Habey BIS-6564 User manual

21015 Commerce Pointe Drive, Walnut, CA 91789
www.habeyusa.comwww.habeyusa.com
Quick Setup Guide
BIS-6564
Description QTY
BIS-6564 1
Power Cable 1
Power Adaptor 1
HDD Mounting Bracket 1
Rack Mount Ears 2
Rack Mount Screws 4
Drive Mounting Screws 4
Packing List
Safety Warning:
The use and installation of this system should only be performed by
professionals. Improper installation of any electronic device or electrical
component can result in serious injury or death. Please make sure that all
safety precautions are taken into account.

Install Guide
Unpack all package contents and inspect
each component. Make sure all included
parts and accessories are present.
Step 1 - Inspect Contents
Using a phillips head screw driver, remove
the four screws on the sides of the enclosure.
Step 2 - Remove Top Cover
Align notch in memory circuit with
corresponding guide on the memory slot.
Insert the memory circut at a 45° angle and
press the circuit at and secure it to the
memory slot with an audible click on each
side of the memory slot.
Step 3 - Install RAM
Step 4 - Install 2.5” HDD
Mount the HDD onto the bracket and then x
it with 4 screws.

www.habeyusa.comwww.habeyusa.com
Then mount the HDD bracket back onto the
backplane and x it.
Your system is now ready. Connect the power cable to a power source and
press the power button on the front of the system.
Step 6 - Hardware Installation Complete
Place the cover as illustrated in the picture
and connect SATA cable to HDD marked in
lines.
Locate the included rack mount brackets
(ears). Mount the ears on the bottom cover
by securing the ears to the side of the
enclosure with the included screws.
Step 5 - Rack Mounting

Input / Output
Dimensions
21015 Commerce Pointe Drive, Walnut, CA 91789
www. habeyusa.com
Copyright©2014. Habey USA. All Rights Reserved. Version 1.
224mm/ 9.6”
156mm/ 6.1”
54mm/ 2.1”
Rear Panel
COM
2x USB2.0
Audio
LAN
VGA
HDMI
Power S/PDIF 1x USB2.0
2x ANT