Go Fermentor GOpump User manual

GOpump Operating Manual
Ver 0.3 02/01/23
GOpump is an intelligent pump for pumping wine or similar fluids. It can be used in 1) PUMP mode
where the delivery rate is automatically controlled at the user set flowrate; 2) BATCH mode where a
user preset volume is delivered at user set flowrate. And finally, 3) REMOTE mode where pump can be
controlled by external device (Bluetooth or WiFi).
NOTE: Do not use with fluids containing particles larger than 100 microns. DO NOT use to pump grape
must.
USAGE: general purpose winery pump for transferring or filling wine. Built-in accurate totalizer based on
magnetic flux sensing (no moving parts) provides accurate estimate of total wine transferred.
Controllable flow rate allows gentle or rapid transfer of wine. Automatic shutdown on empty detection.
NOTE: Do not use with fluids containing particles larger than 100 microns. Use a strainer at the flow inlet
to prevent solids from damaging the pump. DO NOT use to pump grape must.
Touch
screen
Carrying Handle
11.5 inch
7 inch
FLOW inlet
FLOW
outlet
13 inch
DRAIN

INSTALLATION:
GOpump is portable and can be plugged into any suitable AC outlet. The unit is equipped with a GFI
which will disconnect power in the event of a malfunction or ground fault.
Plug the GFI plug into AC and press the RESET button to power the GOpump. Press the TEST button to
turn power off.
OPERATION:
All operations are performed using the touchscreen.
Priming to remove all air from the pump and filling of the lines may be necessary for accurate
measurement of volume. Press PRIME to run pump until all air has been cleared from the outlet side.
Volume during priming does not count on total cumulative volume. If PRIME is not display, RESET will
need to be pressed to clear cumulative volume.
OPERATING MODE (PUMP or BATCHER):
Operating mode can be switched by pressing the MODE button:
•PUMP MODE:
Functions as a variable flow pump. Will control the flowrate at the set value. Cumulative volume is
displayed and saved until RESET is pressed or mode is changed.
Press to set flowrate
using keypad
clear entry
backspace
done
Press to change units:
liters or gallons per
minute
actual flowrate
set flow rate
cumulative
volume
Press to STOP pump
current
MODE
Press to zero total
Press to START pump

•BATCH MODE:
Will dispense a preset volume. Flowrate can be set at any desired value for efficiency of task and to
address foaming or agitation. Upon completion or cancellation of a batch run, it is necessary to
press RESET to run next batch. It is possible to make adjustments to batch parameters if you stop
the batch and do not RESET the counter before continuing.
SPECIFICATIONS:
Dimensions:
24 x 25 x 16cm (9.5 x 10 x 6.3 inch)
Weight:
8.5 Kg (19 lbs)
Flow rate range:
1 to 10 lpm (0.26 gpm to 2.6 gpm)
Batch range:
0.1 to 9999 liters
Power:
115/230 VAC 2A with built-in GFI
Interface:
Color LCD touch panel
Environmental:
IP65 splash-proof
Process connection:
½ FNPT inlet and outlet
Support: www.GOfermentor.com or [e-mail] Version 0.3 02/01/23
set volume to
dispense
BATCH CANCELLED
BATCH COMPLETED
Press to START
current
MODE
set flow rate
Press to CANCEL
Press RESET for new batch