
6/6
English ( USA )
Safety
- The product must be installed in accordance with applicable
NEC standards by a qualified electrician familiar with the
installation of exterior lighting fixtures.
- The product must be operated under specified voltage at all
times.
- Do not install if parts are damaged.
- Power must be disconnected while installing or servicing to
avoid electrical shock.
- Failing to comply with warnings and installation steps in this
document might void warranty.
- Do not touch the light source.
- Make sure that temperature of the product is at a safe level before
touching.
- Do not allow cables to touch sharp edges of metal parts or other sharp
objects to avoid damage or abrasion.
- Check all of the cable connections including grounding before
powering the product.
- Check the proper grounding of the metal housing before powering the
product.
- Only use the product for its intended purposes.
- Do not use accessories not approved or recommended by
HEPER.
- Replace any broken/cracked protective surface with a new
one
Installation
- Make the cable connection as shown on the visual.
- Secure the luminaire to its place, as shown in the visual.
- To adjust and bring the product to the required angle, bolt should be
loosened and re-tightened.
- Base angle adjustment can be made by loosening and tightening the
bolts close to the mounting table. The product can be brought to the
desired angle in accordance with the image.
Replacement of the light source
- Disconnect the power coming into the product.
- Unscrew the bolts from front cover as shown in the visual, to reach to
the light source.
- Carefully disconnect the supply power socket from the cover.
- Carefully disconnect the wire connectors between the driver and LED
light module.
- Reinstall the product following the same steps.
Replacement of the control gear
- Disconnect the power coming into the product.
- Unscrew the bolts from front cover as shown in the visual, to reach to
the driver. Note: The cover is secured to the body with a safety latch.
- Carefully disconnect the supply power socket from the cover.
- Carefully disconnect the wire connectors between the driver and LED
light module.
- Detach the driver and place the new one.
- Reinstall the product following the same steps.
Cleaning - Maintenance
- The product was designed and manufactured to operate for a long
period of time. To ensure maximum lifespan of the product, regular (i.e.
every six months) visual inspection and cleaning with a solvent-free
cleaner using a soft cloth is recommended.
- Do not clean or service while the product is power connected.
Disposal
- In accordance with EU Directive WEEE (Waste Electrical and
Electronic Equipment), luminaires must not be disposed of with
other household waste. At the end of their life, luminaires must
be taken to the appropriate local facility available for the
disposal or recycling of electronic products.
Wiring Color Codes
- Ground - GREEN
- Line - BLACK
- Neutral - WHITE
- Dim(+) - RED/PURPLE
- Dim (-) - GRAY/ORANGE
Disclaimer
- HEPER reserve the right to make technical and design changes.