Haier HWM30-22P User manual

2 Put in the laundries
3Usage of the detergent
Direct dissolved inthe machine
1.Fill water to"Low" water level.
2.Add the power. Run for30 seconds
to dissolve itcompletely.
3.Put in thelaundries. Select suitable
water level.
The instant dissolvingof the washing
powder:
1.Prepare warm waterof 30 and a
container.
2.Add the powderwhile stirring to
fully dissolve it.
The powder ismore prone topollute
the laundries thanthe detergent.
Therefore please useit with proper
quantity.
It is suggestednot to usehigh
sudsing detergent.,so as toavoid the
bubble overflow.
Different washing powders have
different dosage. Please refer tothe
usage manual ofthe washing powder


STAT US
WASH RINSE
SPIN
POWER
ON/OFF
START
PAUSE
FUNCTION
HIGH
HEAVY
MEDIUM
LOW
倈

ѽ
⼺Ꮎ䖧᧶
ᑦߊ ᔚ≆ Ὀ⏅
⟯ᙺ
≆㶒 ⇅≆ 㙚Ⅳ
䪺໺
ᯚ֋
䰪⎿
䪺䬋
WATER
LEVEL
ⅣѼ
䖧᧶
QUICK WASH NORMAL
HWM30-22P
ス䥪





POWER
ON/OFF
FUNCTION
STAT US
WASH RINSE
SPIN
POWER
ON/OFF
START
PAUSE
FUNCTION
HIGH
HEAVY
MEDIUM
LOW
倈

ѽ
⼺Ꮎ䖧᧶
ᑦߊ ᔚ≆ Ὀ⏅
⟯ᙺ
≆㶒 ⇅≆ 㙚Ⅳ
䪺໺
ᯚ֋
䰪⎿
䪺䬋
WATER
LEVEL
ⅣѼ
䖧᧶
QUICK WASH NORMAL
HWM30-22P
ス䥪

Total time: including the normal water inlet time, draintime, excluding the power off time. The total
washing time may be influenced by the water inlet pressure and water level.
Spintime: the time from intermittent running to finishing
5 Close the top lid
Three water levelsavailableaccording tothe laundries quantity:High; Medium; Low.
After the waterinlet under setwater level, ifhigher water level i sneeded, please first
press "START/PAUSE" button, then select needed water level and press
"START/PA USE" button. The washing machine will fill water to the new water level.
When selecting "HEAVY" program, high water level are set automatically, no water level
select can be done further.
During operation of wash and rinse program, you can push down "HEAVY" button to
add water. When you release the button, or itreaches the overflow water level, the machine
will stop adding water(IItwill not add water ifhigh water level isselected).
The power willbe switched off automaticallyafterthe finishing ofthe washing
Ifyou openthe top lid, the machine willstop working exceptfor water filling.
3Press "WATERLEVEL" button
to select water level
4 Press "START/PA USE " button
6 Washing finished
Time list of each program (minute)
NORMAL
Program
HEAVY
QUICK WASH
Wash (min)
About 12~15About 56~65About 8
About 8
About 5
About 22~28 About 45~61
About 4~7 About 18~27
Rinse (min/time) Spin(min) Total time (min)
Rinse twice timeswith
stored water, about 28
Rinse twice timeswith
stored water, about 18
Rinse once withstored
water, about6
Even there'snowater inthe tub, the
spinning will startafter acertainperiod.
Do not usethe "HEAVY" program for the
woolen laundries.
Wash the laundries that are prone to lose
colors separatelyfromother laundries.
The pulsator willnot rotate unlessthe
water isfilled to selected water level.
Attention
START
PAUSE
WATER
LEVEL

7 Disposal after washing
After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may
Influence your using the machine.
Please first pull off the power plug from the receptacle before cleaning.
5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time (
about 1 hour), then close the top lid.
2.Do not store water in the washing machine for a long period. Drain the water completely after each using.
The filter screen of the water inlet valve is l
ikely to be blocked by foreign materials
and influence the water inlet.
Please clean it with brush every two months.
If the cabinet is dirty, wipe it with wet cloth
Do not flush it directly with water.
Wipe it with neutral detergent.
Do not wipe it with thinner, petrol, alcohol etc.
1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose).
4.Hang up the power cord and drain hose.
3.Be sure to pull off the power plug before maintenance.
Lint filter:
The lint filter must be used during washing.
It must be cleaned in time after each using.
Figure 1
Figure 2
Down
Dismantle
Install
The back cover of lint filter
Install
Dismantle
Down
Up
Up
The front cover of lint filter
1.Push down the spring piece of the top lint filter
to make the claws out of the filter cover, and then
pull out the lint filter to get it down. figure1
2.Pull the back of the lint filter,and then you can
get down it off the front cover of the lint filter. figure2
3.Sweep the rubbish in the lint filter.
4.Put the back of the lint filter into the front cover .
5.Put the lint filter into filter cover, and make it
tight .
6.Make sure the lint filter well installed, or it can
influence your use.

Trouble-shooting Answer to question
(Ifthere'sbreakdown, please pull off the power plug before checking) The following
phenomena are notbreakdowns sometimes. Pleaseconfirm againbeforesending itto
repair. Ifthere are real breakdowns, please cometo the special maintenance department
or after-saleservicedepartment of ourcompany. Do not repairitby yourself.
There may besome water flowing out of thedrain
hose inthefirst use of the machine.
Itisthewater remained inthe factory inspectionof
performance.
Common phenomena
Phenomena Explanation
The spinning isintermittent when itstarts.
Push the "FUNCTION"button to select "Spin", but it
doesn'twork.
Inthe final spinning, i tstops and displays"Rinse",
and starts water inlet.
Balance the laundriesto avoidslanting.
The program issetting the draintime. Some timeis
needed before itstarts spinning.
Itisbecausethat the laundries are slanting toone
side, and thesafety switch acts. After water inlet and
stirring, the slantingwill be removed and the
spinning will work.
Phenomena The reason How to settle
Inwash/rinse/spin, themachine stops
running. (The "wash" " rinse" "spin"
indicator flash quickly)The top lidisnot closed
Isthe drainhose blocked by
foreign material?
Are the laundriesput slantingly?
Are the laundriesslanting in
spinning?
Isthe machineslanting?
Isthe machineslanting?
The water faucetisnot open
The water inletvalve isblocked
The water pressureistoo low and
the current i stoo small
Isthe jointerscrew of the water
inlet hose islooseor twisted awry?
The water faucetleaks
There's abnormal sound insidethe
machine
The water filling does not work (the
indicators of "wash" "spin" flash quickly)
The draining doesnot work, or the
speed of drainingistoo slow (the
indicators of "wash" " rinse" flash)
The safety switchacts. The spinning
can not work ( the indicators of"wash"
"rinse" flash quickly)
Close the top lid
Clean the foreignmaterial. Open
and close thetop lidonce.
Re-order the laundries. C l ose the
top lid.
Level the machineinright
position. Open andclose the top
lidonce.
Open the waterfaucet. Push the
"Start/Pause" button.
Clean the water inletvalve. Push
the "Start/Pause" button.
Waitfor thenormal water
pressure before use.
Level the machineproperly.
Re-order the laundries.
Fasten the jointerscrew
properly.
The machine
does not act.
Not wash
Not spin
Nowater inlet
Is the power plug tightlyplugged?
Is the water faucet open?
Have you pushed down the power
switch and Start/Pause button?
Insert the power plug tightly.
Open the water faucet.
Push down the power switch and
Start/Pause button.
Isthere powerfailure?
Isthe powerplug loose?
Does the waterlevel arrive at the
set water level?
Use itwhenthe power on.
Insert the powerplug tightly.
Affusion to thewater level.
Isthe powerplug loose?
Isthe toplidclosed?
Are the laundriesput orderly?
Insert the powerplug tightly.
Close the toplid.
Put the laundriesorderly.

Packing list
User'smanual
Name
Bottom plate
Tappingscrews
One
One
One bag
One
Quantity
Inside the documentbag
Storage position
FullyAutomaticwashing
machine with Pump
Inside the accessorybag
Inside the accessorybag
Between the upper cushion of the washing machine
package and the upper seal of the package carton
One
water inlet hose One
Warranty card Inside the documentbag

Specification
Rated voltage frequency
Rated washing / spinning capacity
Water level/Water quantity (about)
Max water consumption
Injection pressure
Rated washing power
Rated spinning power
Weight
Dimension
3.0kg(weight ofstandard dry cloth)
High/33L, Medium/22L, Low/14L
About 90L (High water level; Standard program)
0.03Mpa-0.78Mpa
220W
200W
About 19.5kg
L447mm W 438mm H 760mm
220V~ 50Hz
ModelXQBM30-22
Rated voltage frequency
Rated washing / spinning capacity
Water level/Water quantity (about)
Max water consumption
Injection pressure
Rated washing power
Rated spinning power
Weight
Dimension
3.0kg(weight ofstandard dry cloth)
High/33L, Medium/22L, Low/14L
About 112L (High water level; Standard program)
0.03MPa-1.0MPa
220W
200W
About 19.5kg
L447mm W 438mm H 760mm
220V~ 50Hz
ModelHWM30-22P