HECKLER H587-ADA User manual
H587 - ADA Camera Mount
for Logitech BRIO
2
IN THE BOX
ADA Camera Mount
1 x
Wall Achor
1 x
Hex Key, 5/32”
1 x
Mounting Screw
1 x
3
TOOLS NEEDED
COMPONENTS NEEDED
(Not Included)
1/2” Spade
Drill Bit
Tape Measure Power Drill
Pen
If you have any questions, please contact
service@hecklerdesign.com.
Phillips
head Bit
BRIO USB-C CableLogitech BRIO
STEP 1
Locate mounting position
4
Important Notes:
Locate and mark the ideal location for your ADA Camera
Mount. It could be mounted underneath, above or beside
the display.
5
STEP 2
Install the wall anchor
6
Important:
Drill a 1/2-inch hole for the cable to
pass through the wall.
Optional
Mark and drill the hole
1 3/8”
1/2” hole
7
Optional
Route the USB-C cable through the wall
8
STEP 3
Fasten the ADA Camera Mount
Connect the USB-C cable to Logitech
BRIO Camera
1.
Fasten the camera to the ADA Camera
Mount with the hex key.
2.
Install the Logitech BRIO
9
STEP 4
Loosen the screw with the hex hey to adjust
camera orientation, and then tighten it.
10
STEP 5
Adjust and set camera orientation.
Table of contents
Other HECKLER Camera Accessories manuals
