HealthCo HeathZenith 5407 User manual

Replacement
Motion Sensor
Requirements
• Thelightcontrolrequires120-voltsAC.
• IfyouwanttouseManualMode,thecontrolmust
bewiredthroughaswitch.
• Somecodesrequireinstallationbyaqualified
electrician.
©2013HeathCoLLC 206443-01A
Features
• Turnsonlightingwhenmotionisdetected.
• Automaticallyturnslightingoff.
• Photocellkeepsthelightingoffduringdaylight
hours.
• LED indicates motion was sensed (day or
night).
Model5407
OPERATION
*resetstoAutoModeatdawn.
Note:Whenrstturnedonwaitabout11/2minutes
forthecircuitrytocalibrate.
ON-TIME
10 5 1TEST
1051TEST
ON-TIME
...backon.
1Second
OFFthen...
PuttheON-TIMEswitchinthe1,
5,or10minuteposition.
PuttheON-TIMEswitchonthe
bottomofthesensorintheTEST
position.
Manualmodeonlyworksatnight
becausedaylightreturnsthesen-
sortoAUTO.
Flipthelight switchofffor one
secondthenbackontotoggle
between AUTO and MANUAL
MODE.
Manualmodeworksonlywiththe
ON-TIMEswitchinthe1,5,or10
position.
Move ON-TIME Switch to
1, 5, or 10 minutes
Mode Switching Summary
Flip light switch
off for one second
then back on*
MANUAL MODE
AUTO
TEST
* Ifyougetconfusedwhileswitchingmodes,turn
thepoweroffforoneminute,thenbackon.After
thecalibrationtimethecontrolwillbeintheAUTO
mode.
TEST
AUTO
MANUAL MODE
Mode: On-Time Works: Day Night
Test 5Seconds x x
Auto 1,5,or10Minutes x
Manual ToDawn* x

-2- 206443-01
1. Swingthesensorheadtowardstheclamp
screw.
Foreavemountonly:
Controls
INSTALLATION
1. Removetheexistinglightxture,ifpresent.
2. Afterscrewingthesensorintothewallplate,
connectthejunctionboxwirestothelightcontrol
wiresbytwistingtogetherandsecuringwithwire
connectors.
Theseinstructionsshowthesensorwiredtoood
lamps.Thewhite sensorwireisneutral.Theblack
sensor wire is hot.Theredwireistheswitched
“hot”wire.Thelighting load(500W,4.2Amax)is
placedacrossthewhiteandred wires.
Mount the Light
1. Followtheinstructionsthatcamewithyourlight
xtureformountingandadjustingthelightx-
ture.
2. KeepregularPAR-38lampsatleast1"(25mm)
fromthesensor.Halogenlampsshouldbekept
atleast2"(51mm)fromthesensor.
BlacktoBlack
WhitetoWhite
RedSensorWireto
BlackLampWire
Optional: Connect additional load
acrossthewhiteandredwires.Total
lightingloadincludinglampheadson
xturemustnotexceed500W(4.2A).
Junction
Box
Lamp
Holders
For under eave installation, the sensor head
must be rotatedasshowninthenexttwosteps
forproperoperationandtoavoidtheriskofelec-
tricalshock.
2. Rotatethesensorheadclockwise180°so
thecontrolsfacedown.
ClampScrew
Controls
Controls
Ifthesensorpopsoutoftheballjoint,loosenthe
clampscrewandpushthesensorbackintothe
balljoint.Tightentheclampscrewwhendone.
WARNING: Turn power off at the fuse or
circuit breaker.
Wire the Light Control

-3-
206443-01
Motion
Least Sensitive Most Sensitive
Sensor
Motion
Thesensorislesssensitivetomotiondirectlyto-
wardsit,mostsensitivetomotionacrossitseld
ofview.
Maximum Range Maximum
Coverage Angle
8ft.
(2.4m)
70ft.(21m)
TEST AND ADJUSTMENT
1. Turn on the circuit breaker and light switch.
NOTE: Sensor has a 1 1/2 minute calibration
periodbeforeitwilldetectmotion.When
rstturnedon,wait11/2minutes.
2. TurntheRANGEcontroltothemidpositionand
theON-TIMEcontroltotheTESTposition.
1051TEST
ON-TIME
Bottom of Sensor
Avoid aiming the control at:
•Objectsthatchangetemperaturerapidly,such
asheating vents and air conditioners.These
heatsourcescouldcausefalsetriggering.
•Areas where pets or traffic may trigger the
control.
•Nearby large, light-colored objectsreecting
lightmaytriggertheshut-offfeature.Donotpoint
otherlightsatthesensor.
180°
3. Loosen the clamp screw
inthesensorballjointand
gentlyrotatethesensor.
4. Walk through the cover-
age area noting where
you are when the lights
turnon(also,theLEDwill
ash several times when
motionisdetected).Move
thesensorheadup,down,
orsidewaystochangethe
coveragearea.Keep the
sensoratleast1"(2.5 cm)
away from the lamps.
5. Adjust the RANGE as
needed. RANGE set too
high may increase false
triggering.
6. Secure the sensor head
by tightening the clamp screw.Donotover-
tightenthescrew.
7. SettheamountofTIMEyouwantthelightstostay
onaftermotionisdetected(1,5,or10minutes).
WARNING:Riskoffire.Donotaimthelamps
at a combustible surface within 3 ft. (1 m).
SPECIFICATIONS
Range.............. Upto70ft.(21m)[varieswith
surroundingtemperature].
SensingAngle........Upto180°
ElectricalLoad........ Upto500Watt(4.2A)Maximum
Incandescent[Upto250Watt
maximumeachlampholder.]
PowerRequirements... 120VAC,60Hz
OperatingModes...... TEST, AUTO and MANUAL
MODE
TimeDelay ..........1,5,10minutes
Range.............. Adjustable
HeathCoLLCreservestherighttodiscontinueprod-
uctsandtochangespecicationsatanytimewithout
incurringanyobligationtoincorporatenewfeaturesin
productspreviouslysold.
RANGE
MIN MAX
Clamp
Screw
Ball
Joint
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage

-4- 206443-01
TROUBLESHOOTING GUIDE
SYMPTOM
Lights will not
come on.
Lights come on
in daylight.
Lights come on
for no apparent
reason.
POSSIBLE CAUSE
1. Lightswitchisturnedoff.
2. Lightislooseorburnedout.
3. Fuseisblownorcircuitbreakeristurned
off.
4. Daylight turn-off is in effect (recheck
after dark).
5. Incorrectcircuitwiring,ifthisisanew
installation.
6. Re-aimthesensortocoverdesiredarea.
1. Lightcontrolmaybeinstalledinarela-
tivelydarklocation.
2. LightcontrolisinTest.(Set control switch
to an ON-TIME position).
1. Light control may be sensing small
animals or automobile trafc (re-aim
sensor).
2. Rangeissettoohigh.(Reduce Range).
SYMPTOM
Lights stay on
continuously.
Lights flash on
and off.
POSSIBLE CAUSE
1. Alampispositionedtooclosetothesensor
orpointedatnearbyobjectsthatcauseheat
totriggerthesensor.(Reposition the lamp
away from the sensor or nearby objects).
2. Light control is pointed toward a heat
source like an air vent, dryer vent, or
brightly-painted heat-reective surface.
(Reposition sensor).
3. LightcontrolisinManualMode.(Switch
to Auto.)
1. Heatorlightfromthelampsmaybeturning
thelightcontrolonandoff.(Reposition the
lamps away from the sensor).
2. Heatbeingreectedfromotherobjectsmaybe
affectingthesensor.(Reposition sensor).
3. Light control is in the Test mode and
warming up. (Flashing is normal under
these conditions).
4. Lightcontrolisdetectingalightsource.
(Reposition Light control or lamp).
TWO YEAR LIMITED WARRANTY
Thisisa“LimitedWarranty”whichgivesyouspeciclegalrights.Youmayalsohaveotherrightswhichvaryfromstatetostateor
provincetoprovince.
Foraperiodoftwoyearsfromthedateofpurchase,anymalfunctioncausedbyfactorydefectivepartsorworkmanshipwillbe
correctedatnochargetoyou.
Not Covered -Repairservice,adjustmentandcalibrationduetomisuse,abuseornegligence,lightbulbs,batteries,andotherex-
pendableitemsarenotcoveredbythiswarranty.Unauthorizedserviceormodicationoftheproductorofanyfurnishedcomponent
willvoidthiswarrantyinitsentirety.Thiswarrantydoesnotincludereimbursementforinconvenience,installation,setuptime,loss
ofuse,unauthorizedservice,orreturnshippingcharges.
ThiswarrantycoversonlyHeathCoLLCassembledproductsandisnotextendedtootherequipmentandcomponentsthatacus-
tomerusesinconjunctionwithourproducts.
THISWARRANTYISEXPRESSLYINLIEUOFALLOTHERWARRANTIES,EXPRESSORIMPLIED,INCLUDINGANYWARRANTY,
REPRESENTATIONORCONDITIONOFMERCHANTABILITYORTHATTHEPRODUCTSAREFITFORANYPARTICULARPUR-
POSEORUSE,ANDSPECIFICALLYINLIEUOFALLSPECIAL,INDIRECT,INCIDENTAL,ORCONSEQUENTIALDAMAGES.
REPAIRORREPLACEMENTSHALLBETHESOLEREMEDYOFTHECUSTOMERANDTHERESHALLBENOLIABILITYON
THEPARTOFHEATHCOLLCFORANYSPECIAL,INDIRECT,INCIDENTAL,ORCONSEQUENTIALDAMAGES,INCLUDING
BUTNOTLIMITEDTOANYLOSSOFBUSINESSORPROFITS,WHETHERORNOTFORESEEABLE.Somestatesorprovinces
donotallowtheexclusionorlimitationofincidentalorconsequentialdamages,sotheabovelimitationorexclusionmaynotapply
toyou.Please keep your dated sales receipt, it is required for all warranty requests.
TECHNICAL SERVICE
Please call 1-800-858-8501 (English speaking only) for assistance before returning product to store.
Ifyouexperienceaproblem,followthisguide.YoumayalsowanttovisitourWebsiteat:www.hzsupport.com.
Iftheproblempersists,call*forassistanceat1-800-858-8501(Englishspeakingonly),8:00AMto5:00PMCST
(M-F).Youmayalsowrite*to:
HeathCoLLC,P.O.Box90045,BowlingGreen,KY42102-9045,ATTN:TechnicalService
*IfcontactingTechnicalService,pleasehavethefollowinginformationavailable:ModelNumber,DateofPurchase,
andPlaceofPurchase.
No Service Parts Available for this Product