GLITZHOME SOLAR POST CAP LIGHT User manual

ASSEMBLY INSTRUCTION
Glitzhome, LLC
SOLAR POST CAP LIGHT (SET OF 4)
HOW THE SOLAR LIGHT WORKS:
During the day, the solar panel converts solar power into energy and stores it in the rechargeable battery. At night, the light
turns on automatically and using the energy stored. The duration of the illumination will depend on your geographical
location, weather conditions and seasonal light availability.
CHOOSE AN IDEAL LOCATION:
Choose an outdoor location where the solar panel can receive at least 6 hours of full and direct sunlight each day. Shaded
locations will reduce the battery charge and shorten the illumination time at night. Avoid placing solar lights near bright light
sources, such as street lights. The bright light sources may cause the solar light to turn off automatically. Solar lights are
ideal for night time lighting in the garden, lawn, etc. You can also place the solar lights outdoor during the day and then
place them indoor for lighting.
ATTENTION FOR FIRST TIME USE:
Turn the ON/OFF switch to the "ON" position, the light sensor will control the lighting automatically. When the environment
turns dark, the solar light will turn on and use the energy stored in the battery. If you press the switch again, the solar light
will turn off to save energy. If the solar light does not turn on automatically at night after 6 hours of charging during the day,
please check the following:
1. Make sure the power switch is at the "ON" position
2. Check the battery and make sure the battery contacts the terminals securely.
3. Make sure the solar light is located in a sunny location and the solar panel can receive direct sunlight.
IMPORTANT: DOUBLE CHECK CONTENTS BEFORE DISCARDING THE PACKAGING TO
PREVENT LOSING PARTS THAT ARE NEEDED FOR ASSEMBLY
EN
ON
ALLUMER
DE
OFF
ÉTEINDRE
HECHO EN CHINA
MADE IN CHINA
FABRIQUÉ EN CHINE

ASSEMBLY INSTRUCTION
Glitzhome, LLC
1
PRECAUTIONS:
1. Please note the solar light is designed to work when the environment gets dark. If there are strong light sources nearby,
the solar light may illuminate dimly or not light up at all.
2. Although the battery has been charged by the manufacturer, the electric charge may have dropped by the time
consumer receives the product. Please let the solar light charge for a full day for the maximum performance.
3. Surface of the solar panel must be kept clean. Dusty surface will reduce charging efficiency.
REPLACE BATTERIES:
If the solar light stops working after it has been used for a long time, the battery may need to be replaced. You may open
the battery cover and replace it with a new rechargeable battery. 1pc 1.2V AA 600MAH, Ni-MH rechargeable battery
(included), same equivalent type as recommended must be used.
Step1: Unscrew the battery compartment cover by using a Phillips head screwdriver (not included). The battery compartment
is located underneath the solar panel.
Step2: Remove the exhausted battery and install 1pc new AA rechargeable battery according to the +/- polarity. Open
the compartment carefully and ensure that welding wires inside the battery terminals are not damaged.
Step3: Replace battery compartment cover, screw it back into position and make sure is properly sealed.
1. Keep batteries away from children. This product is not a toy.
2. Ensure battery contacts are clean and free of debris.
3. Install batteries according to correct polarity (+/-).
4. Remove batteries when consumed or when product is not in use for an extended period of time.
5. Contains Ni-MH battery. Batteries must be recycled or disposed of properly, in accordance with all state and local
regulations. DO NOT crush, puncture, or incinerate.
WARNING
ASSEMBLY:
A 1
PC
HARDWARE UST
CODE
B
CODE
PARTS QTY.
1
PC
QTY.
C
CODEPARTS PARTS
1
PC
QTY.
SAVE THESE INSTRUCTIONS - THIS MANUAL CONTAINS IMPORTANT SAFETY AND
OPERATING INSTRUCTIONS FOR POWER UNITS.
A
B
C
Fit for 4" x 4" Post Fit for 3-5/8" x 3-5/8" Post