GMI PCR-WT User manual

3985 S. Fletcher Road ∙ Chelsea, MI 48118
[phone] ∙ Fax [phone]
www.greenemfg.com
PCR-WT Workstation
TOOLS REQUIRED FOR ASSEMBLY
Electric Hand Drill, Phillips Head Bit, 3/8” Magnetic Hex
Driver Bit, Socket Set and Ratchet.
BEFORE ASSEMBLING THE WORKBENCH
Read through the assembly instructions to familiarize your-
self with the order in which the parts are assembled.
We suggest that you clear & vacuum the area where the
bench is to be assembled.
It is important that the bench is assembled in the same
sequence as instructed.
HARDWARE
All assembly hardware is provided.
Attach the legs to the modesty panel using (4) 1/4-20 x
1/2” Flange head bolts. The bolts will thread into pre-
installed threaded inserts in the sides of the legs
STEP 1
1/4-20 x 1/2”
Flange Head Bolt

3985 S. Fletcher Road ∙ Chelsea, MI 48118
[phone] ∙ Fax [phone]
www.greenemfg.com
STEP 2
Once legs and modesty panel are attached hang the wire
tray over the top of the modesty panel. Holes in the top of
the modesty panel will line up with holes in the wire tray.
STEP 3
Attach the top to the base.
Line up the holes in the legs with the
pre-installed wood nuts on the underside
of the top. Indicated by pink arrows. Attach
using 1/4-20 Flange head bolts. Using Spax
wood screws attach the modesty panel/wire tray
by screwing through the holes on the top edge.
Indicated by green arrows.
Flange Head Bol
#10 x 5/8”
SPAX Wood Screw
1/4-20 x 3/4”