guide craft G86504 User manual

For ages 2 and up.
Adult assembly required.
! WARNING
Small parts and sharp points may be present
prior to assembly.
Care Instructions
To clean your product, use mild soap and
water on a damp cloth. Do not use window
cleaners or cleaning abrasives as they will
scratch the surface and could damage the
protective coating.
Customer Service
For questions regarding this product, or to
receive replacement or missing parts,
contact Customer Service at [phone].
Please have the model number and part
number(s) located in this Assembly
Instruction sheet available for reference.
Limited Warranty
All Guidecraft products are warranted to
the original purchaser at the time of
purchase and for a period of one (1)
year thereafter. In order to provide you
with timely assistance, please
thoroughly inspect your product for
missing or defective parts immediately
after opening the carton. To receive
replacement or missing parts under this
warranty, contact Customer Service.
You will also need your sales receipt or
other proof of purchase.
G86504 Moving All Around
Toy Box
Assembly Instructions
Guidecraft • 55509 Highway 19 West, Winthrop, MN 55396 • [phone] • www.guidecraft.com
Hardware and Parts
1.7"
(44mm)
(8)
(1)
(2)
(2)
.5"
(12mm)
(6)
(3) (3)
.8"
(20mm)
(8)
L
J
You will also need a Phillips-
head screwdriver (not included).
2.6"
60mm
1
23
45
6
7
8
A
B
D
C
E
F
G
H

Guidecraft • 55509 Highway 19 West, Winthrop, MN 55396 • [phone] • www.guidecraft.com
L
J
A
STEP 1
STEP 2
STEP 4
STEP 5
STEP 6
STEP 3
1
1
1
1
1
1
1
2
2
2
2
2
2
2
33
4
4
4
5
5
5
6
6
7
7
8
I
I
I
A
B
C
C
D
E
F
F
F
G
H
H
A
D

Guidecraft •55509 Highway 19 West, Winthrop, MN 55396 •[phone] •www.guidecraft.com
This unit is equipped with a special safety lid support. The lid support must be attached as
indicated in the assembly instructions prior to use. The purpose of the safety lid support is to
prevent injury to a child's fingers or other parts when opening and closing the lid. The safety lid
support is functioning properly when the lid can be opened at any angle without dropping more
than 1/2" inch (from its own weight), with the exception of the final 2 inches before reaching its
closed position. This unit should not be used unless the safety lid support is properly attached and
functioning properly.