rollease acmeda CU40 User manual

CU40 & CU41 Panel Glide
INSTALLATION MANUAL

INSTALLATION
CU40 & CU41 PANEL GLIDE SYSTEM
CU40 PANEL GLIDE
CU41 PANEL GLIDE
DISCLAIMER
INTRODUCTION
This installation manual for CU40 & CU41 Panel Glide has been produced by Rollease Acmeda to supply the necessary information for the safe
and correct installation of CU40 & CU41 Panel Glide.
DISCLAIMER
Rollease Acmeda has used reasonable care in preparing the information included in this document, but makes no representations or warranties
as to the completeness or accuracy of the information. Information is supplied upon the condition that the persons receiving the information
will make their own determination as to its suitability for their purposes prior to use. Rollease Acmeda assumes no liability whatsoever for any
damages incurred by you resulting from errors in or omissions from the information included herein. Rollease Acmeda reserves the right to make
changes without further notice to any products to improve reliability, function or design.
COPYRIGHT
COPYRIGHT © ROLLEASE ACMEDA
All rights are reserved. No part of this document may be reproduced or utilised in any means, by any means, electronic or mechanical including
photocopying, recordings, or by any information storage or retrieval system, without the express permission from Rollease Acmeda.

STEP 2 - INSTALL CU40 OR CU41 PANEL GLIDE SYSTEM INTO BRACKETS AS
SHOWN BELOW.
STEP 3 - ATTACH FABRIC TO PANEL BARS.
Insert the fabric as detailed below using a 9mm Flat Spline attached to the Fabric and slide along
Panel Bar. Once the Fabric has been inserted into position replace the end cap and fasten end cap
screw.
D30 Front Face
The Panel Bar & Bottomrail both use 9mm at
spline to attach fabric.
The D30 Bottomrail uses 15mm at spline to
attach fabric.
D30 Bottomrail (Optional)
27mm 29mm
RB91-1232-xxxLLL
Panel Bar Front Face
CU40 & CU41 Panel Glide Assembly Manual | v3.1 | February 2022
2022 © Copyright All Rights Reserved Rollease Acmeda
Page. 3
INSTALLATION
STEP 1 - SECURE TOP FIX BRACKETS EVERY 1000 - 1200MM
1,000mm - 1,200mm
BACK
BACK
FRONTFRONT

rolleaseacmeda.com