GetLoFi Electric Guitar Pickup Box User manual

Electric Guitar Pickup Box
BEFORE YOU BEGIN
SAFETY IS YOUR RESPONSIBILITY.
Make sure that all the compo e ts are i cluded.
Always work i a well lit a d ve tilated area.
Wash ha ds after ha dli g solder a d compo e ts.
Use o ly proper tools.
Retur s o ly accepted for u ope ed kits.
Se d us a email at circui[email protected] with a y problems or questio s.
Tools Needed for Basic Kit Assembly
25 watt or less solderi g iro with a fi e tip.
60-40 Flux-Core from Radio Shack or equivale t DO NOT USE ACID CORE or SELF CLEANING solder.
Wire Cutter for cutti g lo g legs of compo e ts close to circuit board.
Wire Stripper for exposi g the metal core of the i sulated wire.
Third Ha d or other assembly with a clip to hold the circuit board while solderi g.
Copyright GetLoFi, LLC 2012
Page 1 of 3
5/11/2013
Created:

Assembly I structio s:
Electric Pickup Panel - Clear
Mount potentiometer and jack. O serve
the panel la els, so its not ackwards
Step: 1
1uF Capacitor
Install capacitor as shown, - side
towards jack. Make hoops from legs.
Step: 2
Single Coil Electric Pickup
Carefully install the pickup using
included springs and screws. Guide the
pickup through. Its tight fit. Cut, strip,
and tin the end-wires.
Step: 3
Copyright GetLoFi, LLC 2012
Page 2 of 3
5/11/2013
Created:

Assembly I structio s:
STEREO 1/4 JACK SWITCHING
Wire sleeve ( Ground ) wire of pickup
to first pin. The HOT will go to the last
pin of the jack ( TIP )
Step: 4
Make sure to connect to the Non-
Switching side
5K B Potentiometer
Solder a short wire from middle lug of
potentiometer to same last pin of Jack
where pickup HOT wire connected.
Step: 5
Break off the little ta .
KNOB - BLACK
Slide on the kno . Your finished
project should look like this.
Step: 6
Copyright GetLoFi, LLC 2012
Page 3 of 3
5/11/2013
Created: