Glasdon NEXUS SHUTTLE BIN Manual

To Secure a Sack in Position (Sack Retention Model)
NEXUS®SHUTTLE BIN
Operator Instruction Leaflet
To Open and Close Lid (Sack Retention or Solid Liner Model)
IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE
Using your foot, push
downwards onto the pedal
allowing the lid to rise.
With your foot still on the
pedal, place food waste
into the aperture.
Remove your foot from the
pedal to allow the lid to
close softly.
To Keep Lid in an Open Position for Emptying/Replacing Sack (Sack Retention or
Solid Liner Model)
Repeat Step 1. With your foot still on the pedal,
push the lid backwards so that it
locates within the recess.
To close the lid, pull
forwards towards you.
1. 2. 3.
4. 5. 6.
7. 8. 9.
Repeat Steps 4 & 5 to allow
the lid to remain in the open
position.
Pull the sack bands upwards
from the aperture. Pull the sack up through the
aperture and wrap over the
sack bands. 1.

To Secure a Sack in Position
(continued) To Empty the Sack (Sack Retention Model)
Pull the sack out of the body
towards you for minimal
manual handling.
Replace the bin with a new
sack following steps 7 -10.
10. 11. 12.
Push the sack bands down into
the aperture so that the sack is
held securely and neatly. Ensure
that the sack is sat within the bin
body behind the support bar or
in the centre of the shelf.
13.
Repeat Steps 4 & 5 to
allow the lid to remain in
the open position.
Pull the sack bands upwards
to release the sack.
14.
15. 16.
To Remove and Adjust Height of Shelf (Sack Retention Model)
Using the lip of the shelf,
pull the shelf towards you. Sit the shelf on top of the
relevant brackets. Note: The shelf is
dishwasher safe.
NEXUS®SHUTTLE BIN
Operator Instruction Leaflet
2.

To Remove, Empty, and Replace Solid Liner (Solid Liner Model)
17. 18.
Place one hand under the
lip on the front of the liner
and pull towards you to
remove the liner from the
bin body.
Push the liner lid firmly down
onto the liner. (Liner lid is
dishwasher safe). This will keep
the food contained when
being moved or if being stored
for emptying at a later time.
Place both hands onto the
liner handles and tilt the liner
towards you allowing it to be
wheeled.
19.
20. 21.
Once at the disposal area,
place one hand onto a
liner handle and one into
the base recess. Lift the
liner to empty.
Using the lip of the liner,
hook this onto the edge of
the wheeled bin (example)
and tip the liner to empty
the food.
After jet washing the liner,
follow step 20 to wheel the
liner back to the bin body.
22.
23. 24.
If the bin lid is closed, follow
steps 4 & 5 to allow the lid to
remain in the open position.
25.
Follow steps 4 & 5 to
allow the lid to remain in
the open position.
3.
NEXUS®SHUTTLE BIN
Operator Instruction Leaflet

Using Bungee Cord to Secure Sack in Solid Liner (Solid Liner Model)
26. 27. 28.
Remove the bungee cord
from around the liner by
pulling up and over.
Place the sack inside the
liner ensuring that the sack
overhangs the liner rim.
Pull the bungee cord over
the sack so that it sits
underneath the rim of the
liner.
4.
NEXUS®SHUTTLE BIN
Operator Instruction Leaflet
Attaching A4 Sign Kit
Remove solid liner from bin, if applicable. Position the sign
carrier at the rear of the bin so that the holes are aligned
with the holes in the bin. From inside the bin place 4 off
screws and washers provided through the holes and fix on
the back of the bin with 4 off washers and nyloc nuts.
Using a 10mm spanner and allen key tighten nuts until
secure.
Place A4 sign behind
the clear polycarbonate
sheet and slide into the
sign carrier so that the
lugs locate into the slots
along the bottom of the
sign carrier.
Inserting A4 Sign
29.
30.
Glasdon U.K. Limited
Preston New Road
BLACKPOOL
Lancashire FY4 4UL
Tel: [phone]
Fax: [phone]
email: [email protected]
web: www.glasdon.com
AND NEXUS SHUTTLE BIN ARE TRADEMARKS OF GLASDON GROUP
OR ITS SUBSIDIARIES IN THE U.K.AND OTHER COUNTRIES
• Aplanned maintenance schedule of regular inspection is recommended, replacing
components as necessary.
• Replacement components are available direct from GLASDON UK LIMITED.
• GLASDON UK LIMITED cannot be held responsible for claims arising from incorrect
installation, unauthorised modifications or misuse of the product.
Issue 2 January 2014 C000/0427
© Copyright January 2014
Glasdon UK Ltd reserve the right to alter specifications without prior notice.
R