30310467 Issue 1.04
Features
Cable checking for output cables input audio
cables or 24V input cables.
Occupying one address. It can be modified in
filed.
Output port utilizes AD sampling technology for
precise testing.
DIN-Rail mounted or Wall mounted.
Standard: EN 54-18:2005
Description
With a microprocessor, DI-9305E Digital Single Riser
Output Module (the module) can communicate with a
FACP. The module is designed to connect with
70V/100V input audio signal cables or 24VDC input
cable, featuring of checking states of input or output
ports. Checking method can be set.
Connection and Cabling
Fig. 1 shows terminals on the module.
Fig. 1
(Z1, Z2) IN & OUT: Connecting with Signaling Line
Circuit (SLC) loop of FACP, polarity-insensitive.
O1, O2: Output terminals
(I1, I2) IN & OUT: Power input terminals. For
connecting with 24V signal terminals or 70V/100V
audio signal terminals (Note: there is 50kΩ
resistance between I1 and I2).
CODE: connecting with P-9910B programmer.
Recommended Wiring
1.0mm2or above fire cable for all terminals, and
subject to local codes.
Installation
Warning:
Before installing the module, disconnect
power from the loop and verify that the
guide rail is securely installed.
1) Before installation, make sure the enclosure is
in good condition and markings are complete.
2) The module can be mounted on a 35mm
DIN-Rail as shown on Fig. 2.
3) The module can also be wall mounted by 4
mounting screws as shown in Fig. 3.Mouting
space is 67mm x 40.5mm.
Fig. 2
Fig. 3
Application
Connect terminals of I1/I2 with O1/O2. The address
can be programmed in field through a P-9910B Hand
Held Programmer.
Programming Parameters:
In standby state of the programmer, Inputting “456”
and then pressing “Clear” can unlock the
programmer, pressing Fn and then number 3, “—”
(data waiting for programming) will be popped up on
the screen. Writing a parameter and then pressing
“Program”, a “P” will show on the screen meaning
the parameter is programmed.
Operation of Fn and 4can be done as the same as
