Hakko Electronics FX-888D User manual

H K Wentworth Ltd, Ashby Park, Coaleld Way, Ashby de la Zouch, Leicestershire, LE65 1JR, T [phone] W hakko.co.uk
Packing List:
(Standard Unit)
Specications:
Model No. FX-888D
Power consumption 70W
Temperature range 50 to 480ºC
Temperature stability ±1ºC at idle temperature (When set
to 200 to 480ºC)
Output voltage AC 26V
Dimensions 100(W)×120(H)×120(D)mm
Weight 1.2kg
Power consumption 65W (26V)
Tip to ground resistance <2Ω
Tip to ground potential <2mV
Heating element Ceramic heater
Standard tip Shape-B (No.T18-B)
Cord length 1.2m
Total length 217mm (with B tip)
Weight 46g (with B tip)
FX8801 Soldering Iron
FX-888D Soldering Station
* Total length and weight (w/o cord)
Tips:
The FX8801 supplied with the FX-888D soldering station requires the T18 Series Tips which are available in a variety of shapes and sizes.
Note: A Standard tip is included with this soldering station. Alternate tips may be purchased separately.
Shape BC / C
FX-888D-17BY (UK Voltage)
FX-888D Station with British Power Cord +
Instruction Manual
FX8801 Soldering Iron with T18-B Standard
Soldering Tip
FH800 Iron Stand
A1559 Cleaning Sponge
A1561 Cleaning Wire

hakko.com - hakko.co.uk
Tips (Continued):
Shape B
Shape D
Shape I / J / K
Recommended Extras:
Available to purchase separately
B2300
Heat Proof Pad for Tip
Changes
FX8803
One-Handed
Solder Iron and
Solder Feed
FX8804
Hot SMD Tweezers
FX8805
Heavy Duty
Soldering Iron
FA-400 Desk Top
Fume Extractor
FX-889
Duel Port Soldering
Station
Solder Wire Holder
611-1 (Single)
611-2 (Double)
FG100B
Tip Thermometer
FT-710 Solder Tip
Polisher

How to Set the Temperature on a HAKKO FX-888D
1. Turn ON the power. The display will show the following:
2. Let the temperature come up to the factory default of 750°F
3. Hold the button for at least 2 seconds. The hundreds digit will start to flash
4. Press the button to select the value, then press to move to the next digit. When you
finish the last digit, the temperature is set.
Hundreds Digit
(outlined in yellow
box) will begin to
flash.
IMPORTANT: If you see the
following display, you are doing
this wrong. Start over.
(Note the two extra dots)

If you mistakenly change calibration instead of temperature…
How to Reset the HAKKO FX-888D
1. Turn OFF the power.
2. Hold the and button at the same time and turn ON the power.
3. Continue holding the buttons until the display shows ‘A’ like you see below
4. Press one time so the display shows ‘U’ like you see below
5. Press . The station is now reset to factory defaults.