buzzer will give you a warning signal.
FuriBee F90 Wasp Mini RC Racing Quadcopter user manual

Prepare Your Quadcopter
Heading
ccw
cw
ccw cw
1. Install the propeller
Fix the clockwise propellers
onto the clockwise motors
based on the rotation direction
marked on the motors, then fix
the counterclockwise propellers
as the same way. Tighten the
propellers manually and make
sure the propeller is installed
in proper way and fastened.
Install prop by hand and
tighten by holding the motor
with the included wrench.
You can also use the wrench to help remove broken props
in case of crash.
2. Install the battery
First open the battery cover, then
put the battery into the top of the
body and move it forward-
backwards as required for perfect
balance, then firmly secure the
battery with the velcro strap.
1. Make sure the battery installed in a suitable place so
that the quadcopter has a best balance.
2. Please secure the battery with the velcro strap firmly to
prevent battery moving during the flight.
06
Battery
FuriBee F90 Wasp Mini RC Racing Quadcopter user manual
(Insert Battery direction)

Ready for flight
1. Place the aircraft in a wide open space, with the rear facing you.
2. Put all the switch in the remote controller to the UP position,
release all the trim buttons and function buttons, move the throttle
to the lowest position, then turn on the remote controller.
3. If you have a video receive equipment(such as a 7 inch screen,
glass, etc) please turn on the equipment and set the receive channel
to the correct channel, then turn it on.
07
Motor Unlock/Lock
Motor Unlock
After power on the remote controller and aircraft, the rear
indicator LED will be constant green, that means the flight
controller initialization finished.
Gently push the throttle stick down and move the rudder(YAW)
stick to the right side and hold for more than 2 seconds(On
the mode 2 the throttle and YAW stick is the same stick), you
will see the rear LED becomes constant blue, means the
motors are unlocked. Be very careful at this point, as pushing
the throttle stick will start the motors.
The unlock method shown as below
FuriBee F90 Wasp Mini RC Racing Quadcopter user manual

Motor Unlock/Lock
Motor Lock
Lock the motors by moving the throttle stick all the
way down and the rudder(YAW) stick all the way to
the left side and hold for about 2 seconds, the rear
LED will become constant green means that the
motors are locked.
TEST: Push the throttle up a little, the motors will not start.
End of flight
1. Land the aircraft, disarm(lock) the aircraft.
2. First power off the aircraft by unplugging the battery, then
turn off the remote controller.
3. Finally, remove the battery from the aircraft.
08
FuriBee F90 Wasp Mini RC Racing Quadcopter user manual

Operation Instruction
08
FuriBee F90 Wasp Mini RC Racing Quadcopter user manual

Specifications
General
Motor
Battery
Camera Video Resolution: 600TVL ( horizontal)
Dimension
and Weight
Package weight: 0.450 kg
Package size (L x W x H): 20.00 x 15.00 x 6.00
cm / 7.87 x 5.91 x 2.36 inches
09
Brand: FuriBee
Type: Battery,Camera,Frame Kit,Motor,
Propeller,Receiver,Transmitter
Shaft Diameter: 1.0mm
Motor Dimensions: 8.5 x 20mm
Max. Continuous Current (A): 0.15A
Battery (mAh): 400mAh 7.4V 2S 30C
FuriBee F90 Wasp Mini RC Racing Quadcopter user manual

10
FuriBee F90 Wasp Mini RC Racing Quadcopter user manual