Habey FW-1042 User manual

21015 Commerce Pointe Drive, Walnut, CA 91789
www.habeyusa.comwww.habeyusa.com
Quick Setup Guide
FW-1042
Description QTY
FW-1042 1
Power Cable 1
Rack Mount Ears 2
Rack Mount Screws (Large) 4
Drive Mounting Screws (Small) 4
Packing List
Safety Warning:
The use and installation of this system should only be performed by
professionals. Improper installation of any electronic device or electrical
component can result in serious injury or death. Please make sure that all
safety precautions are taken into account.

Install Guide
Unpack all package contents and inspect each
component. Make sure all included parts and
accessories are present.
Step 1 - Inspect Contents
Using a phillips head screw driver, remove the four
screws on the sides of the enclosure.
Step 2 - Remove Top Cover
Remove the drive bracket
from the enclosure by
removing the screws at
the base of the bracket.
Mount the 2.5” drive on
the top of the bracket.
Mount the completed
bracket to the enclosure
Connect the Power and
SATA Cables,
Step 3 - Mounting a 2.5” Drive
Step 4 - Mounting a 3.5” Drive Remove the drive bracket
from the enclosure by
removing the screws at
the base of the bracket.
Mount the 3.5” drive
on the underside of
the bracket. Mount the
completed bracket to the
enclosure.
Connect the Power and
SATA Cables.
Using a phillips head screw driver, remove the
single screw at the top rear of the enclosure.

www.habeyusa.comwww.habeyusa.com
Locate the memory slot. Ensure memory is a 204-
Pin SO DIMM. Align notch in memory circuit with
corresponding guide on the memory slot. Insert the
memory circut at a 45° angle and press the circuit
at and secure it to the memory slot with an audible
click on each side of the memory slot.
Step 5 - Memory
Step 6 - Rack Mounting
Mount the ears to the front side of the enclosure by
securing the ears to the side of the enclosure with
the included screws.
Locate the included rack mount brackets (ears).
Your system is now ready. Connect the
power cable to a power source and press
the power button on the front of the system.
Step 7 - Hardware Installation Complete

Input / Output
Dimensions
21015 Commerce Pointe Drive, Walnut, CA 91789
www. habeyusa.com
Copyright@2014. Habey USA. All Rights Reserved. Version 1.
Power
PS/2 VGA
COM USB2.0
LANLPT PortPS/2
Line-In
Line-Out
425mm / 17”
170 mm / 6.7”
170 mm / 6.7”
44mm / 1.75”
250mm / 9.8”