Gigabyte S251-3O0 User manual

Giga Computing GIGABYTEChannel @GIGABYTEServer GIGABYTEofficial
How To Install a Server into a Tank
S251
Installing Server
1
2
1
Installation
1 Attach the two carabiners to server handles.
2 Put the server into the tank vertically.
 Strongly recommended to use gloves when handling the coolant.
 Before handling coolant, handlers must read the material safety data sheet (MSDS) for their safety.
 The thermal pad contains Indium foil, so it is strongly recommended to use gloves
when replacing the thermal pad.
DANGER!
CAUTION!
 Make sure the crane can handle at least 60 KG before installing the server into a tank.
 Only licensed professionals are authorized to access the restricted access location.
 The power supply fan is disabled by default, so the server must be immersed in the fluid before powering on.
 Consult with immersion cooling tank vendor to ensure compatibility and read their tank manual thoroughly.
 Do not install a GPU into the system without consulting GIGABYTE first, doing so may cause
compatibility issues.

Giga Computing GIGABYTEChannel@GIGABYTEServer GIGABYTEofficial
Learn more about GIGABYTE server, visit www.gigabyte.com/Enterprise
* All specifications are subject to change without notice. Please visit our website for the latest information.
* All other brands, logos and names are property of their respective owners.
© 2023 Giga Computing Technology Co., Ltd. All rights reserved.
Engineered by
How To Install a Thermal Pad to CPU
Installing Thermal Pad
Installation
1 Place the thermal pad at the bottom of the CPU heatsink
2. Align the carrier assembly so that the triangle on the carrier aligns with the triangle on the heatsink, and then
install the carrier assembly onto the bottom of the heatsink.
 Strongly recommended to use gloves and mask when handling the thermal pad.
 The thermal pad contains Indium foil, so it is strongly recommended to use gloves
when replacing the thermal pad.
DANGER!
2 When installing the heatsink to CPU, use a T30 Lobe screwdriver to tighten 4 captive nuts in sequence as 1-4.
The screw tightening torque: 8 ± 0.5 kgf-cm.
4
3
1
2