GLG Pastello Pixel Bar 1810 User manual
Pastello Pixel Bar 1810
A. GENERAL SAFETY INSTRUCTIONS
This device hasleft the GLG factory in perfect condition. In order to maintain this condition and to ensure a safe
operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written in
this user manual.
If the device has been exposed to temperature changes due to environmental changes do not switch it on
immediately. The arising condensation could damage the device.
Leave the device switched off until it has reached room temperature.
This device falls under protection-class 1. Therefore it is essential that the device be earthed. The electric
connection must carry out by ualified person.
The device shall only be used with rate voltage and fre uency.
Make sure that the available voltage is not higher than stated at the end of this manual Make sure the power
cord is never crimped or damaged by sharp edges. If this would be the case, replacement of the cable must be
done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power
cord by the plug. Never pull out the plug by tugging the power cord.
During initial start-up some smoke or smell mayarise.
This is a normal process and does not necessarily mean that the device is defective, it should decrease
gradually.
Fixtures cannot be installed on combustible substances, keep more than 20cm
distance with wall for smooth air flow, so there should be no shelter for fans and
ventilation for heat radiation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar ualified person in order to avoid a hazard.
B. UNPACKING
Thank you for choosing our Pastello Pixelbar 1810. For your own safety, please read this manual before
installing the device. This manual covers the important information on installation and applications.
Please install and operate the fixture with following
instructions. Meanwhile, please keep this manual well for future needs.
The Pastello Pixelbar is made of a new type of high temperature strength of
engineering plastics and cast aluminum casing with nice outlook. The fixture is designed and manufactured
strictly following CE standards, complying with international standard DMX512 protocol. It's available
independently controlled and linkable with each other for operation. And it is applicable for large-scale live
performances, theater, studio, nightclubs and discos.
C. OPERATING DETERMINATIONS
This device is an LED lighting device for color decoration in discothe ues, on stages etc. It is
allowed to be operated with an AC of 200 - 250 V, and is designed for indoor use only.
This device is NOT designed to use at full output on all Led colors for a long time such as used in
fairs. It is a show light which normally will be used in show lighting with continually variation of
output and colors. The device can handle two colors in full output for a long time. Also flashing
with all outputs to full for short time will be no problem.
Do not shake the device. Avoid brute force when installing or operating.
1. Graphic part：
E
A
．
Function key
B
．
UP
C
．
DOWN
D
．
ENTER
E
．
LED DISPLAY
A B C D
Instr ctions:
Press the function key A will cycle out of fifteen different functional effects, digital tube in which the first two
digits represent the current function (see menu). After two digits to represent the kinds of functions in which
the Address Code. Or speed parameters. Press B or C key to change its value. Press the D key to confirm.
2. LED display window f nction table,
after all of the features selected according to press the D key to confirm
No.
display
f nction
1
A
001
DMX Address Setting
（
001—512
）
B
、
C key: add and reduce the address code
2
23ch/-9ch-72ch
Channel mode selection
（
23ch/9ch/72ch
）
B
、
C key: add and reduce the value
3
CC00
7 Colors jump change
（
01—99
）
B
、
C key: change the speed of jump change
4
Ed00
7 Color Fade
（
01—99
）
B
、
C key: change the speed of fade
5
Er
00
7 Colors running 1
（
01—99
）
B
、
C key: change the speed of pulse change,
Setting ID, enabling multi-lamps water effects
6
Po00
7 Colors running 2
（
01—99
）
B
、
C key: change the speed of pulse change,
Setting ID, enabling multi-lamps water effects
7
tr00
Running change
（
01—99
）
B
、
C key: change the patterns of running
8 tU00 Speed of running
（
01—99
）
B
、
C key: change the speed of the running
9
BE50
Colorful running changes under sound control
B, C key to modify the voice sensitivity
10 R200
Red color selection (000
-
255)
B, C key to modify the color values
11 G200
Green color selection (000
-
255)
B, C key to modify the color values
12 B200
Blue color selection (000
-
255)
B, C key to modify the color values
13 W200
White color selection (000
-
255)
B, C key to modify the color values
14 ID00
Lamps ID (01
-
14)
B, C keys to change the ID value (for water
effects, enabling multi-lamps water effects)
15 OPRT
Slave
3．9 DMX512 channels
No. f nction
1CH Total dimmer R,G,B,W total dimmer
，
Linear dimming, from dark to light
2CH Total strobe R,G,B,W total strobe, from slow to fast
3CH Function
selection 1
0--25: None
26--35: None
36--45: Colorful water (jump), (Id code staggered, can
achieve more lamps water effects, controlled by channel
1-9)
46--55: Colorful water (fade), (Id code staggered, can
achieve more lamps water effects, controlled by channel
1-9)
56--65: color selection; (controlled by channel 1-5)
66--75: transition (controlled by channel 5 )
76--85: gradient pulse change (controlled by channel 1-5)
86--95: running pattern 1 (controlled by channel 1-9)
96--105: running pattern 2 (controlled by channel 1-9)
. . etc..etc…
236--245: running pattern 15 (controlled by channel 1-9)
246--255: Sound activate (controlled by channel 1-9)
4CH Function
selection 2
(when
CH3=0--25)
0--5
：
None
6--255
：
Fixed 255 patterns (controlled by channel 1-9)
When
CH3=36--35
Colorful flow direction control (0-127: Left to
water,128--255: the right to water.)
5CH Function
speed
0-255: From slow to fast
6CH R dimmer Red dimmer, Linear dimming, from dark to light
7CH G dimmer Green dimmer, Linear dimming, from dark to light
8CH B dimmer Blue dimmer, Linear dimming, from dark to light
9CH W dimmer White dimmer, Linear dimming, from dark to light
4．23 DMX512 channels
No.
f nction
1CH
Total dimmer
R,G,B,W total dimmer
，
Linear dimming, from dark to
light
2CH
Total strobe
R,G,B
,W
total strobe,
from slow to
fast
0--4 no strobe
5--255 strobe from slow to fast
3
CH
Function
selection 1
0
--
25: None
26--35: 7 color selection water(controlled by channel
1-23)
36--45: Colorful water (jump), (Id code staggered,
can achieve more lamps water effects, controlled by
channel 1-9)
46--55: Colorful water (fade), (Id code staggered,
can achieve more lamps water effects, controlled by
channel 1-9)
56--65: color selection; (controlled by channel 1-5)
66--75: transition (controlled by channel 5 )
76--85: gradient pulse change (controlled by
channel 1-5)
86--95: running pattern 1 (controlled by channel 1-9)
96--105: running pattern 2 (controlled by channel
1-9)
. . etc. . .etc….
236--245: running pattern 15 (controlled by channel
1-9)
246--255: Sound activate (controlled by channel
1-9)
4
CH
Function
selection 2
(when
CH3=0--25)
0--5
：
None
6--255
：
Fixed 255 patterns (controlled by channel
1-9)
When
CH3=36--35
Colorful flow dire
ction control (0
-
127: Left to
water,128--255: the right to water.)
5
CH
Function
speed
0
-
255:
From slow to
fast
6
CH
1
dimmer
R
,G,B,W
dimme
r
7
CH
2
dimmer
R
,G,B,W
dimme
r
8
CH
3
dimmer
R
,G,B,W
dimme
r
9
CH
4
dimmer
R
,G,B,W
dimme
r
......
......
......
2
3
CH
18
dimmer
R
,G,B,W
dimme
r
5．72 DMX512 channels
No.
f nction
1
CH
R
1
dimmer
Red dimmer,
Linear dimming, from dark to light
2
CH
G
1
dimmer
Green dimmer,
Linear dimming, from dark to
light
3
CH
B
1
dimmer
Blue dimmer,
Linear dimming, from dark to light
4
CH
W1
dimmer
White
dimmer,
Linear dimming, from dark to
light
5
CH
R
2
dimmer
Red dimmer,
Linear dimming, from dark to light
6
CH
G
2
dimmer
Green dimmer,
Linear dimming, from dark to
light
7
CH
B
2 dimmer
Blue dimmer,
Linear dimming, from dark to light
8
C
H
W2
dimmer
White
dimmer,
Linear dimming, from dark to
light
......
......
......
72
CH
W18
dimmer
White
dimmer,
Linear dimming, from dark to
light
TECHNICAL SPECIFICATIONS
Power supply
AC 200
-
250V, 50Hz
Power cosumption
210 watt
Led uantity
1
8 x 10 watt RGBW
Service life
Exceed 30.000 hours
DMX 512 protocol
72 channels max.
Please note: Every information is subject to change without prior notice
GLG is a trademark from Goed Licht en Geluid.
The Netherlands. www.goedlichtengeluid.nl
Table of contents
Other GLG Dj Equipment manuals
