Hathaway NG5018 User manual

NG5018
Ver. 0418
METROPOLIS 48-IN FOOSBALL TABLE
with TELESCOPIC SAFETY RODS
ASSEMBLY INSTRUCTIONS
Please Do Not Hesitate to
Contact Our Consumer Hotline
at 800-759-0977
with Any Questions That May
Arise During Assembly or
Use of This Product!

2
THANK YOU!
Thank you for purchasing this product. We work around the clock and around the globe to ensure
that our products maintain the highest possible quality. However, in the rare case of issues during
assembly or use of this product, please contact our Consumer Hotline at 800-759-0977for immediate
assistance before contacting your retailer. Please read the warranty information at the back of these
assembly instructions for further details.
CARE AND USE
1. This product is intended for INDOORuse only.
2. Do NOT drag the table when moving it, as this will damage the legs.
ASSEMBLY TIPS
1. Find a clean, level surface to begin the assembly of your game table. We recommend that two adults
work together to assemble this game. You may want to carefully cut or tear the four corners of the box
so that the bottom of the box can be used as your work surface.
2. Remove all of the contents from box and verify that you have all of the parts shown on the Parts
List before you begin assembly. Note: Some parts may be pre-installed or pre-assembled.
3. Some figures or drawings may not look exactly like product.
4. When installing parts that have more than one screw orbolt, hand tighten all screws orbolts
in place before final tightening with screwdriver orwrench.
5. Electric screwdrivers may be helpful during assembly; however, please set a low torque and use
extreme caution because screws may be stripped or overtightened, resulting in damaged parts, if the
electric screwdriver’s torque is set too high.
WARNINGS!
READ AND FOLLOW ALL ASSEMBLY, OPERATION AND SAFETY INSTRUCTIONS CAREFULLY.
CHOKE HAZARD - THIS ITEM MAYCONTAIN SMALL BALLS AND PARTS
NOT SUITABLE FOR CHILDREN UNDER 3 YEARS OF AGE.
IMPORTANT! PLEASE READ THESE ASSEMBLY INSTRUCTIONS
IN ENTIRETY BEFORE ASSEMBLING YOUR PRODUCT.

3
METROPOLIS 48-IN FOOSBALL TABLE - NG5018
Parts List
PARTS
HARDWARE PACK - NGP7238
H1 H2 H3 H4 H5 T1
P1 NGP7229 P2 NGP7230 P3 NGP7231 P4 NGP7232 P5 NGP7233 P6
SIDE PANEL END PANEL
P7 NGP7235
P8 NGP7223 P9 NGP5513 P10 NGP55131 P11 NGP7236 P12 NGP7224 P13 NGP7237 P14 NGP5102
P15 NGP7222 P16 NGP7221
ROD WASHER
P17 NGP7220
1/2” PLASTIC ROD
BOLT A
1/2” PLASTIC ROD
NUT
ADDITIONAL EQUIPMENT
REQUIRED:
PHILLIPS HEAD
SCREWDRIVER
LEFT LEGPLAYFIELD
4/18 For replacement parts please call 800-759-0977.
Illustrations Not to Scale
X2
X2 X1X2 X8
X2
X4
X4
X32 X4 X4 X8 X1
X32
P18 NG7225 P19 NGP7226
X8
X8 X8
ROD BUMPER SLIDE SCORER
X2
LEG LEVELER
X8
SOCCER BALL
X8
4-PLAYER ROD3-PLAYER ROD
ROD HANDLE
X2
RIGHT LEG
5/16” WASHER 3.5x1-3/4” SCREW
5/16”x1-1/2” BOLT
P10
P11
P16
P1
P2
P7
P12
P8
P13
P18,P19,P20
P5
P20 NGP7227
X2
P15
P15
P17
SUPPORT BRACE
CROSS BAR
X2
3.5x1-1/4” SCREW
ALLEN WRENCH
P17
P16
P16
P4
P6
P3
X2
1/2” PLASTIC ROD
BOLT B
X2
NGP7234
PLAYER ROD
INSERT
X8
1-PLAYER ROD
P16
P9
H5
1/4”x22mm WASHER

4
ASSEMBLY INSTRUCTIONS
H2
P2
H2 H1
P2
H1
P3
P1
P1
Step 1
Step 2

5
Step 3
Step 4
ASSEMBLY INSTRUCTIONS (CONT.)
P6
H3
P4
H2
P13
H1
P5
H1
P11
H2
P4
P5

Step 5
Step 6
6
ASSEMBLY INSTRUCTIONS (CONT.)
H4
P17
P16
P16
H5
P18
P15
P9
P12
P17
P16
P7
HOME VISITOR
*NOTE: You may choose either color for home or visitor teams.
All players on your team will face opponent’s goal
and all handles will be on same side of table.
P15 P16 P17P16 P17 P16 P15P16
P15
P16
P19 P20P1P8
Installing Rods*
1. Place Rod Washer (P10) over end of handle side of Player Rod (P15, P16, P17), then insert rod end into appropriate
Side Panel (P1) hole (all same color team handles will be on same side of table) in order show on diagram below.
2. Insert Rod Insert (P8) into opposite end of rod while placing Washer (H5) and Rod Bumper (P9) onto insert as shown.
3. Attach end of Rod Insert (P8) to Side Panel (P1) by placing two pieces of Rod Bolt (P18, P19) together over end of
Rod Insert (P8) and inserting through side panel hole and securing with Rod Nut (P20) by screwing onto Rod Bolt clockwise.
P1
P8
P10

7
180-DAY LIMITED WARRANTY
This product is warranted to the original purchaser to be free from defects in material or workmanship
for a period of 180 days from the date of the original retail purchase.
This warranty does not cover defects or damage due to improper installation, alteration, accident or
any other event beyond the control of the manufacturer. Defects or damage resulting from misuse,
abuse or negligence will void this warranty. This warranty does not cover scratching or damage that
may result from normal usage.
This product is not intended for institutional or commercial use; the manufacturer does not assume
any liability for such use. Institutional or commercial use will void this warranty.
This warranty is nontransferable and is expressly limited to the repair or replacement of the defective
product. During the warranty period, the manufacturer shall repair or replace defective parts at no
cost tothe purchaser. Shipping charges and insurance are not covered and are the responsibility of
the purchaser. Labor charges and related expenses for removal, installation or replacement of the
product or components are not covered under this warranty.
The manufacturer reserves the right to make substitutions to warranty claims if parts are unavailable
or obsolete.
The manufacturer shall not be liable for loss of use of the product or other consequential or incidental
costs, expenses or damages incurred by the consumer of any other use. The user assumes all risk of
injury resulting from the use of this product.
This warranty is expressly in lieu of all other warranties, expressed or implied, including warranties of
. Neither the manufac-
turer nor any of its representatives assumes any other liability in connection with this product.
All warranty claims must be made through the retailer where the product was originally
purchased. A purchase receipt or other proof of date of purchase will be required to process
all warranty claims. The model number and part numbers found within the assembly
instructions will be required when submitting any parts requests or warranty claims.
For further warranty information or inquiries, please call 800-759-0977

NG5018
Ver. 0418
TABLE DE SOCCER METROPOLIS 1,22 m
AVEC TIGES DE SÉCURITÉ TELESCOPIQUES
INSTRUCTIONS D’ASSEMBLAGE
Contactez notre
service à la clientèle au
800-759-0977
avec des questions sur le montage
ou l'utilisation de ce produit.

2
MERCI!
Merci d’avoir acheté notre produit. Nous travaillons 24 heures sur 24, partout dans le monde, à garantir
que nos produits sont de la meilleure qualité possible. Toutefois, dans les rares cas de problèmes lors
du montage ou de l'utilisation de ce produit, se il vous plaît communiquer avec notre service à la clientèle
au 800-759-0977 pour une aide immédiate avant de contacter votre revendeur. Pour obtenir de plus amples
renseignements, veuillez lire l'information relative à la garantie au verso de ce guide d’instructions.
ENTRETIEN ET USAGE
1. Ce produit doit être utilisé À L’INTÉRIEUR seulement.
2. NE JAMAIS déplacer la table en la traînant, cela pourrait endommager les pieds.
INSTRUCTIONS D’ASSEMBLAGE
1. Trouver une surface propre et plane, pour commencer le montage de votre table de jeu. La table
s’assemble à l’envers pour être ensuite retournée sur ses pieds, une fois l’assemblage complété.
Cette table est lourde et nécessite au moins deux adultes forts pour la soulever et la retourner.
2. Retirez le contenu de la boîte, avant de commencer l’assemblage, assurez-vous d’avoir toutes
les pièces telles que listées et illustrées au tableau d’identification. Avis : certaines pièces sont
préassemblées ou préinstallées.
3. Certaines illustrations ou dessins peuvent ne pas ressembler au produit que vous avez acheté.
4. Quand vous fixez en place une pièce avec plus d’une vis ou écrou, veuillez, en premier, les
visser à la main et terminer la fixation avec un tournevis ou une clé.
5. Un tournevis électrique peut être utile lors de l’assemblage, mais veuillez le régler à basse torque
et l’utiliser avec prudence; si la torque est trop élevée, la vis peut se défaire ou être trop serrée.
AVERTISSEMENTS!
LIRE TOUTES LES INSTRUCTIONS D’ASSEMBLAGE ET LES CONSIGNES DE SÉCURITÉ ATTENTIVEMENT.
RISQUE D’ÉTOUFFEMENT – CERTAINS ÉLÉMENTS DU PRODUIT CONTIENNENT
DE PETITES PIÈCES - NE CONVIENT PAS À UN ENFANT DE MOINS DE TROIS ANS.
IMPORTANT! VEUILLEZ LIRE, EN ENTIER, TOUTES LES
INSTRUCTIONS AVANT D’ASSEMBLER VOTRE PRODUIT.

3
TABLE DE SOCCER METROPOLIS 1,22 m - NG5018
Liste des pièces
H1 H2 H3 H4 H5 T1
P1 NGP7229 P2 NGP7230 P3 NGP7231 P4 NGP7232 P5 NGP7233 P6
panneau latéral panneau d’extrémité
P7 NGP7235
P8 NGP7223 P9 NGP5513 P10 NGP55131 P11 NGP7236 P12 NGP7224 P13 NGP7237 P14 NGP5102
P15 NGP7222 P16 NGP7221
rondelle de tige
P17 NGP7220
boulon de tige en
plastique A 1,27cm
ecrou de tige en
plastique 1,27cm
pied gauchesurface de jeu
4/18
X2
X2 X1X2 X8
X2
X4
X4
X32 X4 X4 X8 X1
X32
P18 NG7225 P19 NGP7226
X8
X8 X8
butoir de tige marqueur manuel
X2
patin de
nivellement
X8
balle de soccer
X8
tige 4 joueurstige 3 joueurs
poignée de tige
X2
pied droit
P10
P11
P16
P1
P2
P7
P12
P8
P13
P18,P19,P20
P5
P20 NGP7227
X2
P15
P15
P17
barre transversale
X2
clé Allen
P17
P16
P16
P4
P6
P3
X2
boulon de tige en
plastique B 1,27cm
X2
NGP7234
insert de tige joueurs
X8
tige 1 joueurs
P16
P9
H5
Pour commander une pièce de remplacement, veuillez téléphoner au 1 800 759-0977
illustrations non à l'échelle
PIÈCES
Le sac de quincaillerie NGP7238 comprend
traverse surface
de jeu
ÉQUIPEMENT
ADDITIONNEL REQUIS:
TOURNEVIS
CRUCIFORME
rondelle
(8,47mm x 17mm)
boulon
(8,47mm x 3,81cm)
vis
(3,5mm x 3,18cm)
rondelle
(6,35mm x 22mm)
vis
(3,5mm x 4,45cm)