Grundig PAD01 User manual

2
Introduction
Thank you for buying this GRUNDIG product, which is designed
to give you many years of trouble-free service.
You may already be familiar with using a similar unit, but please
take time to read these instructions. They are designed to
familiarise you with the unit’s many features and to ensure you
get the very best from your purchase.
Safety is important
Your safety is very important. Please therefore, ensure you read
the “Safety Instructions” before you operate this unit.
Warranty
In the unlikely event that your product fails to work normally,
please call one of our qualified service engineers on either of the
below toll free phone numbers to discuss any issues directly.
Australia
GRUNDIG Warranty: 1800 509 394
New Zealand
GRUNDIG Warranty: 0800 450 259
PAD01

3
Introduction
What’s in the Box
Safety Instructions
Your Docking System
Getting Started
Using the Dock
Other Functions
Troubleshooting
Specifications
Warranty
2
3
4
5
7
9
12
13
14
15
Carefully remove your Portable Speaker with Dock for iPad from the
box. You may wish to keep the packaging for future use. Inside the box
you will find:
• 1 x Portable Speaker with Dock for iPad (Main Unit)
• 1 x Remote Control with Battery
• 2 x Rubber Spacers for iPad2
• 1 x Power Adaptor
• 1 x iPad2 Support
• 1 x User Guide
PAD01
Contents
What’s in the box

4
Ensure that you read all of the safety instructions before operating
this unit.
• Ensure that the power cable and other connected cables are protected
and are positioned so that they are not likely to be walked on, pinched
or damaged.
• Do not position the unit in areas where it may experience humid or
damp conditions.
• Do not allow the unit to get wet. You must keep it away from dripping
or splashing water.
• Never allow children to insert foreign objects into the holes or slots on
the unit.
• Do not cover the ventilation holes with items such as tablecloths or
curtains, etc. This may cause the unit to overheat.
• No naked flame sources, such as candles, should be placed on or near
the unit.
• Do not place objects filled with liquids, such as vases or jugs, on or near
the unit.
• Do not place the unit in a closed cabinet without proper ventilation.
Safety Considerations
• Disconnect the unit from the mains supply before cleaning.
• Do not use any liquids or aerosol cleaners, as this may damage the
unit.
• Use a dry, soft, dust free cloth.
Cleaning
• There are no user serviceable parts in this unit. When servicing, refer to
qualified service technician.
• Consult your retailer if you are ever in doubt about the installation/
operation/safety of the product.
Servicing
PAD01
Safety Instructions

5
PAD01
Your Docking System
FRONT
REAR
ON/OFF
VIDEO OUT AUX IN
DC 9V
DOCKING Connector VOLUME UP Button
IR SENSOR
BASE Hinge
ROTATING Head
VIDEO ON/OFF Button
VIDEO OUT Jack AUX IN Jack
LEFT Speaker
iPad Dock
RIGHT Speaker
POWER ON / STANDBY
Button
DOCK Hinge
SUPPORT Arm
BASS Opening
DC Jack (9V)
BATTERIES Compartment
VOLUME DOWN Button

6
PAD01
Remote Control
Your Docking System
POWER ON /
STANDBY Button
VIDEO Button
REPEAT Button
MUTE Button
VOLUME UP Button
VOLUME DOWN Button
PLAY /PAUSE Button
SHUFFLE Button
SKIP FORWARD Button
SELECT Button
MENU Button
UP ARROW Button
SKIP BACKWARD Button
DOWN ARROW Button
POWER ON/ STANDBY Button Press the STANDBY Button to turn the power on or off.
VIDEO Button Press the VIDEO Button to play your iPad/iPhone/iPod
videos on your TV screen once connected via Composite
Video Out.
MENU Button Press the MENU Button to enter the iPhone/iPod Menu.
UP ARROW Button Press the UP ARROW Button to scroll through the on-
screen playlist or menu options.
SKIP BACKWARD Button Press the SKIP BACKWARD Button to rewind in a track or
skip between tracks.
DOWN ARROW Button Press the DOWN ARROW Button to scroll through the on-
screen playlist or menu options.
REPEAT Button Press the REPEAT Button to cycle through the repeat options.
MUTE Button Press the MUTE Button to turn the volume off only.
VOLUME DOWN Button Press the VOLUME DOWN Button to decrease the volume.
VOLUME UP Button Press the VOLUME UP Button to increase the volume.
PLAY/PAUSE Button Press the PLAY/PAUSE Button to play or pause playback on
your iPad/iPhone/iPod.
SHUFFLE Button Press the SHUFFLE Button to activate or deactivate the
shuffle mode on a docked iPod/iPhone/iPad.
SKIP FORWARD Button Press the SKIP FORWARD Button to skip forwards in a track
or skip between tracks.
SELECT Button Press the SELECT Button to make selections in the menu.

7
PAD01
Getting Started
1
2
Setting up the Docking System
1.Insert the connector of the power adaptor into the DC IN jack on the rear of the unit.
2.Insert the power adaptor plug into the wall socket and switch the socket on.
3.Gently dock your iPad/iPhone/iPod into the docking connector.
4.Press the button to turn the unit on.
Caution:
•Risk of product damage! Ensure that the power voltage corresponds to the voltage
printed at the bottom of the unit.
•Risk of electric shock! When you unplug the power adaptor, always pull the plug from the
socket and ensure both the unit and mains power is turned off. Never pull the cord.
•Before connecting the power adaptor, ensure you have completed all other connections.
Using the Docking System with Batteries
This unit can be powered by six UM-3 (LR6) “AA” type batteries.
1. Open the battery compartment cover located at the bottom of the unit.
2. Insert six “AA” type batteries (not supplied) into the battery compartment at the bottom
of the unit observing the polarity markings on the base of the battery compartment.
Alkaline batteries are recommended for longer life.
3. Close the battery compartment cover.
Caution:
It is important to replace the battery with the same type of battery outlined above.
•If the unit is not used for an extended period of time, we recommend removing the
battery to ensure that the battery does not leak.
•Dispose of batteries in a safe and environmentally friendly way.

8
PAD01
Getting Started
Using the Remote Control
Remove the plastic insulation tab from the battery compartment to
activate the remote control before first use.
When the operation of the remote control becomes intermittent or the
effective distance is significantly decreased, it is time to replace the original
battery with a new type CR2025 3V === lithium battery as follows:
1. Unlock and slide out the battery holder from the remote control case.
2. Replace the weak/dead battery with a new one. Be sure the battery is installed correctly.
The remote will not work if the battery is installed with the wrong polarity.
3. Insert the battery holder back into the battery slot.
Warning:
It is important to replace the battery with the same type of battery outlined above.
•If the unit is not used for an extended period of time, we recommend removing the
battery to ensure that the battery does not leak.
•Dispose of batteries in a safe and environmentally friendly way.
3
4Connecting External Devices
This unit can be connected to a number of external devices using the AUX IN jack on the
rear of the unit. This requires a 3.5mm stereo audio cable (not supplied). Please refer to
page 12 for more instructions.

9
PAD01
Using the Dock
Setting up the Dock
1. Gently dock your iPad, iPhone, or iPod touch while the unit is in portrait mode.
2. If you wish you can rotate the dock to view your iPad, iPhone or iPod in landscape mode.
3. To ensure the unit is supported, adjust the Base Hinge forward until it locks into place.
4. You can also adjust the viewing angle by tilting the iPad Dock forwards or backwards.
Recharging your Apple Device
Whilst your iPad/iPhone/iPod is docked and unit is plugged into the mains power, your iPad/
iPhone/iPod will charge automatically even while you play your favourite tunes.
If you wish to just charge your iPad/iPhone/iPod turn the unit to standby mode to reduce power
consumption.
Note: The unit will not charge your iPad/iPhone/iPod in battery mode.
Portrait Mode Landscape Mode

8. Press the Mute button on the remote control to turn off the sound only. Press the Mute
5. Press the Skip Forward button on the remote to skip to the next chapter or to the end
10
PAD01
Using the Dock
Listening to Music on your Apple Device
1. Dock your Apple device carefully and securely onto the Docking Connector.
This unit works with all models of iPad, iPhone, iPod touch, and iPod nano.
2. Press the button to turn on the unit and the touch control panel will illuminate.
3. Select the iPod function from the main screen on the iPad/iPhone/iPod touch or Music on
iPod to access your music library.
track.
4. After selecting your favourite song, press the button on the remote to play or pause the
of the track being viewed. Press and hold the Skip Forward button to fast forward through
the track.
6. Press the Skip Backwards button on the remote to skip to the previous chapter or to
the end of the track being viewed. Press and hold the Skip Backward button to rewind the
track.
7. To adjust the Volume, press the Volume (+) or (-) buttons on the unit or on the remote.
button again to restore the sound again.
Menu Navigation
You can access the menu system of your iPhone/iPod using the remote control.
1. To access the iPhone/iPod menu system, press the MENU button.
2. Use the ▲or ▼buttons to highlight the menu option you would like to operate.
3. Press the SELECT button to confirm and select the highlighted option.
Repeat Play
You can repeat a single track or all the tracks on your iPad/iPhone/iPod.
1. To repeat a single track, press the REPEAT button once. The track will be played
repeatedly.
2. To repeat all the tracks, press the REPEAT button twice. All the tracks will be played
repeatedly.
3. To cancel the repeat function, press the REPEAT button again.
Shuffle Play
The tracks on your iPad/iPhone/iPod can be played in a random order using the shuffle play
feature.
Note:
•You need to use the remote control to use this function.
•This feature only works when your iPad/iPhone/iPod is in Music mode.
Note:
•This feature only works when your iPhone/iPod is in Music mode.
•For iPad feature operation, please use your on-screen touch menus and options.
Note:
•You need to use the remote control to use this function.
•This feature only works when your iPad/iPhone/iPod is in Music mode.
1. To turn shuffle play on, press the SHUFFLE button. All the tracks will be played randomly.
2. To turn shuffle play off, press the SHUFFLE button again.