Govaplast Play Bench Maxi User manual

Govaerts Recycling NV | Kolmenstraat 1324 | B-3570 Alken | [email protected] | www.govaplast.com 1
+/- 29 kg
34
180
41
User manual GP11
„Bench Maxi"
(version 2015-01)
Latest version can always be found at www.govaplay.com
Material
ŸSolid boards made of recycled plastic (PE), coloured throughout
(beige and brown)
ŸStainless steel screws (6 and 8 mm)
ŸGalvanized reinforcement profile
Installation
The bench GP11 is delivered fully assembled. Can be anchored.
Description
The bench consists of 2 brown bench legs and a seat with length
of 180 cm. The bench legs are made of 80 x 80 mm posts,
mounted at 15°, with a cross beam 60 x 60 mm at the bottom. The
seat consists of 2 boards 40 x 150 mm and length of 1800 mm
which are both reinforced underneath with a galvanized profile.
The edges of the boards are rounded. The seat height is 34 cm.
Anchorage
The bench can be anchored by fixing a threaded rod (M12, 50 cm
long) and nut in each pre-drilled hole (12 mm) of the bench leg.
According to EN1176, this bench is not considered as being a play equipment.
Therefore, a TÜV-certificate is not required.
100% recycled material

2 x
Govaerts Recycling NV | Kolmenstraat 1324 | B-3570 Alken | [email protected] | www.govaplast.com
2
Anchorage GP11 on a hard and flat surface
Anchorage is not necessarily needed on a school playground with
supervision.
The anchorage is done by fixing the nail plugs into the holes of the two
lower boards.
Position the bench on the desired place and mark the 2 anchorage
points. Then move the bench and drill the holes into the surface using a
drill bit of 8 mm. Put the bench on its place and fix the 2 nail plugs.
Because of the limited height in between the boards, it is
recommended to use an angle screwdriver.
Important suggestion
To drill the holes in the ground, use a sharp drill and just put the plastic
plug into the hole. It is better to screw the nail into the plug than to
hammer. This way, you don't damage the head of the nail and unfixing
will be easy.