Generation Lighting Perrywood Outdoor Wall User manual

Installation Instructions for
Perrywood Outdoor Wall
990W8_1420_-PWD
8414201, 8514201, 8614203, 8714203 1.0
OUTDOOR
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliantNEC
junction boxes.
This product is safety listed for wet locations.
Incandescent version may be dimmed with a standard incandescent
dimmer. version may be dimmed with a dimmer. ConsultLED LED
lamp manufacturer for additional information.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.generationlighting.com
© 2019 Generation Lighting.All rights reserved.
The "Generation Lighting" graphic is a registered trademark of
Generation Lighting. Generation Lighting reserves the right to
change specifications for product improvements without notification.
SAVE THESE INSTRUCTIONS!

2
Secure the mounting plate to the junction box.
Install the candle tubes by sliding them over the sockets.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.
Insert the glass into the cage and secure it in place using the brackets and bracket screws.
Install the cover to the top of the fixture and secure it in place using the washers and cap nuts.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Align and place the fixture base onto the mounting studs and secure it with the washers and cap nuts.
For wet locations, caulk around the base of the fixture with waterproof construction sealant.
1
2
3
4
5
6
7
Install the Fixture
8
1A
7
8
MOUNTING STUD
MOUNTING
PLATE
JUNCTION BOX
FIXTURE
BASE
9
COVER
CAP NUT
& WASHER 5
2
3
9
CAP NUT
& WASHER
10
4 4
10