Gulfstream plastics La lili User manual

Owners Manual

Manufacturers of Acrylic Baths

Whirlpools & Pedicure Foot Spas

GULFSTREAM PLASTICS LTD.

Cambridge, Ontario, Canada N1R 6T4

Phone (519) 622-0950

Toll Free 1-877-622-4853

Fax (519) 622-6926

Website: www.gulfstreamplastics.com

Contents:

Section A. Component Locations 1-2

Section B. Installation Instructions 3

Section C. Operation and use 4

Section D. Safety instruction 5

Section E. Cleaning and Maintenance 6-7

Section F. Specifications 8

Section G. Warranty 9

CAUTION:

Must be installed by a, licensed plumber and electrician

in accordance with local codes. Plumbing and

Electrical Installation instructions must be adhered to in

order for the warranty to be in effect and to insure the

utmost in safety. Chair and spa have a maximum

seating capacity of 350 pounds.

Thank you for purchasing the La Lili spa from Gulfstream Plastics Ltd.

Please carefully read instructions before installing La Lili spa.

By correctly following these instructions; your La Lili Spa, will give you

years of beauty and service.

Section A. La Lili Component Locations

Drain control

On/Off button for CleanJet motor

Water fill valve

Shiatsu massage back

Section A. La Lili Component Locations

Bottom View

Back View

Divertor Discharge pump

(optional)

ABS piping from

drain to discharge

Hot & cold hoses

Clean Jet

pump Drain with

P Trap

Discharge

pump

1/2” outlet

Outlet

switch

Hot & Cold

flex hose

1/2” outlet

Top View Sprayhead

Switch for

discharge

pump

(optional)

Knob for

drain

On/Off

button

for jet

LED light

switch

Section B. Installation Instructions

1. Discharge pump installation - The La Lili

discharge pump may be connected to an existing

sink drain or floor drain. It can also pump up to 20

ft high, but this will increase the length of the drain

time. The drain connection is at the rear of the

unit by a 1/2” fitting.

2. Gravity drain installation - The La Lili uses a

standard gravity drain. A floor drain is the

recommended installation. Connection is via a

1/2” pipe. A P-Trap is supplied.

3. Water Supply Connections – The La Lili hot

and cold connections are located at the rear of the

unit. 1/2” Fittings.

4. Electrical installation - Have a qualified

licensed electrician to install the wiring according

to local codes. The CleanJets are 1/5 hp, 120V, 15

AMP 60OHZ. A GFI protected circuit must be used

to supply power to the unit. The roller back

massage chair uses a 115V supply.

5. Secure the base - The La Lili base should be

anchored securely to the floor. The base may be

anchored through the opening in the back of the

base wherever access is convenient for the installer.

WARNING:

FAILURE TO ANCHOR THE BASE MAY RESULT

IN PERSONAL INJURY OR DAMAGE TO THE

UNIT. DAMAGE AS A RESULT WILL VOID THE

WARRANTY.

Section C. Operation and Use

1. Fill bowl – Your La Lili is provided with a

single hot and cold mixing valve located on the

front of your spa(far left). This is a pressure balance

valve that requires you to lift the handle to start the

water flow and to adjust to the temperature that is

desired. The clean jet motor must be completely

submerged in water. CAUTION: DO NOT USE

FOAMING, SUDSING OR MINERAL OIL BASED

ADDITIVES IN THE WATER.

2. To start – Press the button that is situated next

to the water fill lever. This will start your Clean Jet

motor. You may stop the whirlpool function at any

time by pressing the button again.

3. Adjustable air control - The air control

button is situated on the left hand side of the spa

base, just under the chair. You can control the

supply of air to the clean jet motor by turning this

chrome button in a clockwise direction.

4. Hand Shower – The La Lili is equipped with a

hand held sprayer. To activate the hand shower,

pull the hand shower from the receptacle and

depress the thumb control on the sprayer handle.

This will turn on the water. When you release

pressure on the thumb control this will turn the

water off.

5. Adjustable footrest - The La Lili utilizes a

comfortable 3-position footrest system in which the

footrest can be adjusted by pulling out the pin

located at the centre of the La Lili base and

placing the pin in one of the tree holes situated on

the footrest stand. You can also slide the footrest

forward by pulling out the pin located at the side

of the actual footrest. This will cause the footrest

pad to slide forward.

6. To drain whirlpool tub – La Lili. The La Lili

is equipped with a built in optional discharge

pump. Open the drain plug by turning the control

knob which is situated at the far right of the spa

base. The discharge pump will turn on

automatically and the water will drain.

7. 9500 Shiatsu Roller back massage chair -

Your La Lili is equipped with a state –of-the-art

massage system. The massage system is easy to

use; the remote has a one touch power that starts

directly in the auto function mode, or you can

select your own massage. You can also adjust the

front to rear position of the chair and the reclining

back. By using the remote your client can adjust

the back to the most comfortable position.

Section D. Safety Instructions

CAUTION: BASIC PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING

1. Read and follow all instructions

2. DANGER. To reduce the risk of injury, do not

permit children to use this unit unless they are

supervised at all times.

3. Use this unit only for its intended use as described

in this manual. Do not use attachments that are

not recommended by the manufacturer.

4. Never drop or insert any object into any opening.

5. Do not block jets during whirlpool operation.

6. The unit must be connected to an electrical

supply circuit that is protected by a ground fault

circuit interrupter.

7. SAVE THESE INSTRUCTIONS.

Section E. Cleaning & Maintenance

Gulfstream Plastics Ltd highly recommends the

following cleaning regimen. You should always

contact your local governing agency for their

specific cleaning and disinfecting requirements and

regulations for pedicure spas. For your clients

safety, always use the regulations as a minimum

standard for cleaning and disinfecting. Combining

your states standards with the regimen listed below

will provide your clients with a safe and healthy

pedicure spa environment experience.

1. Routine maintenance. Powdered cleansers or

abrasives are NOT RECOMMENDED. A clean towel

or sponge, are all that are usually needed. A soft

bristled brush may be used when excessive residue

is present. Use a mild soap and water solution to

clean the upholstery, but do not over wet. Wipe

dry with a clean towel. No internal maintenance of

the spa components is necessary. Remove clean jet

caps and spray with disinfectant after each use.

For extra protection, our recommendation is that

the system be flushed daily or weekly depending

on use. To flush the clean jet system fill spa with

hot water to just above the jets. Add disinfectant.

Run whirlpool for 15 minutes, drain and then wipe

dry with clean soft cloth.

NOTE: Cleaning or sanitizing is NOT

disinfecting. According to the Centers for

Disease Control and Prevention (CDC), and

the US Environmental Protection Agency

(EPA), disinfecting occurs only when there is

a reduction of pathogenic microbes at

99.999%. Sanitizing is only a reduction of

99.9%. Cleaning of whirlpool pedicure spas

requires surfactants and chelating

detergents that are low-foaming and have

the ability to remove body oils, organic oil

additives, mineral oil, skin cells, nail

clippings etc that can accumulate both in

the basin and the jets which may become

a fertile area for micro organisms to grow.

The use of oil based products can build up in the

whirlpool system causing clogging in the jets.

Adherence to the above cleaning will minimize

build up. Gulfstream Plastics Ltd does not

recommend the use of mineral oil based products.

TESTING/FLUSHING FOOT SPA

After foot spa has been installed, fill tub with water

just above the jets. Carefully check for leaks at

drain and overflow. After checking underside for

leaks turn on system by pushing whirlpool button

and watch for leaks as water circulates. Let tub run

full cycle. Open drain plug for water discharge.

Section E. Cleaning & Maintenance

Clean intake area using a soft bristled brush or cloth and low foam soap to remove any

visible residue. Rinse with sprayhead - Cold water

Remove screen by turning counter-clockwise.

Clean back of screen Jet with same soft brush or cloth. Rinse with cold water Replace screen by turning clockwise

Section F. Specifications

54"

xx"

56" 20"

28"

Section G. Warranty - Service

Warranty

1. Limited Three Year warranty on Spa Shell.

2. Limited One Year warranty on the Whirlpool

Pump.

3. Limited One Year warranty on the Clean Jet.

4. Limited One Year warranty on the Glass Bowl.

5. Limited One Year Parts-Only warranty which

covers the Hydraulic System, Discharge Pump,

Massage System and All Electrical Components.

6. Gulfstream will pay shipping charges on all

replacement parts during the first 90 Days of the

stated Warranty Period. After 90 days the

consumer is responsible for all labour and

shipping costs incurred.

7. During the first 90 days, any part or component

of the Product is found by the Company to be

defective, the Company will repair, without

charge for labour or parts.

Exclusions

1. Damage to pump parts and/or motor parts due

to obstruction in plumbing lines etc.

2. Staining, fading or discoloration of plastic

surfaces due to exposure and/or the use of

harmful cleaning agents or chemicals.

3. Staining, fading or discoloration caused by

improper or poor water additives not related to

the maintenance of proper water are not

covered by this warranty.

4. Staining, fading or discoloration of the seat,

armrests or footrests.

5. Freight damage, misuse, neglect, accident,

natural disaster and abuse.

6. Unauthorized repairs.

Service

1. The Dealer shall forward all warranty-related

matters to our Customer Service Department.

2. Serial Numbers and Original Invoice must

accompany all warranty claims.

3. Customers are responsible for shipping defective

parts back to Gulfstream. These parts must be

packaged correctly in order to protect against

any further damage.

4. All parts are to be shipped by UPS Ground

Service - average 2-5 days.

5. All defective parts must be shipped back to

Gulfstream withing 30 days of receiving the new

replacement parts or warranty will be void.

6. Any warranty claim that cannot be determined

over the phone, the customer must send photos

and original invoice directly to Gulfstream before

any repairs can be performed.

7. Any service performed on the product without

Gulfstreams authorisation will also void the

Warranty.

8. Each service call from the customer will be

assigned a Claim Number. The Claim Number

will stay open until the problem is resolved.

Gulfstream warrants to the original purchaser that the new pedicure spa will be free from defect during the Standard Warranty Period (listed below).

The shipping date and the uniquely-coded Serial Number on the back of each spa chair will justify the start of the warranty period for the product.

The warranty is null and void if the pedicure spa is taken from its initial place of installation, or it is not installed in accordance with federal, state or local codes

and ordinances. Also, this warranty does not apply if the pedicure spa has been subject to misapplication, improper installation or maintenance, negligence,

improper cleaning or other circumstances beyond Gulfstream’s control.