Green Solar CH-PIR-15 User manual

MULTIFUNCTIONSOLARSECURITYLIGHT
INSTRUCTIONMANUAL
READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING YOUR SOLAR LIGHT.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
USAGE
Providelightingandsecuritytogarage,pathway,shedorremotecottage
anywhere,anytime.CompletelysolarpoweredandnoACpowerneeded.
PARTS
1‐‐‐1xLEDLamp
2‐‐‐1xSolarPanel
4‐‐‐6xmountingscrewsanddryanchors
5‐‐‐1xinstructionmanual

FEATURES
1. Solarpanel:amorphous165x135mm
2. Rechargeablebattery:Lithium,3.7V,2000mAh
3. Lamp:30piecessupperbrightwhiteSMDLEDs
4. Max.OutputLumen:500lumens
5. Operationmode:Multifunction.ReadthepartofOPERATION
6. Detectsmotion:upto26feet(approximately8meters)
7. Rangeofmotion:upto120degree

INSTALLATION
Decidewhereyouwanttoplacethelampandthesolarpanel.Thesolar
panelisequippedwitha10ft.(approximately3meters)connectionwire,
sothelampandthesolarpanelcanbeinstalledupto10ft.(3meters)
apart.Thesolarpanelmustbesetinalocationwherereceivesfull,directly
sunlight,aminimumofeighthoursaday.
Mountthesolarpanel
1. Placethesolarpanelinthedesiredlocation,adjustingtheunittobest
fitthesurface.
2. Marktheholelocationofthebase,thensetthesolarpanelaside.
3. Checkthatthemarkedareasareclearofobstaclessuchascablesand
electricallines.Drillholesfortheenclosedscrewsandplasticanchors.
4. Inserttheplasticanchorsthensecurethesolarpanelinplacewiththe
screws.
Mountthelamp
1. Locatetheunitsixtoeightfeet(1,8metersto2,4meters)above
groundonasolidsurfacecapableofsupportingthelampandsecure
enoughsothatitwillnotmovewhenexposedtovibrationsorwind.
Thenunitmustbehighenoughtoallowformotiondetectionandlight
distribution.
2. Marktheholelocationsofthemountingbracket,thensetthelamp
aside.
3. Checkthatthemarkedareasareclearofobstaclessuchascablesand
electricallines.Drillholesfortheenclosedscrewsandplasticanchors.
4. Securethelampinplacewiththescrews.
5. Carefullyroutethepowercodeofthesolarpaneltothelampand
connectitwiththecablefromlamp.
6. Loosenthedetectoranglelock,swivelthemotionheadsothatitfaces
theareawheremovementwilloccurandtightenthelock.

OPERATION
InitialBatteryCharging
Beforethelightcanoperateproperly,thebatteryneedtobefullycharged.
Tochargethebattery,pleasepressthebuttonandselecttheOFFmodeand

allowaminimumof8hoursoffullsunlightcharging.
ModeDescription







1. OFF:PressthebuttonontheOFFpositiontoturnoffthelightand
conservethebatterylife.TheOFFpositionacceptsthesolarpanel
charging,
2. ON:PressthebuttonontheONposition,thelightwillturnon
constantlyforlimitedtimewhen
darkness,about2hours.Thissettingwilldepletethebatteryandextra
chargingtimemayberequired.
3. TEST:PressthebuttonontheTESTposition,thelightwilloperate
duringthedayornight.Thelightwillstayonfor5secondsafterall
motionisstopped.Thismodeallowsaquicktestingofthemotion
sensorwheneveritisdaytimeornight.Followasbelow:
i. TurnthebuttontotheTESTposition.
ii. Performa“walktest”:walkinanarcacrossthefrontofthemotion
sensor.
iii. Watchthelight.Thelightwillcomeonindicatingthemotionhasbeen
detected.
iv. Stop,waitforthelighttoturnoff,andthenbeginwalkingagain.
v. Continuethisprocessuntilthedetectionzonehasbeenestablished.
vi. Ifneeded,gentlygrabthelampheadsandmovethemfromsideto
sideorupanddowntoadjustthelightcoveragearea.
4. PIR:PressthebuttononthePIRposition,thelightwillturnon
automaticallywhenmotionisdetectedatdarkness.Itstaysonfor30
secondswhennomotiondetected.
5. DIM/BRIGHT:PressthebuttonontheDIMBRIGHTposition,thelight
comesonwithdimlightatdarknesswhennomotiondetectedand
changestobightlightmodewhenmotiondetected.Andthebright
lightwillremainsfor30secondswhennomotiondetected.

TROUBLESHOOTING


BATTERYMAINTENANCEANDREPLACEMENT
Thebatteryisastandard3.7V2000mAhlithiumrechargeablebattery
whichiseasilyreplaceable.Ifthelampbeginstoilluminatedimlyorfor
shortdurationsoftimeandyouknowthatithashadsufficientsunlighton
thepanelinordertocharge,youshouldreplacethebatteryinthe
followingway:
1. Unscrewthebatterycase.
2. Takeouttheoldbatterycarefully.
3. Replacethenewbatteryandremounttheunit.

WARNING–Lithiumbatterymustberecycledordisposedofproperly.
‐‐Donotshort,incinerateoropenbattery.