GlacialTech SP100 User manual



SP100 LED Flood Light Installation Instruction
Photograph Description
1. Take the SP100 luminaire out of the
packaging box.
2. Tear off the protective plastic sheets at
the front and rear sides of the luminaire
to avoid affecting optical illumination
and thermal radiation.
3. Loosen the two M10 screws on both
sides.



4. Use the two M10 or 3/8" screws to fix
the U-shape brace to the wall to hang
the luminaire.

5. Attach the two M10 screws to both
sides, adjust the irradiation angle of the
luminaire, and tighten the screws on
both sides.
6. Respectively connect the Brown, Blue
and Green/Yellow wires to the Line,
Neutral and Ground terminals of an AC
power source providing AC voltage of
100~277V.



User Manual
1. Instructions
To ease the installation process and ensure the optimal performance of the product purchased,
carry out the installation procedure in compliance with the following safety regulations.
Unpack carefully and make sure there is no product damage during shipping. Should the
unpacked product be found damaged during shipping, please return it to your supplier.
Never connect the device with any dimmer switch.
All the electrical wiring necessary for the proper installation of the product is required to
be conducted by qualified personnel to prevent electric shock or product damage.
In case of a malfunction, turn off the power source immediately. Never try to repair the
product by yourself as this could cause serious damage and will void your warranty.
Instead, contact your local dealer for technical assistance.
2. Luminaire
Never touch the luminaire when it turns on or gets hot.
Unless otherwise specified, never use the luminaire in humid environments.
Appropriate ambient temperature: -20 to 40°C
Please refer to www.GlacialLight.com for the complete installation manual.