Handy Home Products VALUE Series User manual

STOP!
STOP!
Call Us First!
DO NOT RETURN TO STORE.
For immediate help with assembly or product information
call our toll-free number:
or email:
[e-mail]
Our staff is ready to provide assistance.
April through October M - F 8:00 AM to 7:00 PM EST
Saturday 8:30 AM to 4:30 PM EST
November through March M - F 8:00 AM to 5:00 PM EST
1-800-221-1849
16789-ND

(This page intentionally left blank.)

1/21/2013
KEEP THIS MANUAL FOR FUTURE REFERENCE
ASSEMBLY MANUAL
ACTUAL FLOOR SIZE IS 96 x 116-5/8" (244 x 296 cm)
MONTANA 8' x 9' 8-5/8" (244 x 296 cm)
VALUE SERIES
16789-ND
BEFORE YOU BEGIN
IMPORTANT!
READ INSTRUCTIONS THOROUGHLY PRIOR TO BEGINNING ASSEMBLY.
- CUSTOMER SERVICE -
Call: 1-800-221-1849 email: [e-mail]
• BUILDING RESTRICTIONS AND APPROVAL
Be sure to check with local building department and homeowners association for specific restrictions and/ or
requirements before building
. • ENGINEERED DRAWINGS
Contact our Customer Service Team if engineered drawings are needed to pull local permits.
• SURFACE PREPARATION
To ensure proper assembly you must build your shed on a level surface. Recommended methods and materials to
level your shed are
listed on page 8 .
• CHECK ALL PARTS
Inventory all parts listed on pages 4 - 6. Contact our Customer Service Team if any parts are missing or damaged.
• ADDITIONAL MATERIALS
You will need additional materials to complete your shed. See page 3 for required and optional
materials and quantities.
A Backyard Products Company

2
FINISH
TOOLS
Safety! Always use approved safety glasses during assembly.
OptionalRequired
HELPFUL REMINDER SYMBOLS
Look for these symbols for helpful reminders throughout this manual.
ORIENT LUMBER AND TRIM FOR BEST APPEARANCE
= Assistance Required; two or more people.
= Ensure squareness.
= Important required step or operation.
= Helpful assembly hint.
= Mark part with pencil.
= Beginning of steps for assembly or installation.
= You have finished the assembly or installation.
= Level
❑ Gloves
Framing lumber is graded for structural strength and not appearance. Exterior trim is graded for one good side.
Always install the material leaving the best edge and best surface visible. Please remember that these blemishes in no
way negatively affect the strength or integrity of our product. (See Fig. A, B, C.)
A
❑ Safety Glasses
❑ Tape Measure
❑ Paint Tools
❑ Ladder
❑ Caulk Gun
❑ Hammer
❑ Level
BEGIN
❑ Pencil
❑ Phillips
Screwdriver
❑ Drill / Driver
❑ 3/8" Drill Bit
❑ #2 Philips Drive Bit
❑ #2 Square Drive Bit (Included)
❑ Tool Belt /
Nail Pouch
❑ Chalk Line
❑ Nail Gun
❑ gun nails
❑ Tin Snips
(for drip edge)
❑ Square or
❑ Utility Knife
❑ Shingle Blades
B C

3
COMPLETING YOUR SHED You will need these additional materials:
OPTIONAL MATERIALS
ADDITIONAL MATERIALS
DRIP EDGE ..................... 30 Feet #15 ROOFING FELT
To cover 145 Sq. Ft. of roof area.
1" GALVANIZED ROOFING NAILS.........1/4 Lb
For roofing felt.
REFER TO THE BACK OF THIS MANUAL AND THE MANUFACTURER’S INSTRUCTIONS
FOR INSTALLATION OF SHINGLES, DRIP EDGE AND FELT.
3-TAB SHINGLES ............................ 6 Bundles
PAINT FOR SIDING .......................... 2 Gallons
Use 100% acrylic latex exterior paint. (2) coats recommended.
CAULK ................................................. 3 Tubes
Use acrylic latex exterior caulk that is paintable.
1" GALVANIZED ROOFING NAILS.... 3 Lbs
For shingles.
PAINT FOR TRIM .............................1 Quart
Use 100% acrylic latex exterior paint.
WOOD GLUE ....................... Exterior Rated
REINFORCED WOOD FLOOR FRAME (OPTIONAL)
IMPORTANT! The included floor
has been designed for general
use. Depending on your specific
use you may want to construct a
heavy duty floor frame by adding
additional floor joists (shown
below as shaded). Below is a
list of additional materials (not
included):
x5
x20
2 x 4 x 8' (5 x 10
x 244 cm) Treated
Lumber
Cut to (5) 2 x 4 x 93"
(5 x 10 x 236,2 cm)
ea. 3" (7,6 cm) Hot
Dipped Galvanized
Nails
Optional 12"
(30,5 cm) spacing
Standard 24"
(61 cm) spacing
FOUNDATION OR FLOOR MATERIALS
• This shed kit includes a wood floor frame system. It does not include floor panels.
• This shed does not include any leveling materials.
• See the FLOOR LEVELING section on page 8 for recommended methods and suggested materials to properly level your
floor, as this will vary depending on your specific site.
FLOOR PANELS (Not included)
Floor panels are 5/8" (1,6 cm) thick.
Shown actual size
5/8 x 48 x 96"
(1,6 x 122 x 244 cm)
5/8 x 20-5/8 x 96"
(1,6 x 52,4 x 244 cm)
x2 x2
NAIL BOXES (Not included)
3" (7,6 cm)
2" (5,0 cm)
x2 BOXES
x5 BOXES