Gigaware 2790025 User manual

®
2790025
User’s Guide
Please read this user’s guide before using
your new duplex adapter.
Single-Line Duplex Adapter
with Built-In DSL Filter

®
2
Package Contents
• Duplex Adapter
• User’s Guide
Features
• Eliminate background noise on
telephone line
• Clear phone conversation during the
operation of the DSL modem
Notes:
• This duplex adapter with built-in DSL
filter is designed for indoor use.
• If you subscribe to DSL high-speed
internet service through your telephone
line, you must install a DSL filter
between the telephone line cord and
the telephone wall jack to prevent noise
and caller ID problems caused by DSL
interference. Contact your DSL service
provider for more information.

®
3
1 Connect Equipment to
Duplex Adapter
Plug the phone
cable into the
Phone/Fax jack.
Plug modem cable into
the DSL jack
OR
Modem

®
4
2 Plug Adapter into Phone
Socket
Specifications
Input ................................... RJ11 Phone plug x 1
Output ............................... RJ11 Phone jacks x 2
...........(1 for DSL output, 1 for telephone output)
Cable length .........................................2.5 inches
Specifications are subject to change and improvement
without notice. Actual product may vary from the
images found in this document.

®
5
Important Safety Instructions
When using your telephone equipment, basic
safety precautions should always be followed
to reduce the risk of fire, electric shock and
injury to persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions
marked on the product.
3. Do not use this product near water, for
example, near a bath tub, wash bowl,
kitchen sink, or laundry tub, in a wet
basement, or near a swimming pool.
4. Never push objects of any kind into this
product through cabinet slots as they may
touch dangerous voltages.
5. Never install telephone wiring during a
lightening storm.
6. Never install telephone jacks in wet
locations unless the jack is specifically
designed for use in wet locations.
7. Never touch uninsulated telephone wires
or terminals unless the telephone line

®
6
has been disconnected at the network
interface.
8. Use caution when installing or modifying
telephone lines.
9. Do not use the telephone to report a gas
leak in the vicinity of the leak.
Note: The USOC for the equipment is RJ14C
or RJ11C. This equipment is designed to
be connected to the telephone network or
premises wiring using a compatible modular
jack this is part 68 compliant.
Save These Instructions
FCC Information
a) This equipment complies with Part 68 of the FCC rules and the
requirements adopted by the ACTA. On the bottom of this equip-
ment is a label that contains, among other information, a product
identifier in the format US:AAAEQ##TXXXX. If requested, this
number must be provided to the telephone company.
b) The registration jack USOC for the equipment is RJ11C.
c) This equipment is designed to be connected to the telephone
network or premises wiring using a compatible modular jack and
plug which is Part 68 compliant. See installation instructions for
details.
d) The REN is useful to determine the quantity of devices that may be
connected to the telephone line. Excessive RENs on the telephone
line may result in the devices not ringing in response to an incoming
call. In most, but not all areas, the sum of RENs of all devices should
not exceed five (5). To be certain of the number of devices that may

®
7
be connected to a line, as determined by the total RENs, contact the
local telephone company.
e) If this DSL Filter causes harm to the telephone network, the
telephone company will notify you in advance that temporary
discontinuance of service may be required. But if advance notice
isn’t practical, the telephone company will notify the customer as
soon as possible. You will be advised of your right to file a complaint
with the FCC if you believe it is necessary.
f) Your telephone company may make changes in its facilities,
equipment, operations, or procedures that could affect the operation
of your equipment. If they do, you will be given advance notice so as
to give you an opportunity to maintain uninterrupted service.
g) If your DSL Filter is not performing as it should, contact Ignition L.P.
for assistance at 1-866-315-0426. If your equipment is causing harm
to the telephone network, the telephone company may request that
you disconnect the equipment until the problem is resolved.
h) Do not attempt to service this device yourself. Refer all servicing to
qualified service personnel.
i) Connection to party line service is subject to state tariffs. Contact
the state public utility commission, public service commission or
corporation commission for information.
j) If your home has specially wired alarm equipment connected to the
telephone line, ensure the installation of this DSL Filter does not
disable your alarm equipment. If you have questions about what
will disable alarm equipment, consult your telephone company or a
qualified installer.
Limited Warranty
Ignition L.P. warrants this product against defects in materials and
workmanship under normal use by the original purchaser for ninety (90) days
after the date of purchase. IGNITION L.P. MAKES NO OTHER EXPRESS
WARRANTIES.
This warranty does not cover: (a) damage or failure caused by or attributable
to abuse, misuse, failure to follow instructions, improper installation or
maintenance, alteration, accident, Acts of God (such as floods or lightning),
or excess voltage or current; (b) improper or incorrectly performed repairs
by persons who are not a Ignition L.P. Authorized Service Facility; (c)
consumables such as fuses or batteries; (d) ordinary wear and tear or
cosmetic damage; (e) transportation, shipping or insurance costs; (f) costs of
product removal, installation, set-up service, adjustment or reinstallation; and
(g) claims by persons other than the original purchaser.

®
8
Protect the environment by recycling used electronics.
Go to E-CyclingCentral.com to find an electronic recycling
center near you.
Printed in China
AO0446AAA1
© 2010. Ignition L.P. All rights reserved.
Gigaware is a registered trademark used by Ignition L.P.
Should a problem occur that is covered by this warranty, take the product and
the sales receipt as proof of purchase date to the place of purchase. Ignition
L.P. will, at its option, unless otherwise provided by law: (a) repair the product
without charge for parts and labor; (b) replace the product with the same or
a comparable product; or (c) refund the purchase price. All replaced parts and
products, and products on which a refund is made, become the property of
Ignition L.P. New or reconditioned parts and products may be used in the
performance of warranty service. Repaired or replaced parts and products
are warranted for the remainder of the original warranty period. You will be
charged for repair or replacement of the product made after the expiration of
the warranty period.
IGNITION L.P. EXPRESSLY DISCLAIMS ALL WARRANTIES AND
CONDITIONS NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED
WARRANTIES THAT MAY BE IMPOSED BY LAW, INCLUDING THE IMPLIED
WARRANTY OF MERCHANTABILITY AND, IF APPLICABLE, THE IMPLIED
WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, SHALL EXPIRE
ON THE EXPIRATION OF THE STATED WARRANTY PERIOD.
EXCEPT AS DESCRIBED ABOVE, IGNITION L.P. SHALL HAVE NO LIABILITY
OR RESPONSIBILITY TO THE PURCHASER OF THE PRODUCT OR ANY
OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR
DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE
OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY,
INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM
INCONVENIENCE AND ANY LOSS OF TIME, DATA, PROPERTY, REVENUE,
OR PROFIT AND ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSE-
QUENTIAL DAMAGES, EVEN IF IGNITION L.P. HAS BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts
or the exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you. This warranty gives you
specific legal rights, and you may also have other rights which vary from state
to state. You may contact Ignition L.P. at: Ignition L.P., 3102 Maple Ave. Suite
450, Dallas, TX 75201 02/09
For product support, call 1-866-315-0426
09A10
2790025