Gioteck HF-1 User manual

HF-1 WIRELESS CONTROLLER FOR PS3™
ERGONOMIC FPS CONTROLLER
MODEL G302A
This product is not designed, manufactured, sponsored or endorsed by Sony Computer Entertainment Inc. or any of its divisions.
PS3™ is a trademark of Sony Computer Entertainment Inc. Specification & appearance are subject to change without prior notice.
Copyright © 2009, 2010 GBB Group. All Rights Reserved.

06 | PAIRING ASSIGNING PORTS | 07
assigning ports
To assign the HF-1 to a different port, follow the instructions below:
Controller assigned to port 1. Controller assigned to port 7.
pairing your controller
The HF-1 must be paired to your PS3™ to use it wirelessly. To enable pairing, connect your controller to the PS3™
via a USB cable and pairing will happen automatically. Once paired, one or two LEDs within the crescent of the
controller will light depending on which port the controller has been assigned to.
1. Press X on Accessory Settings. 2. Press X on Reassign Controllers. 3. Scroll to assign the controller
to your desired port.

08 | OPERATION OPERATION | 09
02
flip switch
The Flip switch swaps the
functions assigned to the L1 & L2
and R1 & R2 buttons.
The HF-1 will
go into sleep
mode if not
used for 10
minutes. To
wake up the
controller,
press the
Home button.
operating your controller
To power on your controller, press and hold the home button for 2 seconds until a red LED appears in the
crescent. To power off your controller, press and hold the home button for 1 second.
01
turbo function
Pressing an action button assigned
with turbo will simulate the button being
pressed rapidly e.g. “boost firepower”.
To enable turbo function: While pressing
the Turbo button, press & release the
action button you wish to turbo.
To switch turbo off, repeat the
procedure above. NOTE: More than one
button can be assigned the turbo
function at any one time.
To clear all turbo functions: Press & hold
the Turbo button ONLY for 12 seconds.