GLEN CANYON 4501138 User manual

WARNING
NEVER LEAVE FIRE UNATTENDED!
Do not allow small children near flame. Hot embers can
fly out in breezy conditions. Adequate fire extinguishing
material should be readily available.
WARNING
CARBON MONOXIDE HAZARD
Burning charcoal inside can kill you. It gives off carbon
monoxide, which has no odor. NEVER burn charcoal
inside homes, vehicles or tents.
Read and follow all safety statements, warnings,
assembly instructions and use & care directions before
attempting to assemble.
CAUTION
CAUTION
Some parts may contain sharp edges – especially as
noted in manual. Wear protective gloves if necessary.
WARNING
Do not use this unit on a wood deck or on combustible
surfaces such as dry grass, leaves, mulch, etc. Do not
use this unit near heat sensitive or combustible structures
such as vinyl or wood siding.
CAUTION
THIS UNIT IS HEAVY!
DO NOT assemble without a helper.
42804026 (07-12-04)
0420110104501138
Outdoor Fireplace
Copper AccentCopper Accent
For Outdoor
Use Only

STOP!
Missing a part?
No need to go back to the store!
The store where you made your purchase
does not stock parts for this item. If you
need parts, whether they are missing or
damaged, call the Customer Service toll
free Help Line.
Call us and we will gladly ship
the part you need
FREE OF CHARGE.
Call Our Help Line
Tools required for assembly: Phillips screwdriver • Adjustable wrench
ITEM DESCRIPTION
55700518 BASE KIT
55700519 SIDE PANEL TOP TRIM KIT
55700520 SIDE PANEL BOTTOM TRIM KIT
55700521 SIDE PANEL SCREEN KIT
55700522 BACK PANEL TOP TRIM KIT
55700523 BACK PANEL BOTTOM TRIM KIT
55700524 BACK PANEL SCREEN KIT
55700525 REAR CORNER POST KIT
55700526 FRONT PANEL TOP TRIM KIT
55700527 FRONT PANEL BOTTOM TRIM KIT
55700528 DOOR TOP OR BOTTOM KIT
55700529 DOOR SCREEN KIT
55700530 DOOR FRAME KIT
55700531 HINGE CORNER POST KIT
55700532 LATCH CORNER POST KIT
55700533 DOOR LATCH KIT
55700534 TOP COVER KIT
55700535 CHIMNEY SIDE PANEL KIT
55700536 CHIMNEY FRONT OR REAR PANEL KIT
29100603 HOOD CAP
29100615 HOOD CAP SCREEN
29100106 LOG RACK
55700576 LOGO PLATE KIT
42000078 HARDWARE BAG
42804026 ASSEMBLY INSTRUCTIONS
PARTS LIST
To insure your satisfaction
and for follow-up service,
register your product
online at:
www.grillregistration.com

1Attach the four to the base using
eight screws (black) and eight
flange nuts (black) for each post.
corner post
The hinge
corner post and latch corner post must be on the
same side of the base.
#10-24x1/2” #10-
24
2Attach the four Lower Panels to the Base and Corner Post using twelve screws (black) and secure with
twelve flange nuts.
#10-24x1/2”
#10-24
FIRST
Base
Corner Post Latch corner post
with square hole
Base
Logo Plate
Lower Panel
Logo plate clip
Hinge corner post
with hinge cutouts
If logo plate is not
already installed, insert
logo plate pins into two
holes in base. Press
onto
pins until snug against
inside of base.
logo plate clips
Logo plate clip

3
4
Attach the two Side Screens and One Back
Screen to the Upper panels using twelve #10-
24x1/2 screws and twelve flange nuts
Place Side Screen Assemblies into bottom panel slot. Upper Side panels will be attached to corner post in a later step.
Upper Panel
Side/back Screen
REPEAT FOR TWO REMAINING UPPER
PANEL/SCREEN COMBINATIONS

Front panel
top trim
6Attach the Front Panel and Rear Screen Assembly using four screws (black) and four flange nuts
(black).
#10-24x1/2” #10-24
Secure Side and Back screen assemblies using six screws (black) and six flange nuts (black).#10-24x1/2” #10-24
5
REPEAT FOR TWO REMAINING
PANEL/SCREEN ASSEMBLIES

8Assemble door latch and door latch
handle to door using one
screw (black) and one flange
nut (black). Make sure latch slides
easily.
#10-24x1/2”
#10-24
Door latch
Door latch handle
Inside of
fireplace
Door
assembly
7Align hinges on door assembly with hinge cutouts on corner post. Attach hinges to post using four screws
(black) and four flange nuts (black).
#10-24x1/2”
#10-24

10 Place top cover onto fireplace. Insert four
hex-head screws (silver)
from the outside and secure with four
flange nuts (silver) on inside.
#10-24x1/2”
#10-24
Top
cover
9Place log rack into fireplace. Align log rack
legs with holes in base.
Log rack

12Attach chimney assembly to top cover using
four hex-head screws (silver) and
four flange nuts (silver).
#10-24x1/2”
#10-24
Chimney assembly
Chimney assembly
Inside of fireplace
11 Assemble chimney panels as shown using
eight hex-head screws (silver)
and eight flange nuts (silver).
NOTE: Chimney side panels have two
mounting holes on the edge; front and rear
panels do not.
#10-24x1/2”
#10-24
Chimney assembly
Chimney front
or rear panel
Chimney front
or rear panel
Chimney
side
panel
Chimney
side
panel
Holes on
edges of
side panels

13 Place hood cap screen into chimney, then place
hood cap onto screen. Hood cap
Hood cap screen
WARNING
CALIFORNIA PROPOSITION 65
Combustion by-products produced when using this
product contain chemicals known to the State of
California to cause cancer, birth defects, and other
reproductive harm.
#10-24x1/2”
screw
Qty: 47
(black)
#10-24
flange nut
Qty: 47
(black)
#10-24x1/2”
hex-head screw
Qty: 16
(silver)
#10-24
flange nut
Qty: 16
(silver)
HARDWARE LIST
Hardware is shown actual size. You may have spare hardware after assembly is complete.

USE & MAINTENANCE
It is recommended that coals and ashes are removed from your fireplace between each use. Coals and ash that build up
can retrict air flow to the fire. MAKE SURE COALS AND ASH ARE COOL TO THE TOUCH BEFORE REMOVING.
If your fireplace gets wet, be sure to dry it. Wet ashes can promote rust formation. It is recommended that your fireplace be
covered when not in use. NEVER COVER A HOT OR WARM FIREPLACE. Allow it to cool first.
This fireplace is not intended to be used for a primary heat source. Do not overfill it.
The temperatures produced by wood-burning, outdoor fireplaces can vary with the type and amount of combustible being
used. While formulated to withstand high temperatures, painted surfaces can fade, peel, and eventually rust due to the
extreme, damaging heat that wood-burning fires can produce.
Comparable to the patina effect of copper and bronze, rust is the natural occurrence that results on surfaces that are not
protected by paint or porcelain and are exposed to air and moisture. High-temperature paint can be used if the rustic
appearance of your outdoor fireplace is not desired.
Outdoor fireplaces that feature a porcelain coating are still susceptible to rust spots on the screens. Fireplace mesh
screens can not be porcelain coated and will require touch-up with paint that is rated for use in high-temperature
applications.
Copper, chrome and other metallic surfaces often found on outdoor fireplaces will patina, change color, and blacken with
exposure to outdoor conditions, heat, and smoke. Cleaning these surfaces regularly after each use with an appropriate
metal polish can help reduce these effects.
If you notice any of these surface conditions before the outdoor fireplace is used, contact the Char-Broil Service Center for a
free replacement of the defective component. Manufacturing defects are covered under Char-Broil's 90 Day Limited
Warranty.
Steel and Cast Iron Surfaces
Copper and other Metallic Surfaces
Limited Warranty
The manufacturer warrants the product for replacement or repair of parts and/or workmanship for a period of 90 days. Paint is not
warranted and will require touchup.
These limited warranties are made exclusively to the original customer presenting proof of purchase. These warranties are limited to
non-commercial residential use only. Any returned goods must be shipped prepaid. These warranties do not cover normal wear and
tear or damages resulting from abuse or misuse. This warranty excludes incidental or consequential cost due to damages or losses or
property of any nature.
NOTICE: Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an
implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and
you may also have other legal rights which may vary from state to state.
For further information, contact the manufacturer, toll free at 1-800-232-3398.

Please register your grill online at:
(If you register online, you do not need to send in this registration card.)
WWW.GRILLREGISTRATION.COM

W.C. Bradley Co. • Columbus, GA 31902