Green Energy Options Solo III User manual

Quick Reference Guide
Solo III Display (GSM)

Get more help and support online http://greenenergyoptions.co.uk/support/solo3
SOL3-A-QSG-002
FAQs
The Solo III display is blank
Check that the power supply is connected to the
display. Also try and press any button, as it could
be that the display has switched o the back-light.
The dial is not being shown
If the current usage view is zero then the dial will
not be shown.
No generation or consumption is being shown
Check the signal strength icon and try and move
the display closer to the meter.
How do I set my tari?
Please refer to the installation guide on how to set
your taris. Access the tari settings screens by
pressing the middle button for 5 seconds.
About your Solo III display
Your Solo III display will help you understand just how much electricity your solar PV system is generating,
how much your house is using and whether there is any electricity being exported to the grid.
Signal strength
Signal quality to the hub.
Usage totals
Select between GEN (generation),
USE (house consumption), IMP
(amount being used from the
grid). All values are shown in kWh.
Generation available
Green bars f mean you are
currently exporting. Now is the
time to use cheaper energy.
Temperature
Current temperature where the
display is located.
Speedometer
Shows how much is being
generated, consumed, exported
or imported now. The digits
show the value in kW. (Only
shown when in usage view.)
Cost totals
Select between SAVE (savings),
COST (cost of import).
Importing
Red bars g mean you are
currently importing. This is the
most expensive electricity.
Buttons
c changes the total being
shown, e changes the time
period and dswitches between
usage and cost views.