Graco 245343 User manual

309406CINSTRUCTIONS
INSTRUCTIONS
KEEP FOR REFERENCE.
Read this and all related manuals for
important warnings and instructions.
10 mph (16 kph) Maximum Operating Speed
Battery Kit 245343
The Battery Kit allows the LineDrivertelectrical
system to power additional electrical equipment. The
LineDriver generates approximately 70W at full
throttle, the light consumes 55W. The electrical sys-
tem automatically keeps the battery charged when
light and/or additional electrical equipment are not in
use. If the light and additional electrical equipment
exceed 70W consumption for long periods of time,
without battery recharge from the electrical system, it
may be necessary to charge battery with an external
charger.
SThe LineDriver will not charge a dead battery;
battery must be initially charged before use.
The electrical system charges the battery bet-
ween 8 to 14 volts.
SConnect additional 12 volt DC equipment con-
nections directly to battery. Use only 2-wire
devices that are ground isolated. Never con-
nect ground wires or any wires to frame. Use
appropriate fuse on all additional equipment.
SThe switch on the circuit board switches the
light from regulated power from the engine
(BACK – slide switch towards engine), to DC
power from the battery (FORWARD – slide
switch away from engine). The battery will not
charge when switch is in BACK. If the battery
becomes dead at any time, slide the switch to
BACK for the light to work.
SReplace battery only with (completely sealed
lead acid type) Graco 115753.
Trouble Shooting: with battery installed
Problem Possible
Cause
Solution
Battery does
not hold charge
Bad battery Replace battery
Battery voltage
too low
BACK/FOR-
WARD switch is
at BACK
Slide switch to
FORWARD.
Charge battery
with battery
charger
Light does not
light
Bad bulb Replace bulb
Bad battery
connections
Slide switch to
BACK. If light
works, check
battery voltage.
If light does not
work and bulb
is good, check
battery connec-
tions.
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441
ECOPYRIGHT 2001, GRACO INC.
Graco Inc. is registered to I.S. EN ISO 9001

2309406
A
To Battery
(optional)
126 Bottom View Ref 59. Light Jack
Ref A. Use Only for Graco
Battery Kit Number 245343
Ref B. Connects to Honda
Engine Alternator
Switch
(no battery)
position
ti1656b
1
5
4
2
3
6
7
8
9
Ref.
No. Part No. Description Qty.
1 115753 BATTERY, 12V 1
2 198974 BOX, battery 1
3 107069 CLAMP, battery 1
4 107068 BOLT, hook 2
5 100016 WASHER, lock 2
6 110755 WASHER, plain 2
7 100011 NUT, wing 2
8 100057 SCREW, cap, hex hd 2
9 100214 WASHER, lock 2
B
59
7712676
Graco Phone Number
TO PLACE AN ORDER, contact your Graco distributor, or call 1–800–690–2894 to identify the nearest distributor.
All written and visual data contained in this document reflect the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
mm 309406
This manual contains English
Graco Headquarters: Minneapolis
International Offices: Belgium, Korea, China, Japan
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441
http://www.graco.com
11/2001, Rev 9/2006