Harvil AH60-3 User manual

ASSEMBLY INSTRUCTIONS AH60-3
1
The information contained in this manual is subject to change without notice.
We work around the clock and around the globe to ensure that Harvil products
maintain the highest possible quality. However, in the rare instance that your
product is defective or missing parts, contact your retailer to submit parts
requests or warranty claims. Please read the warranty information at the back
of these assembly instructions for further details.
IMPORTANT! PLEASE READ THESE ASSEMBLY INSTRUCTIONS
IN ENTIRETY BEFORE ASSEMBLING YOUR PRODUCT.
Thank you for your purchase of this Harvil product!
AH60-3
Harvil 5 Foot
Air Hockey Table

2
PARTS IDENTIFIER(NOT TO SCALE)
WARNINGS!
READ AND FOLLOW ALL ASSEMBLY, OPERATION AND SAFETY INSTRUCTIONS CAREFULLY.
CHOKE HAZARD - THIS TABLE CONTAINS SMALL PARTS -
NOT SUITABLE FOR CHILDREN UNDER 3 YEARS OF AGE.
1. Find a clean, level surface to begin the assembly of your game table. The table will be partially assembled
upside down and then turned over onto its legs. This is a heavy game and turning it over will require at least
two strong adults.
2. Remove all of the contents from box and verify that you have all of the parts shown on the Parts
before you begin assembly. Note: Some parts may be pre-installed or pre-assembled.
3.
before beginning each assembly step.
4. When installing parts that have more than one screw or bolt, hand tighten all screws or bolts in place
5. Electric screwdrivers may be helpful during assembly; however, please set a low torque and use
extreme caution because screws may be stripped or over tightened if the electric screwdriver's torque
is set too high.
AH60-3
ADDITIONAL EQUIPMENT REQUIRED:

ASSEMBLY INSTRUCTIONS
CARE AND USE
1. This product is intended for INDOOR use only.
2. Do NOT sit, climb or lean on the table.
3. Do NOT drag the table when moving it as this will damage the legs.
4. To clean, wipe the playing surface with a damp (not wet) cloth or sponge. Wipe dry with a clean,
lint-free cloth. NEVER use chemicals, abrasive cleaners or solvents to clean the table.
5. Turn the power OFF and unplug when not in use and before cleaning the table or replacing parts.
3AH60-3
1. Attach RIGHT LEGS #2 and LEFT LEGS #3 to the corners of TABLE BODY #1 with 1-1/8”x 5/16” BOLT #6 and 3/4” x 5/16”
FLAT WASHER #7. Note: The table is assembled upside down.
2. Attach one LEG END PANEL #4 to the LEGS on each side of the table with 3/8”ROUND HEAD SCREW #8.
Note: The graphics should face outward. Thread one LEG LEVELER #9 into each LEG.
3. Attach one LEG SIDE PANEL #5 to the LEGS on each side of the table with 3/8”ROUND HEAD SCREW #8.
Carefully turn the table over.
#3
#2
#1
#4
#9
#5
#5
#8
#8
#6
#7
#3
#2

You have now assembled your Harvil Game Table. Please note the Care and Use instructions above to
ensure years of trouble free use of your game table.
ASSEMBLY INSTRUCTIONS
4AH60-3
4. To install the batteries (not included), remove the screw from the battery compartment. Remove the battery compartment
cover and install each battery in the direction indicated. Replace the battery compartment cover and screw after installation.
5. Feed the SENSOR WIRES through the hole in the side of the TABLE BODY. Plug the color-coded SENSOR WIRES into the
corresponding receptacles in the ELECTRONIC SCORER #14. Attach the ELECTRONIC SCORER to the TABLE BODY with
7/8” ROUND HEAD SCREW #15.
6. To assemble the STRIKERS, remove the paper backing from the adhesive on STRIKER FELT #11. Adhere one STRIKER FELT to
the bottom of each STRIKER #10.
#14
#11
#10
#15
#14
#14

TROUBLESHOOTING
AH60-3 5
In the situation of the electronic scorer not functioning, please check the following to make sure:
•The Table is plugged in.
•The batteries are operational.
•The batteries are placed in the right positions.
If the electronic scorer is still not functioning, it might be due to the issues below.
Defective Console: The electronic scorer doesn’t display numbers.
Defective Wires: The electronic scorer displays numbers, but doesn’t register points when scoring.
Under either circumstance or if you run into any other problem, please don’t hesitate to reach out
to us at [email protected]om or [phone]. We will send you a replacement scoring unit
as soon as possible. For instructions of the electronic scoring wire assembly,
please go to http://tinyurl.com/AH60-2ESAssembly.

6
90 DAY LIMITED WARRANTY
90-DAY LIMITED WARRANTY
AH60-3
This Harvil product is warranted to the original purchaser to be free from defects in material or
workmanship for a period of 90 days from the date of the original retail purchase.
This warranty does not cover defects or damage due to improper installation, alteration, accident or
any other event beyond the control of the manufacturer. Defects or damage resulting from
misuse , abuse or negligence will void this warranty. This warranty does not cover scratching or
damage that may result from normal usage.
This product is not intended for institutional or commercial use; Harvil does not assume any liability
for such use. Institutional or commercial use will void this warranty.
This warranty is nontransferable and is expressly limited to the repair or replacement of the
defective product. During the warranty period, Harvil shall repair or replace defective parts at no
cost to the purchaser. Shipping charges and insurance are not covered and are the responsibility of
the purchaser. Labor charges and related expenses for removal, installation or replacement of the
product or components are not covered under this warranty.
Harvil reserves the right to make substitutions to warranty claims if parts are unavailable or obsolete.
Harvil shall not be liable for loss of use of the product or other consequential or incidental costs,
expenses or damages incurred by the consumer of any other use. The user assumes all risk of injury
resulting from the use of this product.
This warranty is expressly in lieu of all other warranties, expressed or implied, including warranties of
any of its representatives assumes any other liability in connection with this product.
All warranty claims must be made through the retailer where the product was originally
purchased. A purchase receipt or other proof of date of purchase will be required to
process all warranty claims. The model number and part numbers found within the
assembly instructions will be required when submitting any parts requests or warranty
claims.
For further warranty information or inquiries, please call 877-800-2299