Helioscreen HMX SKYE User manual

www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 1
INSTALLATION GUIDE
Helioscreen Australia Pty Ltd – Dealers Australia Wide
www.helioscreen.com.au | [e-mail] | Phone [phone]
HMX SKYE • Under Glass Blind System

Movement / Alignment Correction Measure Horizontal / Vertical
Caution Visual check Exterior Interior
Before starting the installation, check whether the type and number of brackets match the order and whether the installation surface (substrate)
matches the surface given in the order. In the event of significant differences, which make safe and secure fixing of the awning questionable,
consult the system manufacturer and a fixing technology specialist.
1.1 INSTALLATION PREPARATION
Transport the awning to the place of installation in the correct position.
Secure the installation area; at least the area equivalent to the extended awning.
When pulling up the awning into higher installation positions by means of ropes the awning is to be removed from the packaging.
The pull ropes are to be attached so that the awning is securely fastened, but is not damaged. The awning may only be raised in the
horizontal position and uniformly.
Failure to comply can result in the awning falling off and therefore can cause injuries!
1. GENERAL SAFETY INFORMATION
This Helioscreen system has been designed and manufactured in conformity with DIN EN 13561. However, when the awning is
mounted or operated, the persons involved in the respective activity may be put at risk if the relevant instructions are not observed.
Only qualified and duly specialised companies or trained specialist personnel may be permitted to mount the awning.
Always observe the information and notes in the Mounting and Operation Instructions.
A failure to observe the relevant information will render the manufacturer’s liability null and void.
Electrical installation work and connections to the mains must be carried out exclusively by a licensed electrical company.
If significant differences make the safe installation of the awning seem doubtful, please consult the manufacturer of the system and a
mounting/installation specialist. The safety-at-work and accident prevention regulations specific to each country must be complied with. In
particular, a person performing special work at height must be suitably secured.
The notes on the product and its packaging must be observed.
1.2 MEANING OF THE SYMBOLS
www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 2

< 2000 mm 2001 - 3500 mm > 3501 mm
46
80








21.521.5










 





B
2. INSTALLATION
2.1 TOOLS
2.2 MOUNTING OPTIONS
8
(Note: Installation with clip brackets will require additional brackets directly below the headbox when the
system is vertical to prevent any movement)
2.2.1 MOUNTING WITH CLIP BRACKETS
B
A = (B + 43mm)
www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 3











 





 













 
















 





 





80
Angle brackets 60 x 40mm Reveal angle brackets 60 x 40mm
Angle brackets 40 x 40mm
21.521.5 B
2.2.3 MOUNTING WITH STAND OFF DISTANCE BRACKETS
A = (B + 43mm)
21.521.5 B
Bracket detail
2.2.2 MOUNTING WITH ANGLE BRACKETS
www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 4

80
1 2
Required on both Left and right
3 4
6
5
2.3 INSTALLATION WITH CLIP BRACKETS
Required on both Left and right REMOVE THE SECURE CLIPS!
Left and right
Required on both Left and right
www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 5

CLICK CLICK
7
max.5Nm!
8
8
80
1 2
2.3 INSTALLATION WITH CLIP BRACKETS
2.4 INSTALLATION WITH STAND OFF BRACKETS
Installation
must be
parallel and
square
Required on both left and right
www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 6

3 4
6
5
87
2.4 INSTALLATION WITH STAND OFF BRACKETS
Required on both left and right Required on both left and right
Required on both left and right
Required on both left and right
REMOVE THE SECURE CLIPS!
Left and right
www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 7

910
11
Installation
must be
parallel and
square
2.4 INSTALLATION WITH STAND OFF BRACKETS
www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 8

15-20
MIN
≥37-48 km/h
NEW
1
2
3
4
3. TROUBLESHOOTING
3.1 Motor not responding
www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 9

1 mm
>1 mm
END
STOP!
END
STOP!
END
STOP!
1A
3.2 System does not extend or retract fully
3.3 System not travelling fully up or down
Tuning tape
www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 10

x4
x3
1
2
3
2
3
x4
x4
1
2
3
1
3.3 System not travelling fully up or down
3.4 Awning sags unevenly
www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 11

KNRRR
2
WD-40
3.4 Awning sags unevenly
3.5 When operated, system moves by jerks and jolts or generates indefinable noises
www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 12

www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 13

www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 14

www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 15

www.helioscreen.com.au | Phone [phone] INSTALLATION GUIDE | 16