Giant Alarm System ZK-502C User manual

1/ 6
ZK-502C HIFI 2.0 stereo TPA3116D2 BT
Digital Amplifier 50W*2

2/ 6
Catalogue
ZK-502C HIFI 2.0 stereo TPA3116D2 BT Digital
Amplifier 50W*2 ......................................................1
Catalogue.................................................................2
Product parameters .................................................. 3
Schematic diagram of panel opening..........................4
Product details .........................................................5
Installation diagram and installation list .....................6

3/ 6
1. Product parameters

4/ 6
2. Schematic diagram of panel opening

5/ 6
3. Product details

6/ 6
4. Installation diagram and installation
list

This device complies with part 15of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for aClass B
digital device, pursuant to Part 15 oftheFCC Rules. These limits are designed to provide
reasonable protection against harmful interference in aresidential installation. This equipment
generates, uses and can radiate radio frequency energy and, ifnot installed and used in
accordance with the instructions, may cause harmful interference toradio communications.
However, there is no guarantee that interference will not occur inaparticular installation.
If this equipment does cause harmful interference toradio ortelevision reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference byone ormore of the following measures:
-- Reorient orrelocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on acircuit different
from that towhich the receiver is connected.
-- Consult the dealer oranexperienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be u
sed in portable exposure condition without restriction