Gefen Systems TSE100 User manual

USER MANUAL
20600 Nordhoff Street, ChatsworthCA 91311
1-800-545-6900 818-772-9100

Monitor
Keyboard
Mouse
Trackball
Touchscreen

ASKING FOR ASSISTANCE
TechnicalSupport:
Telephone [phone]
[phone]
Fax [phone]
TechnicalSupportHours:
8:00AMto5:00PM MondaythruFriday.
Gefen, Inc.
c/o CustomerService
20600 Nordhoff Street
Chatsworth CA 91311
www.gefen.com -- [email protected]
© 1995 Gefen Inc, AllRightsReserved
Notice
Gefenreservestherighttomakechangesinthe
hardware,packagingandanyaccompanyingdocumentation
withoutpriorwrittennotice.
TSE100isatrademarkofGefen, Inc.
MacintoshisatrademarkofAppleComputerInc.

TABLE OF CONTENTS
GeneralInformation
Introduction ........................................................ 1
OperationNotes ................................................... 2
TSE100SPanelSenderLayout............................... 3
TSE100SFunctionDescription............................... 4
TSE100RRecieverPanelLayout ............................ 5
TSE100RFunctionDescription............................... 6
DipSwitchSettings ............................................ 11
Warranty........................................................... 13
InstallationWiringDiagrams
2MonitorsLocal/Extended.................................... 7
1MonitorExtended .............................................. 8
2MonitorsExtended ............................................ 9
TSE100LinkCable ............................................. 10

ThankyouforpurchasingGefenSystems'TSE100
Series.TheTSE100extendsyourcomputermonitor,
keyboard,mouse,trackball,andtouchscreendevice
upto500feetawayfromthelocationofyour
Macintoshcomputer.
TheTSE100systemconsistsoftwounits,the
TSE100SSenderwhichresidesnexttothecomputer
sideandtheTSE100RReceiver,whichresidesnextto
theextendedmonitorandkeyboard.
Themonitorportonyourcomputeristypically
dividedintothreecoloroutputs,Red,Green,Blue
(RGB)andthreeSyncsignals.TheTSE100Sbuffers
the(RGB)signal. ThesesignalsareextendedbyBNC
connectors.
TheADBsignalcontrolsthekeyboard,mouse,
trackballandotherADBdevicessuchasatouch
screen.TheTSE100SbufferstheADBsignalthrough
sendandreceivelinedrivers,andthesignalis
extendedbyusingstandardtelephonecable.
YoucanconnectadditionalTSE100Series tothe
samecomputer,allowingyoutoaccessthecomputer
fromotherlocationsupto 500feetapart.
INTRODUCTION
1

OPERATION NOTES
READTHESENOTESBEFOREINSTALLINGOR
OPERATINGTHETSE100SYSTEM.
1. WARNING!:TheTSE100weredesignedtooperate on
Macintoshcomputers.Donotattempttousethisequipment
withanyothertypecomputers.
2. The TSE100Sisshippedwithmonitorswitchsettingfor
640X480resolution.Fordetailsonhowtochangethedefault
setting,refertopage11.
3. WARNING!:Whenusingalocalkeyboardnotextended
withtheTSE100Sunit,usetheGefenmodifiedADBcable.
ModifiedcableisconnectedbetweentheTSE100Ssenderand
thelocalkeyboardormouse.
3. WARNING!:WhenplugginginaTSE100Senderunit
ONLY,withouttheTSE100receiverunit,thekeyboardand
mousewillfreeze.TheTSE100Receiverunitmustbe
connected,andpoweredup,andthelinkcableinstalled
betweenbothunits,inordertooperateproperty.
4. WhenusingtheTSE100withtwomonitors,oneextended
andonelocal,bothmonitorsMUSTbethesametype.Ifthe
monitorsaredifferent,theywillnotinitializecorrectly.
5. LinkCable:Refertothewiringdiagramonpage10for
wiringinstructions.
2

V IDEOIN
LOCALMONITOR
ON
MONITOR
SETTINGS
POWER
LINK
ON
ADB
S YNC
BLUEGREENRED VERTHORIZCOMP
GEFEN SYSTEMS
WOODLANDHILLS,CA 91367
MADE INU.S.A.
VIDEO
3
35
10
TSE100S SENDER PANELS LAYOUT
9
48
6
17
2
1

4
Monitor Setting
Monitor size and screen resolution switch setting.
Computer / Video In
DB-15 Male Connector which connects to the computer
monitor port.
Local Monitor In
DB-15 female connector which connects the local monitor.
Terminator Switch
Terminate the video Input if local monitor is not used.
Link
RJ-11 Modular Jack which connects to the TSE100R
(Receiver Unit).
ADB
Mini din sub connector which connects to the computer
ADB port. (For keyboard, Mouse and Trackball).
Power On Light
Power on status indicates that the unit is plugged in.
Power
17 Volt center tapA/C 700ma external power supply.
Video Outputs
RGB video output signal using BNC connectors.
Sync Outputs
Composite, Horizontal, Vertical sync output signal using
BNC connectors.
1
2
3
4
5
6
FUNCTION DESCRIPTION
7
8
9
10

S YNC
BLUEGREENRED VERTHORIZCOMP
GEFEN SYSTEMS
WOODLANDHILLS,CA 91367
MADE INU.S.A.
VIDEO
M ONITOR POWER
LINK
ON
ADB
5
1 2 4
TSE100R RECEIVER PANELS LAYOUT
7
6
35

6
Monitor
DB-15 female connector which connects the extended
monitor.
Link
RJ-11 modular Jack which connects to a TSE100S
(Sender Unit).
ADB
Mini din sub connector which connects the extended
ADB port. (For keyboard, Mouse and Trackball).
Power On Light
Power on status indicates that the unit is plugged in.
Power
9 Volt A/C 1A external power supply.
Video In (BNC)
RGB video input signal using BNC connectors.
Sync In (BNC)
Composite, Horizontal, Vertical sync input signal using
BNC connectors.
1
2
3
4
5
FUNCTION DESCRIPTION
6
7

7
2 MONITORS LOCAL/EXTENDED - WIRING DIAGRAM

8
1 MONITOR EXTENDED - WIRING DIAGRAM

2 MONITORS EXTENDED - WIRING DIAGRAM
9

TSE100 LINK CABLE - WIRING DIAGRAM
10

MONITOR DIP SWITCH SETTINGS
Note: The following configurations can be used for setting up the
most common monitor sizes. If you can't find your specific
monitor setting, Call or fax Gefen Systems for assistance.
The dip switches are located on the front Panel of the TSE100S
unit.
11
1. ALL OFF
Use this setting when extended and
local monitor are connected.
2. Dip Switch 1 ON
Use for 14" Monitors.
Standard 640X480 Resolution.
Use Composite Sync only.
3. Dip Switch 2 ON
Use for VGA / Super VGA Monitors.
Use Horiz. and Vert. Sync. only.
3. Dip Switch 1 & 5 ON
Use for MultiScan 17" Monitors.
Use Horiz. and Vert. Sync. only.

12
5. Dip Switch 3 ON
Use for RGB 17" Monitor.
Use Horiz. and Vert. Sync. only.
MONITOR DIP SWITCH SETTINGS
6. Dip Switch 4 ON
Use for RGB 19" Monitors.
Use Horiz. and Vert. Sync. only.
7. Dip Switch 2,3 & 4 ON
Use for PAL Monitors.
Use Horiz. and Vert. Sync. only.
8. Dip Switch 1 & 6 ON
Use for MultiScan 21" Monitors.
Use Horiz. and Vert. Sync. only.
4. Dip Switches 1 & 2 ON
Use for MultiScan 14" Monitors.
Use Horiz. and Vert. Sync. only.

WARRANTY
GefenSystemswarrantstheequipmentitmanufacturestobefree
fromdefectsinmaterialandworkmanship.
IfequipmentfailsbecauseofsuchdefectsandGefenSystemsis
notifiedwithinone(1)yearfromthedateofshipment,GefenSystem
will,atitsoption,repairorreplacetheequipment,providedthatthe
equipmenthasnotbeensubjectedtomechanical,electrical,orother
abuseormodifications.
Equipmentthatfailsunderconditionsotherthanthosecoveredwill
berepairedatthecurrentpriceofpartsandlaborineffectattheof
repair.Suchrepairsarewarrantedforninety(90)daysfromthedayof
reshipmenttotheBuyer.
Thiswarrantyisinlieuofallotherwarrantiesexpressedorimplied,
includingwithoutlimitation,anyimpliedwarrantyormerchantabilityor
fitnessforanyparticularpurpose,allofwhichareexpressly
disclaimed.
Theinformationinthismanualhasbeencarefullycheckedandis
believedtobeaccurate.However,GefenSystemsassumesno
responsibilityforanyinaccuraciesthatmaybecontainedinthis
manual.InnoeventwillGefenSystems,beliablefordirect,indirect,
special,incidental,orconsequentialdamagesresultingfromanydefect
oromissioninthismanual,evenifadvisedofthepossibilityofsuch
damages.Thetechnicalinformationcontainedhereinregarding
TSE100featuresandspecificationsissubjecttochangewithoutnotice.
13
AllRightsReserved ©Copyright1995 GefenSystems

This document was created with Win2PDF available at http://www.daneprairie.com.
The unregistered version of Win2PDF is for evaluation or non-commercial use only.