HECKLER H876 User manual

H876 - Whiteboard Mount
for Logitech Scribe
Designed & made in Arizona
Patented

If you have any questions, please contact Heckler.
[email protected]om
844-432-5930
Important Safety Notice:
When mounting to mobile whiteboards, be
cautious when rolling through doorways. In many
cases, you'll want to remove this mount from your
whiteboard to avoid potential damage to Logitech
Scribe, the whiteboard, and the doorway.
This Mount is compatible with conventional and
glass whiteboards varying in thickness from 5mm
to 25mm.
1

IN THE BOX
Whiteboard mount
Phillips Screwdriver
1 x
Stay-in-place tab
1 x
Pan Head Screw, M4 x 0.7mm, 8mm Long
4 x
Washer
2 x
TOOL NEEDED
2
AD
BC

STEP 1
3
x4
Fasten the Scribe Camera Mounting Bracket to the Mount using the
included screws and washers. Do not overtighten.
The Camera Mounting Bracket is included with your Logitech Scribe.
x2

STEP 2
4
Route the CAT5e cable between the
front and rear surfaces of the mount as
shown. Connect the CAT5e cable to the
Logitech Scribe Camera. Hang and
connect the Scribe Camera to its
Camera Mounting Bracket.
The CAT5e cable is included with your
Logitech Scribe.

5

STEP 3
Fasten the stay-in-place tab as shown.
6
Tip: The use of the stay-in-place tab
is optional, but recommended when
the Scribe Camera is mounted to
mobile whiteboards.

STEP 4
Measure the width of your whiteboard and mark the center point of the
board with a dry-erase marker. Position the mount so the mount's
centering notch is aligned to the center line on your whiteboard.
Important: Continue to support the weight of the mount and camera
until the clamp is firmly engaged.
7