2019-2628
2019-10-10
OPERATION
The Aqua Trol Above-Ground Pool Automation is an automatic chlorine generation system with a
built-in filter pump timer designed specifically for above ground pools. The operation requires a
low concentration of salt (sodium chloride) in the pool water at levels low enough that it normally
will not be tasted. The Aqua Trol Above-Ground Pool Automation automatically sanitizes your
pool by converting the salt into free chlorine which kills bacteria and algae in the pool through a
process called elecTrol ysis. Because chlorine will revert back to sodium chloride after killing the
bacteria, these reactions will continuously recycle virtually eliminating the need to add sanitizing
chemicals to your pool. The only time you may need to add more salt to the pool is when water is
replenished due to backwashing, draining, or splashing (not evaporation).
The Aqua Trol Above-Ground Pool Automation incorporates a built in timer to control the pool
filter. This timer insures that the proper daily filtration and sanitization occurs. The Aqua Trol
Above-Ground Pool Automation is designed to produce hypochlorous acid for most residential
above ground pools up to 67,500 liters (18,000 gallons). The actual amount of chlorination
required to properly sanitize a pool varies depending upon bather load, rainfall, temperature, and
the pool's cleanliness.
The cell may be mounted directly to the pool return jet. The electrical connections are
made via 120V/15A "straight blade" linecord and receptacle.
Recommended water parameters
As with any pool, it is important that you maintain chemical makeup of the pool water. The table
on the top of page 2 summarizes the levels that must be maintained. The only special requirement
for the Aqua Trol Above-Ground Pool Automation is the salt level and stabilizer. It is important to
maintain these levels in order to prevent the corrosion or scaling and to ensure maximum
enjoyment of the pool. Test your water periodically. Your local pool store can provide you with the
chemicals and procedures to adjust the water chemistry. Be sure to tell the pool store that you
are using a Aqua Trol Above-Ground Pool Automation.
□Do not add pool chemicals directly to the skimmer, this may damage the cell.
□Maintaining high salt and chlorine levels above recommended ranges can
contribute to corrosion of pool equipment.
□Check the expiry date of the test kit as test result may be inaccurate if used after
expiration date.
Note: For outdoor pools, chlorine residuals can be protected from destruction by sunlight by the
addition of stabilizer (cyanuric acid). Regulation may exist regarding the use of cyanuric acid.
Please consult with your local authority.
1
