1
SETTING UP
Use A Three-pin Socket Outlet
Make sure that the socket you
are plugging your refrigerator
in to has proper earthing.
Improper earthing can cause
electric shocks and could also
damage the appliance.
Avoid Direct Sun Light & Heat
Do Not Install Near Damp
Places
Dampness and droughts will
impair the efficiency of
insulation in the appliance.
Place On Firm, Leveled Floor
If the floor is uneven, adjust the
screw type supports at the
bottom of the refrigerator till
perfectly straight, as mentioned
earlier
Place The Refrigerator Close
To An Electric Plug Point
Avoid using extension cords.
Also keep the power cord rolled
up and off the floor.
Choose A Well- Ventilated
Space
Provide sufficient wall
clearance on all sides with a
minimum of 10 cm. on each
side.
10 cm
10 cm10 cm 10 cm
Caution
Keep Ventilation openings, in the
appliance enclosure clear of
obstruction.
●
● Scope : This appliance is suitable for household application only and should not be used in vehicle or aircraft or on board ships.
Appliance Is Intended To Be Used In Household And Similar Applications Such As: Staff kitchen areas m shops, offices and other working environments; ●
Farm houses and by clients in hotels, motels and other residential type environments; Bed and breakfast type environments; Catering and similar non retail applications.
● Unpack your refrigerator in the Unpack The Refrigerator :
presence of company personnel and check for transit damage before
installing the refrigerator. In case of damage, inform your dealer
immediately and don't install the unit.
● Select A Well-ventilated Location: Choose the location of your
refrigerator away from all direct heat sources. Allow sufficient
clearance (at least 10 cm) on the sides, rear and top of the
refrigerator, for effective dissipation of heat from the condenser.
● When properly leveled, the Check Refrigerator Leveling :
refrigerator door should shut gently when released from an angle of
less than 45°. To adjust leveling, rotate the adjustable screws below
the refrigerator on all four sides.
● Use a soft, damp cloth with a mild Clean The Refrigerator :
detergent to clean the refrigerator thoroughly from the inside and
the outside. Leave the doors open for a while to let it dry completely.
● Your Refrigerator Let The Refrigerator Stand For 24 Hours :
could have been tilted during transport / handling. To allow all internal
mechanisms to get back to normal, keep the refrigerator standing for
at east 24 hours before switching it ON.
● Run The Refrigerator For 2-3 Hours :
Allow the refrigerator to cool sufficiently, before loading food, by
running it with the temperature control knob at MAX setting.
● Your refrigerator Identify The Nearest Electrical Outlet :
should preferably be close to an electrical outlet so that the wire does
not lie on the floor. Connect the refrigerator to a single phase
220-240V AC, 50 Hz supply, that has been properly earthed. (Call an
electrician to check, or install one if necessary.) If you have a
separately fused circuit, use a fuse rated at 15 amps.
220~240V AC, 50 Hz supply,
