TROUBLESHOOTING
CLEANING & MAINTENANCE
1. To keep your mixer grinder in top condition, follow these cleaning tips:
2. Wash jars with warm soapy water after use
3. Rinse jars and dry completely before storing
4. Use a damp cloth to clean stubborn stains and avoid abrasive cleaners
5. Run the empty jar for 5-10 seconds to prevent rusting
6. Proper care and cleaning ensures reliable performance and delicious results.
PRECAUTIONS
1. Do not clean the motor unit by immersing it in water, running water over it, or using abrasive cleaners or
scouring pads. Use a damp cloth to wipe the main unit.
2. Be cautious when handling the blades as they are sharp. Always unplug the mixer grinder from the mains
supply before cleaning and use caution when handling the blades.
3. Never leave the mixer grinder unattended while in use, and always hold the lid of the jars while the machine is running.
4. Do not overload the jars beyond their recommended capacity, and avoid running the mixer grinder continuously
for more than a few minutes at a time.
5. Keep the mixer grinder out of reach of children, and do not allow them to operate the machine unsupervised.
IMPORTANT SAFEGUARD
1. Keep the Mixer Grinder at least 6 inches (150mm) away from the wall.
2. Ensure that there is enough space around the Mixer Grinder to accommodate the various items and ingredients required.
3. Do not touch the moving parts and blades when the Mixer Grinder is in operation.
4. To avoid electrical hazards, do not immerse any part of the Mixer Grinder such as the base, plug, or cord in water or any
other liquid.
5. Keep the Mixer Grinder away from direct heat, sunlight, gas stove, or any electrical heating appliances.
6. Always use the Mixer Grinder with the lid and lid cap securely in place.
7. Never operate your Mixer Grinder without a load.
8. Do not pull the cord to disconnect; instead, grasp the plug and pull to disconnect.
9. Always disconnect the plug from the power outlet before cleaning, while emptying, and when not in use.
10. Avoid letting the power cord hang over the edge of the table or touch any hot surface. If the plug or cord is damaged, do
not use the appliance.
11. Keep the Mixer Grinder out of reach of children at all times. Close supervision is necessary when used near children.
12. Do not attempt to repair the Mixer Grinder at home or allow any unauthorized person to do so in the event of any failure.
Problem Possible Cause Solution
The appliance does not start.
The appliance suddenly stops
working while running
The appliance stops working
There 3 connection problem
The appliance is defective
It is reset by tapping the CB one time
on the bottom of the unit.
Check to see if the appliance is plugged
in and if the plug is properly inserted into
the wall socket. Switch off the appliance
and unplug it.
The appliance stops working
The appliance has overheated.
The appliance is overloaded.
The appliance is defective.
It can be reset by simply pressing CB
once on the base of the unit.
Let the appliance cool for 20 minutes
before attempting to restart it.
Remove some ingredients, add some
water and try again.
Switch off the appliance and unplug it.
The appliance generates
lots of noise.
The jar is not properly positioned.
Problem with the blender's inner
drive broken.
Correctly reposition and tighten
the Jar.
Switch off the appliance and
unplug it.
The motor does not function
properly. The appliance is defective Switch off the appliance
and unplug it.
TECHNICAL SPECIFICATIONS
Model
Performance Class
Liquidizer Jar PC
Grinder Jar PC
Chutney Jar Steel
5 6
850W MG
Rated Voltage
(with Clips)
850W MG
(without Clips)
225 gms
185 gms
110 gms
Class 1
175 gms
145 gms
90 gms
Motor 850W MG
Wattage 850W MG
230 V AC
Frequency
Insulation
Type
Armature
Speeds
RPM
50 Hz
Class F
Hybrid
Copper
3, with incher
19K, 20K, 21K
