Generation Lighting Wynfield Outdoor Post User manual

Installation Instructions for
Wynfield Outdoor Post
1.0
990 8_202-WYNOP
POST
82202, 89202
GP I :ENERAL RODUCT NFORMATION
This product is safety listed for wet locations.
Incandescent version may be dimmed with a standard incandescent
dimmer. version may be dimmed with a dimmer. ConsultLED LED
lamp manufacturer for additional information.
This instruction shows a typical installation.
CAUTION RISK OF FIRE-
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
7400 Linder Ave, Skokie, 160077IL
800.969.3347
www.generationlighting.com
© 2020 Generation Lighting.All rights reserved.
The "Generation Lighting" graphic is a registered trademark of
Generation Lighting. Generation Lighting reserves the right to
change specifications for product improvements without notification.
SAVE THESE INSTRUCTIONS!

2
1A
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly tuck in any wiring and secure the fixture to the post with post screws.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
Screw the studs into the fixture
Place the cover onto the fixture aligning it with the studs.
Secure the cover in place with the washers and cap nuts.
1
2
3
4
Install the Fixture
5
6
7
POST
3 2
1
COVER
5LAMP
8
4
POST SCREW
4
STUD
WASHER
CAP NUT
6
8